Some N₂ gas is mixed with some O₂ gas, and the sketch below shows a representative sample of the mixture. The total pressure of the mixture is measured, and found to be 1500. torr. key carbon hydrogen nitrogen sulfur oxygen chlorine Calculate the mole fraction and partial pressure of each gas in this mixture. Round your answers to 4 significant digits. You may assume each gas behaves as an ideal gas. Explanation Check Ⓒ2022 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center

Some N₂ gas is mixed with some O₂ gas, and the sketch below shows a representative sample of the mixture. The total pressure of the mixture is measured, and found to be 1500. torr. key carbon hydrogen nitrogen sulfur oxygen chlorine Calculate the mole fraction and partial pressure of each gas in this mixture. Round your answers to 4 significant digits. You may assume each gas behaves as an ideal gas. Explanation Check Ⓒ2022 McGraw Hill LLC. All Rights Reserved. Terms of Use | Privacy Center

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter8: Gases

Section: Chapter Questions

Problem 97E: Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g)...

See similar textbooks

Similar questions

Calculate the molar volume of ethane at 1.00 atm and 0C and at 10.0 atm and 0C, using the van der Waals equation. The van der Waals constants are given in Table 5.7. To simplify, note that the term n2a/V2 is small compared with P. Hence, it may be approximated with negligible error by substituting nRT/P from the ideal gas law for V in this term. Then the van der Waals equation can be solved for the volume. Compare the results with the values predicted by the ideal gas law.
5-54 Automobile air bags are inflated by nitrogen gas. When a significant collision occurs, an electronic sensor triggers the decomposition of sodium azide to form nitrogen gas and sodium metal. The nitrogen gas then inflates nylon bags, which protect the driver and front-seat passenger from impact with the dashboard and windshield. What volume of nitrogen gas measured at 1 atm and 27°C is formed by the decomposition of 100. g of sodium azide?
A 1.000-g sample of an unknown gas at 0C gives the following data: P(atm) V (L) 0.2500 3.1908 0.5000 1.5928 0.7500 1.0601 1.0000 0.7930 Use these data to calculate the value of the molar mass at each of the given pressures from the ideal gas law (we will call this the apparent molar mass at this pressure). Plot the apparent molar masses against pressure and extrapolate to find the molar mass at zero pressure. Because the ideal gas law is most accurate at low pressures, this extrapolation will give an accurate value for the molar mass. What is the accurate molar mass?
61 As one step in its purification, nickel metal reacts with carbon monoxide to form a compound called nickel tetracarbonyl, Ni(CO)4, which is a gas at temperature above about 316 K. A 2.000-L flask is filled with CO gas to a pressure of 748 torr at 350.0 K, and then 5.00 g of Ni is added. If the reaction describe occurs and goes to completion at constant temperature, what will the final pressure in the falsk be?
A gas effuses 1.55 times faster than propane (C3H8) at the same temperature and pressure. (a) Is the gas heavier or lighter than propane? (b) What is the molar mass of the gas?
Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g) If 3.0 atm of pure HN3(g) is decomposed initially, what is the final total pressure in the reaction container? What are the partial pressures of nitrogen and hydrogen gas? Assume the volume and temperature of the reaction container are constant.
A 275-mL sample of CO gas is collected over water at 31C and 755 mmHg. If the temperature of the gas collection apparatus rises to 39C, what is the new volume of the sample? Assume that the barometric pressure does not change.