Answered: State True or false a- The DC load flow…

State True or false a- The DC load flow study is a linear analysis b- In a load frequency control, a generator unit equipped with a governor can be assumed to be a controlled unit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.15MCQ

See similar textbooks

Related questions

Q: . Discuss about the excitation system of Synchronous generator.

Q: Q.6: A (500 MW) synchronous generator is delivering (100 Mw) to infinite bus through the unit…

Q: Application of load flow in power market?

A: There are various applications of load flow. Some of them are mentioned below, It is used to…

Q: In power flow studies,if a network consists of a generator bus which elements of Jacobian Matrix…

A: The generator bus is also called PV or voltage controlled bus. The quantities specified for such…

Q: Q4/ /A/ A 3-phase, Shp, 208V, 4-pole, 60H IMbjected to no load test at 60HZ and short circuit at…

Q: The single line diagram of figure below shows a generator connected through parallel transmission…

A: when a 3 phase fault occurs at any of the middles of one of the transmission line then the…

Q: Discuss system demand and generator loading

A: System demand System demand management (SDM), also called as management control (DSM) or…

Q: A 60-Hz synchronous generator having inertia constant H9.94 MJMVA and a transient reactance X0.3 per…

Q: 2 Define the term open circuit (no load) and short circuit of a synchronous generator in general.

A: Open circuit of a synchronous generator : When the load on a synchronous generator is open circuit…

Q: In the system shown below, the generator is ideal (Xs = 0) and the magnitude of the load bus…

Q: Why load characteristics goes lower with respect to the occ

Q: a) Two thermal generator units have the following incremental cost curves then determine the…

A: The incremental cost functions are given as F1=0.22+0.16 P1F2=0.48+0.41 P2and Unit 1:…

Q: Q3: A synchronous generator with peak generated voltage Vg which is connected to a lighting arrester…

A: Equivalent per phase diagram Apply KVL in loop 1)

Q: Is desirable to have leading power factor loads? Why? Please explain.

A: The phase difference between current and voltage in an electrical circuit is defined by the power…

Q: 6. Explain following with examples and diagrams. a. Load curve b. Plant capacity factor c. Mean time…

Q: The one-line diagram of a simple power system is shown in Figure below. The neutral of each…

A: In this question we need to find a 3 phase fault at bus 3 .

Q: Choose which answers are correct Which of the following is a way to find the order in which…

A: The way by which the generator generation and capacity are scheduled based upon economic load…

Q: Q#5. Illustrate the variation of output power taken from the wind turbine? How the frequency in wind…

A: In the case of the Wind turbine generated power will vary with the wind flow. So the power will…

Q: Induction motors and power factor correction capacitor banks are examples of nonlinear loads. True…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Q14. In paralleling of synchronous generators, the machines that are to be paralleled must have the…

A: Conditions for parallel operation of alternators (synchronous generators) : -Bus bar voltage of the…

Q: a) Explain the principle operation of synchronous generator.

Q: The figure below shows the one-line diagram of a simple three-bus power system with generation at…

Q: (a) Sketch the equivalent circuit and obtain the general equation for synchronous generator

A: Synchronous generator: It is an electromechanical device. This is called a synchronous generator…

Q: In the system shown below, the generator is ideal (Xs = 0) and the magnitude of the load bus…

Q: Explain FIVE (5) iterative conditions of stopping criteria, that are considered in load flow…

A: In load flow analysis, the repetitive process of converging on the solution is referred as iterative…

Q: synchronous generator operating under steady conditions supplying a load current I0 to the bus at a…

A: Although equivalent circuit of synchronous generator under steady state condition is given by Where…

Q: 7. What is the nature of the generator-load frequency characteristics? 8. What is the effect of a…

A: Load-frequency characteristics: Under equilibrium conditions, but with equivalent primary control…

Q: For minimum cost of power generation the generator limits are consider as inequality constraints…

A: for the economic power generation the value of the power generation by the generator should be…

Q: ) the internal voltage of the generator and

A: Per unit (pu) system - Per unit (pu) system is used to express system quantity in the form of ratio…

Q: Four similar synchronous generators are sharing equally the feed to a load of 1 pu referred to the…

A: To find the correct option from the given statements

Q: Comment on the possible industrial application of cumulative compound generator types, series,…

Q: Tabulate the relative merits or otherwise of the Gauss-Seidel and the Newton- Raphson techniques of…

Q: Illustrate the salient effect of a sudden symmetrical short circuit across the terminals of a…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A) Highlight two significances of power factor correction.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: ineed conclusion for this topic( improvement of transient stability by using turbine fast valving…

A: Turbine fast valving method : Fast valving is a means of reducing turbine mechanical input power…

Q: UDng a ITIe Core in high frequency transformers. c- Discuss, different applications of iron cores of…

A: C)For magnetizing or demagnetizing a iron material, some energy is expended. The energy expended…

Q: The figure below shows the one-line diagram of a four- bus power system. The voltages, the scheduled…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: . Which one of the following method uses weak coupling between reactive power and voltage angle?. A.…

Q: Explain the phase advancer method in power factor improvement?with a proper diagram.

A: According to the question we have to explain the phase advancer method in power factor improvement ?…

Q: why is there a phase shift in rc cct?how do we make it exactily 90 degree?

Q: Plot generator output voltage versus load current for operating conditions with and without…

A: Voltage regulator is a circuit designed to maintain constant voltage at the output. The following…

Q: Problem 4: Consider an interconnected 50-Hz power system that contains four turbine-generator units…

A: The solution can be achieved as follows.

Q: 5/The phase angle between magnetizing component current and core loss component current is 180o…

A: The phase angle between magnetizing component current and core loss component current is 900.

Q: in distribution transformers; What is 30 degrees phase shift in delta-star connection? What are the…

A: In the star-delta connection, the primary side of the transformer is in delta configuration while…

Q: DC generators operating in parallel

A: Parallel Operation of DC Generator The Parallel Operation of the generator is very necessary if we…

Q: 8- What do you understand from the load curve and what information are converged by a load curve.

A: The following are the information obtained from load curves. 1. Load duration curve determines the…

Q: While preparing COPT, if identical generators are available in the system, it will follow rule a.…

A: In this question we need to choose a correct option.

Concept explainers

Photoelectric

The photoelectric effect occurs when light (or similar incident radiation, including X-rays) falls on material together with a metal plate and causes it to emit electrons. The discovery of the photoelectric effect led to important new theories (and to a Nobel Prize for Albert Einstein). Photoelectric cells, or photocells, are utilized in burglar-alarm light detectors and garage-door openers (each employs a through-beam of light this is broken when something movements throughout it), and also to play soundtracks on film movies (in which a light beam shines through the soundtrack encoded at the film and is "read" with the aid of the photocells).

Question

State True or false
a- The DC load flow study is a linear analysis
b- In a load frequency control, a generator unit equipped with a governor can be assumed to be a
controlled unit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Phase Advancer for power factor improvement. and What is penalty factor? Derive the expression for the penalty factor in economic load dispatch.
How do we handle a PV bus in the Gauss Seidel Method? What will happen to the bus voltage if the reactive power at a PV bus exceeds the upper bound? And why?
In power flow studies,if a network consists of a generator bus which elements of Jacobian Matrix will be neglected or become null ? why ?
Draw the phasor diagrams for a transmission line (modeled as short transmission line) when supplying a leading, lagging and unity power factor loads. Phasor diagram should include sending end voltage, receiving end voltage, load power factor, and line current. Based on the phasors answer the following: a. For lagging power factor load, is |??| >|??|? True/Falseb. For leading power factor load, is |??| >|??|? True/Falsec. For unity power factor load, is |??| >|??|? True/False
Choose the right answer. 1. The symmetrical component method is …………. 2. Conditions for succesful operation of a power system ………،……….. and ………… 3. The reason we use the numerical methods in load flow analysis is ……….
Tabulate the relative merits or otherwise of the Gauss-Seidel and the Newton- Raphson techniques of solving the load flow problem.
This question related to dc distribution /radial
Discuss the advantages and limitations of Gauss-Seidal and Newton Raphson methods . Of this two, which method is generally preferred for solving the load flow problems?
Calculate the initial symmetrical short circuit current that will occur when a 3 phase short circuit error occurs at the F point in the Figure below İ k3 phase-max ?
For the system in Figure 4 with given generation and load dispatch determine the voltages after two itterations of Gauss-Seidel method. Assume the initial voltage to be 1.01 at angle of 0◦ pu at bus 1, 1.015 at angle of 0◦ pu at bus 2, and 1.0 at angle of 0◦ pu at bus 3. All line impedances are in per unit on a common base, and charging is neglected. Take base power of 100 MVA.
The figure below shows the one-line diagram of a simple three-bus power system withgeneration at bus 1. The voltage at bus 1 is V1 = 1.0∠0°per unit. The scheduledloads on buses 2 and 3 are marked on the diagram. Line impedances are marked inper unit on a 100 MVA base.(a) Using Gauss-Seidel method and initial estimates of ?2(0) = 1.0 + ?0, ?3(0) = 1.0 + ?0, determine V2and V3. Perform two iterations.(b) If after several iterations the bus voltages converge to?2 = 0.90 − ?0.10 pu?3 = 0.95 − ?0.05 pudetermine the line flows and line losses and the slack bus real and reactive power.
Why are resistors and inductors considered to be series impedance and capacitors considered as shunt impedance in transmission line modeling?