statement is correct
Q: 209. In data over cable system interface specification, the downstream communication has only one a.…
A: In data over cable system interface specification, the downstream communication has only one
Q: A set of rules that govern the exchange of information over a communications channel is called a…
A: Step by step explanation step 1 of 2 The internet is basically a collection of interconnected…
Q: The Asymmetric Digital Subscriber Line- Lite (ADSL Lite) uses carriers for a. 512 DMT b. 64 DMT c.…
A: The Asymmetric Digital Subscriber Line-Lite(ADSL Lite) uses carriers for 256DMT.
Q: A single channel is shared by multiple signals by multiplexing
A: Given: A single channel is shared by multiple signals by multiplexing
Q: Multiplexing is used in Select one: O a. None O b. Circuit Switching O c. Packet Switching O d. Both…
A: Answer to the above question is in step2.
Q: A 6-MHz channel is used by a digital signaling system utilizing 4-level signals. What is the maximum…
A: Given Bandwidth B = 6MHz Number of levels L = 4
Q: Question 25 Which term describes the rate at which the signal alternates over a given period of…
A: The given question are multiple choice selected question.
Q: 79. ADSL is the abbreviation of a. Asymmetric Dual Subscriber Line b. Asymmetric Digital System Line…
A: Given that, ADSL is the abbreviation of (a) Asymmetric Dual Subscriber Line (b) Asymmetric Digital…
Q: explain the effect of AWAY channel on ASK signal.
A: explain the effect of AWAY channel on ASK signal.
Q: A thin UTP cable has higher attenuation than a thicker UTP cable. Select one: O True O False
A: In step 2, you will get the answer
Q: VLAN A Prefix Size: 19 VLAN B Network Mask 255.0.0.0
A: THE ANSWER IS
Q: The term "channel bandwidth" is defined by this function. What makes this such an important aspect…
A: Bandwidth of the channel: « As a channel bandwidth is the rate at which data is usually transmitted…
Q: DSL stands for a. digital subscriber line b. digital switched line c. data subscriber line d. data…
A: DSL Stands for digital subscriber line is the broadband connection uses in the homes today with the…
Q: 110. Bandlimited signal is a. transmission of signals without modulation b. simultaneous…
A: A signal whose energy contained within finite range
Q: Mention all protocols and function when appear 404 message when requesting and reply
A: Given that Mention all protocols and function when appear 404 message when requesting and reply 1.…
Q: Select the correct statement(s) regarding in-band and out-of-band control and signaling. a.…
A: Given: Statements regarding in-band and out-of-band control and signaling. out-of-band control and…
Q: _____technology is a set of technologies develpoed by the telephone companies to provide high data…
A: technology is a set of technologies developed by the telephone companies to provide high data rate…
Q: We cannot send the digital signal directly to the channel, when the channel is a. bandpass b.…
A: There is a multiple choice question given. The digital signal can not be sent directly, when the…
Q: A channel has a 1-MHz bandwidth. The SNR for this channel is 63. What is the appropriate bit rate?…
A: Answer to the above sum related to finding bit rate is detailed in step2.
Q: The size of IP is 16 bits Select one: True False
A: Here, I have to choose an option to the above question.
Q: What multiplexing technique where individual messages are transferred to a new poisiton in the…
A: This question comes from Electronics which is a paper of Computer Science. Let's discuss it in the…
Q: Statement is true/false with explanation. 1. When we send any signal over wireless channel for long…
A: According to the information given:- We have to identify the mentioned statement are true or false.
Q: True or false: An 802.11 station must send an RTS frame and receive a corresponding CTS frame before…
A: Actually, given the question regarding 802.11 station transmits a data frame.
Q: Wi-Fi station with one antenna is connected to an Access Point with a PHY rate of 65 Mbps. The…
A: Summary: - Hence, we have discussed all the points
Q: 39. The _________ product defines the number of bits that can fill the link. a. bandwidth-period b.…
A: The ___ bandwidth-delay______ product defines the number of bits that can fill the link. So, option…
Q: . In an HFC network, the downstream data are modulated using the _______ modulation technique. a.…
A: Answer : QAM is the right Answer.
Q: 246. The High-bit-rate Digital Subscriber Line (HDSL) was designed as an alternative to a. ADSL b.…
A: We need to find the correct answer for the given statement-"The High-bit-rate Digital Subscriber…
Q: Sliding windows ARQ (Automatic Repeat Request) can be categorized into two categories such as…
A: Sliding Window Protocol : The sliding window is a technique for sending multiple frames at a time.…
Q: Why Asynchronous transmission is better than synchronous transmission.Why Asynchronous transmission…
A: SYNCHRONOUS TRANSMISSION: There is no gap between data in synchronous transmission. When…
Q: ________receives a signal and, before it becomes too weak or corrupted, regenerates the original bit…
A: Question A ________receives a signal and, before it becomes too weak or corrupted, regenerates the…
Q: are the multiple access protocol for channel access control.
A: Multiple Access Protocols: The set of protocols that operate in the Medium Access Control sublayer…
Q: Five channels, each with a l00 kHz bandwidth, are to be multiplexed together. What is the minimum…
A: Five channels, each with a l00 kHz bandwidth, are to be multiplexed together the minimum bandwidth…
Q: A channel which has a bandwidth that starts from zero frequency is called a channel. O a. Bandpass O…
A: Lets see the solution.
Q: A(n)____________- takes the form of a series of numbers to route data to an appropriate location on…
A: The right answer to this question is : IP address
Q: onsider CDMA scheme in the following figure. What is the data equence on the common channel? Bit 0…
A: It is defined as a Code Division Multiple Access (CDMA) which is a sort of multiplexing that…
Q: Draw the BLOCK DIAGRAMS (Refer to internet) for 2- channel PAM / TDM Transmitter.
A: we have to give block diagram
Q: We cannot send the digital signal directly to the channel, when the channel is a. bandpass b. Bypass…
A: Answer to the above question related to digital signal is in step 2.
Q: A set of rules that govern the exchange of information over a communications channel is called a 1.…
A: The answer as given below steps:
Q: This function defines the term "channel bandwidth." What makes this a crucial feature of a contact…
A: Introduction: The channel's bandwidth is:
Q: Please give a neat and understandable configuration. Thanks. Assume there are 4 voice channels,…
A: Answer the above question are as follows
Q: The V.34bis modem provides a bit rate of 28,800 with a a. 960-point constellation b. 1250-point…
A: The V. 34bis Modem provides a bit rate of 28800 bps with a 960 point constellation, to a bit rate of…
Q: he position of the 802.11 beacon frames.
A: It is defined as the units of digital transmission particularly in computer networks and…
Q: In fixed channel assignment strategy, each cell is allocated a predetermined set of _______ a) Voice…
A: The answer is given below:-
Q: Define access the caller’s data
A: Lets see the solution in the next steps
Q: Communication in the traditional cable TV network is a. bidirectional b. unidirectional. c.…
A: According to the Question below the Solution:
Q: Q 01:…
A: A computer network, also known as a data network, is a communication system that enables a system to…
Q: spectrum of a channel is between 3000 Hz and 6000Hz and SNRdb = 64 dB. WHAT appropriate bit rate…
A: Two formula needed to solve this problem. data rate=bandwidth * log2(1+SNRdb) from nyquist…
Q: Question 38 Group delay variation (GDV) affects which types of modulation the most? BPSK O QPSK 256…
A:
Q: 250. The local loop has a bandwidth of a. 400Hz b. 4Hz c. 40Hz d. 4000Hz
A: Local loop is a wired connection between sender and local service provider
Which statement is correct
a. Multiplexing uses a single channel and multiple paths
b. Multiplexing uses a single channel and single path
c. Multiplexing uses multiple channels and multiple paths
d. Multiplexing uses multiple channels and a single path
Step by step
Solved in 2 steps
- Yes or false, please explain your answer: The alternating-bit protocol is the same as the SR protocol when both transmitter and receiver windows are 1.A(n)____________- takes the form of a series of numbers to route data to an appropriate location on theInternet.Please answer the following questions as true or false, and briefly explain why your response is correct: When both the transmitter and receiver windows are set to 1, the alternating-bit protocol is the same as the SR protocol.
- In fixed channel assignment strategy, each cell is allocated a predetermined set of _______a) Voice channelsb) Control channelsc) Frequencyd) base stationsWhat multiplexing technique where individual messages are transferred to a new poisiton in the spectral range? A. Phase B. Time C. Amplitude D. FrequencyThe Default administrative distance (AD) of RIP is: a) 115. b) 90. c) 120. d) 110.
- In asynchronous transmission, the gap time between bytes is variable why?MAC address of a device is represented using Hexadecimal number. A section of MAC address is given in the following format: [Last 3 digits of your registration number]. You are asked to sketch the given MAC data using polar signaling and pseudo-ternary signaling. COMPARE the characteristics of waveforms and conclude that which of the waveforms is NRZ and RZ. Write proper justification of your answer. Reg three digits: 031What are the hardware and protocol types? ** Enter arp in the Wireshark window's filter box and press enter. Select the first ARP request packet from the packet list pane. Select the Address Resolution Protocol from the packet detail window.
- In asynchronous transmission, the gap time between bytes is _______. a. fixed b. variable c. a function of the data rate d. zero239. A channel has a 1-MHz bandwidth. The SNR for this channel is 63. What is the appropriate signel level? a. 2 b. 8 c. 4 d. 16134. Which of the following frequency ranges is used for AM radio transmission? a. High Frequency : 3 MHz to 30 MHz b. Very Low Frequency : 3 kHz to 30 kHz c. Medium Frequency : 300 kHz to 3 MHz d. Very High Frequency : 30 MHz to 300 MHz
