Solve the following problems Find the properties of moist air for the following using psychrometric chart: (7) W.B.T. = 30 °C ,0= 80 % (8) W.B.T. = 30 °C ,D.P.T. = 22 °C (9) h = 60 KJ/Kg D.B.T. = 50 °C (10) Ø = 10 % ,h= 50 KJ/Kg

Solve the following problems Find the properties of moist air for the following using psychrometric chart: (7) W.B.T. = 30 °C ,0= 80 % (8) W.B.T. = 30 °C ,D.P.T. = 22 °C (9) h = 60 KJ/Kg D.B.T. = 50 °C (10) Ø = 10 % ,h= 50 KJ/Kg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Prove your answer by using a steam table 1. Find the specific volume, enthalpy, and internal energy…

A: Note Answer may a little vary due to different values are given in different tables .

Q: Air (R-0.287 kJ/kg.K, c=1.005 kJ/kg.K) is contained in a piston cylinder device, it expands first…

Q: The Assmann psychrometer’s dry thermometer shows 22оС, wet thermometer - 14оС. The atmospheric…

Q: Outside air at 30 C drybulb & 25 C wetbulb temperature flowing at a rate of 25,000 liters/min is…

Q: 1. Given steam condition: 70 C, saturated liquid, find: A.S B. v C. h D. U E. quality F. moisture 2.…

A: (1) Given: Steam condition is saturated liquid at 70 C. Calculation: Consider the steam tables at 70…

Q: A continuous flow calorimeter was used to obtain the calorific value of a sample of fuel and the…

A: The calorific value of fuel is amount of heat generated by a fuel due to its complete combustion of…

Q: A Cl engine, during suction stroke, draws Air only Mixture of diesel and air A mixture of oil and…

A: Basics of Thermodynamics are used.

Q: 20. Find the humidity ratio of an air that has tab = 27 °C and twb = 20 °C with a relative humidity…

A: Given:tdb=27°Ctwb=20°CPB=100 KPa

Q: steam at 25o c and 4Bar is throttled to -> 0l bar. The final Enthaply a it the dryiess fradtion of…

A: Given Data State 1:250°C, 4 bar. State 2:0.1 bar P=0.2 bar, quality=91%

Q: The frame supports the distributed load shown. Determine the state of stress acting at point E.…

Q: For the following mixture of gasses calculate the mixture's compresibility and real volume. Ni Mi…

Q: Entering air have a humidity of 0.05 kg/kg with 94% saturation is cooled and separated out the…

Q: HELP ME ASAP PLS Consider: Relative Humidity at 1500m, in % Round to one (1) decimal place 6.…

A: The height into the atmosphere = 1500 mThe total pressure = 101 kPaThe air temperature = 25°CThe dew…

Q: Calculates direct evaporative cooling or saturation efficacy from E= T1- T2/ T2 - T Where T1 is dry…

Q: In an air-conditioning unit 3.5 m3/s air at 27°C dry-bulb temperature, 21°C wet-bulb temperature,…

Q: The air temperature measurement results obtained by the dry ball temperature 37 ° C and the wet bulb…

A: Dry bulb temperature of air, =37oC Wet bulb temperature of air, =27.5oC

Q: A gas mixture consists of 1 kg of N2 and 1.5kg of He. Determine: Mass fractions (m) of: 1. N2: 2.…

A: Given Mass of N2= 1kgMass of He= 1.5 kg

Q: Initially contains Air: P1 = 30 lbf/in^2 T1 = 540 °F V1 = 4 ft^3 Second phase of process involving…

A: Given data:-air piston cylinder with work and heat interaction system To be explained:- potential…

Q: Last Oct. 3rd, the temperature in Quezon City was 81°F, the barometric pressure was 29.8 in, and the…

Q: Improve the expression Determine the value of the expression for H2O at 20 °C using the following…

Q: At a climate station, air pressure is measured as 101.1 kPa. The air temperature was 22 0C and dew…

A: Given Data The air pressure is: Pa=101.1 kPa The air temperature is: Ta=22°C The dew point…

Q: Air (R=0.287 kJ/kg.K, c-1.005 kJ/kg.K) is contained in a piston cylinder device, it expands first…

A: Given: v1=0.2 m3/kgv2=0.53 m3/kgv3=0.74 m3/kgPmax=600 kpaTmin=673 K

Q: A furnace heating unit has an airflow of 2,500 CFM. The heating coil entering temperature is 35°F…

Q: Q6. Moist air at dry -bulb temperature 30 and moisture content Kg/Kg dry air a- During sensible…

A: Given: The dry-bulb temperature, Tdb = 30 C The humidity ratio = 0.0102 kg/kg The temperature rise…

Q: 2. For superheated water, given a pressure P-0.2 MPa, calculate the internal energy (1) and enthalpy…

A: GIVEN- TABLE A-6 DETERMINE- INTERNEL ENERGY AND ENTHALPY AT 560…

Q: 4. (a) If w is humidity ration, o is relative humidity, Pw is partial pressure of water vapor in the…

Q: Determine the quality x of water if P = 0.04 bar and v = 3.48 m^3/kg Select one: Oa. 0.75 Ob. 0.35 O…

A: Step 1:you can ask me what you want to know about this chart Step 2:relative humidity is the amount…

Q: Isobutane gas and liquid mixture (x=0.9) at stage 1 is running through a valve to get 100% vapor…

Q: 2. Steam enters an adiabatic turbine at 5MPa, 650°C, and 80 m/s and leaves at 50kPa, 150°C, and 140…

A: Given data: Inlet pressure, P1 = 5 MPa Inlet temperature, T1 = 650°C Inlet velocity, V1 = 80 m/s…

Q: The beam is supported at A and B as shown in (Figure 1). Suppose that F = 4 kip and w = 250 lb/ft.…

A: To Find : The normal force at point D The shear force at point D Give : The free body diagram is,

Q: Last Oct. 4th, the temperature in Quezon City was 77°F, the barometric pressure was 29.8 in, and the…

A: As per the guidelines, I can solve only first three questions at time. So, repost the other parts in…

Q: What temperature does the first solid form for a 20% wt% Sn-80% Pb. T(°C) 300+ 200+ 100 Answer: 0 α…

A: The phase transformation diagram of Pb-Sn system consists of two solid phase (alpha and beta) and…

Question

Solve the following problems
Find the properties of moist air for the following using psychrometric
chart:
(7) W.B.T. = 30 C , Ø= 80 %
(8) W.B.T. = 30 "C , D.P.T. = 22 °C
(9) h = 60 KJ/Kg
D.B.T. = 50 °C
%3D
(10) Ø = 10 %
,h = 50 KJ/Kg

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3) The temperature of the vehicle cabin is 72F and Ø = 50%. pR (i) the partial pressure of the air and water vapor (ii) the vapor density, and (iii) the 29.92 in. Hg Find humidity ratio of the mixture. Ans. (i) 14.496 psi , 0.1941 psi, (ii) 0.000613 Ib/ft3, (iii) 0.00833
In an environment, the temperature suddenly increased from 100°C to 200°C. In order for a thermoelement in the environment to show 199.4°C in 8 seconds, how many seconds must the time constant of the thermoelement be? a. 1.919 b. 1.609 c. 1.630 d. 1.563 e. 1.955
9:23 日 52% LIU Hadi Moustafa H 1 ft 4 ft 2 ft A 4 ft. II
Handwritten solution required this is a basic thermodynamics question
Outside air at 30 C drybulb & 25 C wetbulb temperature flowing at a rate of 25,000 liters/min is mix with colder air at 20 C drybulb & 18 C wetbulb temperature flowing at a rate 70,000 liters/min. After mixing , the mxture undergoes sensible heating up to 40 C . Compute the heating needed in kW. Plot the process on the Psychrometric chart and label it completely. Can you upload the chart also?
Psychrometric process A room has dimensions of approximately 10m x 10m x 3m. Assume the air inside the room to be at T= 20 oC, P = 100 kPa, Relative Humidity = 50% a. If all of the water vapor in the air of the room could be converted to liquid at the same temperature, what is the volume of the liquid (mL)? b. If the room temperature were slowly cooled without changing the composition of air, at what temperature would you expect to see condensation occurring (oC)?
What is the enthalpy of steam at 155 deg C? Find the specific enthalpy of superheated steam at 2 atm and 900°C.
Thermodynamic
please slove 2nd and 3d soon
Don't solve wrong this is important for me. Try to solve in minimum time