Solve the surface temperature using the parameters: h steam = 17.6319 W/m2 K h air = 25 W/m2 K T steam = 120 deg C T air = 3

Q: Q1. Find the heat flow rate through the composite wall as shown in Fig. below. Assume one…

A: Given: The Thermal conductivity of layer A, KA = 152 W/moC The Thermal conductivity of layer B, KB =…

Q: 1. If the thermal conductivity increase the heat transfer coefficient wi

A: Note:-  As per our company guidelines we are supposed to answer only one question. Kindly repost…

Q: 1. A beverage cooler is in the shape of a cube, 42 cm on each inside edge. Its 3.0-cm thick wall are…

A:

Q: 1.20 m wide is mounted on the vertical wall of an open rectangular tank filled with oil. The top of…

A:

Q: Problem 3 An air-cooled condenser is to reject 70 kW of refrigerant to air. The condenser has an…

A:

Q: An air-cooled IC engine can be approximated as a cube of size 0.2 m x 0.2 m x 0.2 m and made of cast…

A: Given,cube six-0.2m×0.2m×0.2marea of one side A=0.2m×0.2m=0.04m2fin thickness t=0.01mfin length…

Q: The next 8 questions are all related to the following problem statement and figure. Air at 27°C with…

A: Given that ,  T∞=27°C=300KU∞=10m/sqcurve=40mWA=5mm×5mmL=15mm=0.015m

Q: Air stream (k = 0.02439 W/m.K, v = 1.426 ×10° m2/s, Pr = 0.7336) flows over a flat surface [L= 4.5…

A:

Q: Air flows through a 10- inside diameter tube, at an average temperature condition of 300'F. The…

A:

Q: Required information Water at 20°C is flowing with velocity of 0.89 m/s between two parallel flat…

A:

Q: If the average connective heat transfer coefficient on the outer surfaçe of a tube (inner diameter =…

A:

Q: hose the correct answer for each branch below. a) Two walls of same thickness and cross section area…

A: As per bartleby guidelines we are allowed to solve only 1st  3 subparts if multiple subparts are…

Q: (a) If the insulation is 27.5 mm thick and its inner and outer surfaces are maintained at Ts,1=800 K…

A:

Q: A vertical cooling fin approximates a flat plate 800 mm in height is.exposed to saturated steam at…

A: Given: A vertical cooling fin approximates a flat plate of x=800 mm. The temperature of saturated…

Q: A fluid flowing through a tube 20ft long and of 0.62 inch inside diameter has the following has the…

A:

Q: The correlation below is used to calculate the heat transfer coefficients for forced convection…

A: Following is the answer for the question.

Q: QUESTION-) 236 °C steam flows in a pipe which features are given below. Inner and outer diameters…

A: a) Outer surface area (A0)= π×do×L= 502.65m2 Inner surface area (Ai)=π×di×L=471.2388m2 Internal…

Q: Residual oil, with a heating value of 18,480 BTU/lbm, is used as a fuel in a power plant which…

A:

Q: Homework # 3 Q1: A pharmacy with dimensions (L= 10 m, W= 10 m, H= 3 m) are to be air- conditioned…

A: To find: The cooling load in TR from the east wall, east window, door, roof, device. Given: The…

Q: Q1. Find the heat flow rate through the composite wall as shown in Fig. bele Assume one dimensional…

A: Given Data KA=152 W/m°C KB=31W/m°C KC=68 W/m°C KD=53 W/m°C Now  LA=3 cm=0.03 mLB=LC=8 cm=0.08…

Q: Part A If the temperature of the room is 20°C and outside is 10°C, find the rate of heat flow for a…

A:

Q: Hot water (specific heat of 4.18 Kj/kgK) at 66C is flowing through a metal pipe (6 m long, 2 cm ID,…

A:

Q: 18.13 In the curing of rubber tires, the “vulcanization" process requires that a tire carcass,…

A:

Q: 236 °C steam flows in a pipe which features are given below. Inner and outer diameters of pipe are…

A: First of considering uninsulated pipe.

Q: Hot water (cp=D4.18 kJ/kg.K, m = mm, Length = 93 cm, thickness = 1.0 mm, k, outer surface is 204…

A: Specific heat of water, CP=4.18 KJ/kg.KMass flow rate of water,m˙=2.8kg/minInner diameter of tube,…

Q: Task 01 An industrial freezer is designed to operate with an internal air temperature of -20 0C…

A:

Q: B) Consider a binary mixture of magnetite ( specific gravity 5.17) and galena (specific gravity 7.5)…

A: Concept Of Stock's Law Used

Q: 1- For the following design conditions:- Condenser heat load (Qc) = 293 MW Condenser Pressure…

A:

Q: f thickness 30 cm and thermal conductivity 0.69 W/m-°C re maintained at temperatures of 20°C and…

A: Given Data⇒ Dimensions of brick(a,b)=5m×6m Thickness(t)=30 cm=0.3 m Temperature : T1=50CT2=200C…

Q: 7. Determine the heat loss through a ventilated attic under the following conditions: indoor…

A:

Q: Q1: A pharmacy with dimensions (L= 10 m, W= 10 m, H= 3 m) are to be air- conditioned with 24 °C DBT…

A: GIVEN DATA  dimension (L=10m,B=10m,H=3m) are to be air conditioned with 24C

Q: Question 5 Heat transfer A domestic refrigerator with inner dimensions of 0.7 m by 0.7 m at the base…

A:

Q: EXAMPLE 2.3 A= 10 m? =1000 Wim k=D40 Winrk p= 1600 kgn 4 kiigK The temperature distribution across a…

A:

Q: 30°C, 10m/s 2m Electronic components inside D=20cm Figure 5 You are designing components of an…

A: Given data: Maximum temperature of Surface = Ts= 60oC Fluid Stream temperature = To =  30oC Fluid…

Q: An exterior wall's insulation is made up of the following materials: 2" cork (K = 0.025; concrete (K…

A: Given:Thickness of cork, L1=2"=212ft=0.1667ftThermal conductivity of cork, K1=0.025…

Q: A scientist suggests the following correlation be used for square tubes in a liquid cross- flow…

A: Nu=h*lc/K From the above equation, Nu=0.102*Re^0.675 *Pr^1/3 h*lc/K=0.102*10000^0.675 *(6^1/3)…

Q: A heated plate, 20 by 20 cm, is inclined at an angle of 60°with the horizontal and placed in water.…

A: The reference temperature is The thermal conductivity of water at  is The product of the Grashof…

Q: QUESTION-) 236 °C steam flows in a pipe which features are given below. Inner and outer diameters…

A: tempertaure of steam in the pipe, Ts=236oc=236+273=509Kinner diameter of the pipe,…

Q: You are designing a 3m x 3m floor with radiant heating.  The floor has 12 parallel pex pipes (k = 40…

A: Designing a 3m x 3m floor with radiant heating. 12 parallel pex pipes (k = 40 W/mK) L = 3m, OD =…

Q: Conductive heat flow through flat surface  Conductive heat flow throw composite wall

A: To give: Example of conductive heat flow through flat surface Example of conductive heat flow…

Q: The thermal boundary layer in heat transfer exists whenever there is a difference between the…

A: A thermal boundary layer must form if the bulk temperature and the surface temperature differ,…

Q: Metalic cylinder 10 mm in diameter maintained at 50 flow over the cylinder for which the air…

A: Heat transfer Heat transfer is the process of movement of heat from higher temperature to lower…

Q: (1) A copper wire 0.8 mm diameter at 150°C is suddenly dipped into water at 35°C. If h=85.5 W/m²K,…

A:

Q: A pipe line used to transport oil from one area in Dubai to Kuwait carrying a temperature of 30℃ of…

A: