Solve the following problems with complete solutions and units using 2 decimal digits: The tungsten filament in the incandescent lamp has a resistance of 9.8 Ω at a room temperature of 20°C and a resistance of 132 Ω at normal operating temperature. Calculate the temperature of the heated filament.?

Solve the following problems with complete solutions and units using 2 decimal digits: The tungsten filament in the incandescent lamp has a resistance of 9.8 Ω at a room temperature of 20°C and a resistance of 132 Ω at normal operating temperature. Calculate the temperature of the heated filament.?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Current And Direct Current Circuits

Section: Chapter Questions

Problem 70P

See similar textbooks

Similar questions

A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the weight if the wire was made of copper? (b) What is the weight of a 10.00-meter-long wire of the same gauge made of aluminum? (c)What is the resistance of the aluminum wire? The density of copper is 8960 kg/m3 and the density of aluminum is 2760 kg/m3.
A child's electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of 0.0200 inseries with a 1.53-V carbon-zinc dry cell having a 0.100- internal resistance. The load resistance is 10.0 . (a) Draw a circuit diagram of the toy and itsbatteries, (b) What current flows? (c) How much power is supplied to the load? (d) What is the internal resistance of the dry cell if it goes bad, resulting in only 0.500 W being supplied to the load?
What is the current in the element of an electric clothes dryer with a resistance of 7.4 Ω when it is connected to 240 V? Express your answer to two significant figures and include the appropriate units. I= How much charge passes through the element in 50 min? (Assume direct current.) Express your answer to two significant figures and include the appropriate units. Q=
An electrician wishes to cut a copper wire (ρ=1.724 X10−8Ωm) that has no more than 10Ω of resistance. The wire has a radius of 0.725mm. 1. The area of cross section of the wire is Answer ? 2. Approximately what length of wire has a resistance equal to the maximum 10Ω ?
What is the resistance of a wire with a length of 43.4 m and a radius of 2.8 mm, made from a metal with resistivity 6.0 x 10-8 ohm*m? Three significant figures.
A 3.0 length of copper wire (ρ = 1. 78 x 10−8Ωm) at 20oC has a cross section area of 4mm2. What is the electric resistance of this wire?
A 12-volt battery of internal resistance r of 0.05 ohm is to be recharged by a 50-volt dcsource at the rate of 8 amperes.a. What resistance R is to be connected in series with the circuit? ANSWER:_________b. What is the terminal voltage of the battery? ANSWER:_________c. How much energy in joules is dissipated in the resistor in one hour ?ANSWER:_________
A high voltage transmission line of diameter 2.55 cm and length 3.42167 km carries a steady current of 2 x103 A. If the conductor is copper with a free charge density of 7 x 1028 electrons/m3, how long (in seconds ) does it take one electron to travel the full length of the cable? (e = 1.6 x 10−19 C).For this problem use scientific/exponential notation to represent your answer.
A conductor has radius of 1.50 cm. How many centimeters of a material with 3.00 x 10^-2 Ω•m conductivity would be needed to yield a resistance of 4.50 ohms? A. 10.60827521 centimeters B. 10.60287521 centimeters C. 10.06287521 centimeters D. 10.62087521 centimeters
What is the current in a wire in which 3.62x1020 electrons pass a single point every 8.79 seconds? Report your answer with three significant digits. (e = 1.602x10-19 C)
A 100 W light bulb designed to operate at 120 V has a filament with a resistance of 144 Ω. What constraints are on the design of the filament? Why cannot just any 144 Ω resistance be used as a filament for the bulb?