Dimensional Analysis is a way of doing numerical "book-keeping"when converting quantities or performing calculations.• When converting quantities from one unit to another,conversion factors are used.Solving with Dimensional Analysis and Multiple Units:If I am in Canada where the price of gas is $1.022 USD·L1, howmuch will it cost me to fill up my gas tank if I travelled 125 km?• Let's also assume that my car getsan average of 30.0 miles/gallon.

Answered: Image /qna-images/answer/d1ebc584-f407-4da5-9e80-6827cf567a2f.jpg

Solving with Dimensional Analysis and Multiple Units: If I am in Canada where the price of gas is $1.022 USD·L1, how much will it cost me to fill up my gas tank if I travelled 125 km? Let's also assume that my car gets an average of 30.0 miles/gallon.

Solving with Dimensional Analysis and Multiple Units: If I am in Canada where the price of gas is $1.022 USD·L1, how much will it cost me to fill up my gas tank if I travelled 125 km? Let's also assume that my car gets an average of 30.0 miles/gallon.

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 114CP: As part of a science project, you study traffic patterns in your city at an intersection in the...

See similar textbooks

Related questions

Q: What is the product of the CNO cycle? What do you think it is called CNO cycle?

A: CNO cycle It is known as the carbon, nitrogen and oxygen cycle.

Q: concentration of the solution. (c) the mass in grams of NiCl2 contained in each liter O. A 12.5% (w/...

A: As per our guideline, only one to be solved, if multiple questions are posted. Hence, question no. 9...

Q: An equilibrium constant describes the ratio of products over reactants in a particular situation. In...

A: A question based on equilibrium concept that is to be accomplished.

Q: Refering to the figure below, Which of the three circled areas corresponds to the region with the fa...

Q: What is the pK* in the average human blood serum which contains 18 mg of K+ per 100 mL?

Q: QUESTION 5 Ethyl alcohol, C2H5OH, is a water-soluble nonelectrolyte. A solution is prepared by addin...

Q: Given that an aqueous solution of ethylene glycol in water has a vapor pressure lowering of 16.0 mba...

Q: How would the pH of the skin where the Ceramide synthesis de novo is most likely to take place affe...

A: Ceramide synthesis have much importance with pH of the skin.

Q: Which type of isomerism exists between the pair of monosaccharides below? Diastereomers Non-i...

Q: ОН HỌ O но HO- ОН

Q: Please answe the following question: 1. What are two most common alkalis used in soap making? 2. W...

A: Soap is nothing but sodium or patssium salts of long chain fatty acid. For example: C17H35COO- Na+ ...

Q: Determine which classes of reactions would fit into each of the following categories for the reactan...

A: We are to categorize each reaction with its description given in the table, based on number of compo...

Q: HO NH2 Name the numbered functional groups in the structure O 1. carboxyl 2. amido 1. carboxyl 2. am...

Q: Formic acid, HCO2H, is the irritant that causes the body’s reaction to ant stings. What is the conce...

Q: rogen, compound amount Fe,03 4.85 g H2 2.01 g Fe 3.53 g 1.33 g Calculate the value of the equilibriu...

Q: Which one of the equations below represents what happens when NH3 is dissolved in water? O NH3 +H,O ...

Q: 2.21. Under the influence of oxidizing agents, hypophosphorous acid is trans- formed into phosphorou...

A: For reaction., H3PO2 ----------> H3PO3 (oxidising agent) We have to explain the observed kine...

Q: Which of the following C5H8 compounds best fits the spectrum. The integration values are shown above...

A: By correlating chemical shift values and splitting of proton NMR signal with the individual proton a...

Q: What is the molecular formula of the structure shown? O C13H26 O C13H28 O C13H27 C13H29

A: Requirement from question: MF: C13H28

Q: How much energy is released when a 50g sample of gaseous ethanol is cooled from 78.4 degrees celsius...

Q: 6. Water has a specific heat of 4.184 J/g°C while glass (Pyrex) has a specific heat of 0.780 J/g°C. ...

A: Specific heat is the amount of heat energy required to raise the temperature of a body per unit of m...

Q: 2) Ninety thousand grams of a gas (180 kg/mol) is stored in a tank at 120 kPa and 600 K. If the gas ...

A: Given that, The mass of the gas is m = 90000 g = 90 kg. The molar mass of the gas is M = 180 kg/mol...

Q: A solution is made by mixing 50. g of acetone (CН), СО) and 25. g of methanol (CH,он). Calculate the...

A: Given :- Amount of acetone = 50. g Amount of methanol = 25. g To be calculated :- Mole fraction ...

Q: If I have a 7M HCl solution, how many mL are needed from the stock solution to prepare 54 mL of a 2M...

Q: Using the data in the table, determine the rate constant of the reaction and select the appropriate ...

A: The sum of the exponent term in the rate law for a chemical reaction is known as the order of the re...

Q: Answer the below questions and show steps: a. You have a 50X stock of buffer and you need 150 µl of...

Q: The rate constant k for a certain reaction is measured at two different temperatures: temperature k ...

A: Here we are given.,

Q: CH3 CH;-CH,-C-CH,-CH2 CH2 ČH3 CH; What is the systematic name of the structure shown? O 3-ethyl-1,2-...

A: We have to write the Correct IUPAC NAME FOR THE GIVEN COMPOUND.

Q: Which of the compounds below will form hydrogen bonds between two of the same molecules? CH3CH2...

A: Hydrogen bonding: The hydrogen atom attached with the electronegative atom like fluorine, oxygen, or...

Q: What is the molcecular formula and systematic name of the given structure? C19H21, 2-ethyl-2,3,3-tri...

Q: Give the name of the structure shown O 1,2-dichlorobenzene o-dichlorobenzene O both names are correc...

A: Nomenclature of substituted benzene: 1) naming is done by placing the substituent as a prefix to the...

Q: A calorimeter has a heat capacity of 35.45 J/C. When 100.0 mL of a strong acid at 23.1°C is mixed wi...

A: Given Specific heat of calorimeter 35.45J/°C Specific heat of solution = 4.10J/g°C Initial temper...

Q: From its position in the periodic table, determine which atom in each pair is more electronegative. ...

Q: What would be the rate law for the mechanism below? Step 1 NO(g) + Cl2(g) ↔ NOCl2(g) slow Step 2 ...

A: The given equations are : Step 1 NO(g) + Cl2(g) ↔ NOCl2 (g) slow Step 2 NOCl...

Q: Determine the multiplicity of each signal in the expected 'H NMR spectrum of the following compound....

A: NMR spectroscopy is branch of chemistry which involves identification of compound on the basis of NM...

Q: Carl, a laboratory analyst for a mining company determined that copper is 3.21% of the ore that he i...

A: The percent of copper in the ore is 3.21%.

Q: C2H5OH combustion releases 1200 kJ/mol. How many giving off of C2H5OH is to be burned to generate 62...

Q: While looking over some of her lab data, a chemistry student notices she forgot to record the number...

Q: 1. If the limiting reactant was found to be K2C2O4⋅H2O, how many grams of the limiting reactant are ...

A: Mass of salt mixture = 2.64 g Mass...

Q: When the following equation is balanced using the smallest possible integers, what is the exponent o...

A: Qc is the ratio of product of concentration of products raised to their stoichiometric coefficient ...

Q: The rate at which a certain drug is eliminated by the body follows first-order kinetics, with a half...

Q: A chemistry student weighs out 0.0827 g of phosphoric acid (H,PO,), a triprotic acid, into a 250. mL...

Q: C5H10O4 I need help answering 2 3 4 5 For IHD please show step by step ir analysis: absorption ba...

Q: Refer to the attached slide on "Identifying Oxidizing and Reducing Agents" 1. For each of the follow...

A: We have been asked to find the oxidation state of each element of reactants and products along with ...

Q: The graph below shows two titration curves: 40.0 mL of two different acids are titrated with 0.100 M...

A: Answer :- pH at half equivalence point of acid A = 4.25 ------------------------------------------...

Q: (Phs) P -CH

A: It is wittig reaction. Please note: if the negative charge is stabilised on carbon by a electron wi...

Q: Select which of the following substances would require the least amount of energy to increase 20.0 g...

A: The amount of heat required to increases the temperature of the 1 g of the substance by 1 degree is ...

Q: A chemist makes 530. mL of copper(II) fluoride (CuF,) working solution by adding distilled water to ...

Q: Provide the most stable (lowest energy) chair conformation of cyclohexan-1-ol Drawing

A: Given Molecule is cyclohexan-1-ol Cyclohexan-1-ol is more stable in chair form.

Q: A chemist prepares a solution of mercury(I) chloride (Hg,Cl,) by measuring out 0.347 mg of mercury(I...

A: Molarity is a concentration term for a solution. The molarity of a given solution is defined as the ...

Concept explainers

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.

Question

Dimensional Analysis is a way of doing numerical "book-keeping"
when converting quantities or performing calculations.
• When converting quantities from one unit to another,
conversion factors are used.
Solving with Dimensional Analysis and Multiple Units:
If I am in Canada where the price of gas is $1.022 USD·L1, how
much will it cost me to fill up my gas tank if I travelled 125 km?
• Let's also assume that my car gets
an average of 30.0 miles/gallon.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1– dimensional analysis

VIEW

Step 2– conversion of quantities

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between (a) mass and density? (b) an extensive and an intensive property? (c) a solvent and a solution?
Suppose a room is 18 m long, 15 m wide, and the distance from floor to ceiling is 2.9 m. What is the room’s volume in cubic meters? In cubic centimeters? In liters?
A 124-g sample of a pure liquid, liquid A, with a density of 3.00 g/mL is mixed with a 40.8-mL sample of a pure liquid, liquid B, with a density of 2.00 g/mL. What is the total volume of the mixture? (Assume there is no reaction upon the mixing of A and B, and volumes are additive.)
A solution is prepared by dissolving table salt, sodium chloride, in water at room temperature. a Assuming there is no significant change in the volume of water during the preparation of the solution, how would the density of the solution compare to that of pure water? b If you were to boil the solution for several minutes and then allow it to cool to room temperature, how would the density of the solution compare to the density in part a? c If you took the solution prepared in part a and added more water, how would this affect the density of the solution?
1.87 A solution of ethanol in water has a volume of 54.2 mL and a mass of 49.6 g. what information would you need to look up and how would you determine the percentage of ethanol in this solution?
1-86 The specific heats of some elements at 25oC are as follows: aluminum = 0.215 cal/g · oC; carbon (graphite) = 0.170 caI/g oC; iron = 0.107 cal/g mercury = 0.033 1 caI/g oC. (a) Which element would require the smallest amount of heat to raise the temperature of 100 g of the element by 10oC? (b) If the same amount of heat needed to raise the temperature of 1 g of aluminum by 25oC were applied to 1 g of mercury, by how many degrees would its temperature be raised? (c) If a certain amount of heat is used to raise the temperature of 1.6 g of iron by 10oC, the temperature of 1 g of which element would also be raised by 10oC, using the same amount of heat?
Although the preferred SI unit of area is the square meter, land is often measured in the metric system in hectares (ha). One hectare is equal to 10,000 m2. In the English system, land is often measured in acres (1 acre = 160 rod2). Use the exact conversions and those given in Exercise 47 to calculate the following. a. 1 ha = __________ km2 b. The area of a 5.5-acre plot of land in hectares, square meters, and square kilometers c. A lot with dimensions 120 ft by 75 ft is to be sold for 6500. What is the price per acre? What is the price per hectare?
As part of a science project, you study traffic patterns in your city at an intersection in the middle of downtown. You set up a device that counts the ears passing through this intersection for a 24-hr period during a weekday. The graph of hourly traffic looks like this. a. At what time(s) does the highest number of cars pass through die intersection? b. At what time(s) does the lowest number of cars pass through die intersection? c. Briefly describe the trend in numbers of cars over the course of die day. d. Provide a hypothesis explaining the trend in numbers of cars over the course of the day. e. Provide a possible experiment that could test your hypothesis.
Particles in the illustration below undergo a chemical change. Which among the remaining boxes, a through d, can represent the products of the chemical change? If a box cannot represent the products of the chemical change, explain why. a b c d