Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until it is just dry saturated, then it is re-heated to 400 °C and expanded through the second-stage turbine. The condenser pressure is 0.04 bar. what is the temperature in degrees celcius at state 4? find the thermal efficiency of the system in percentage to 2.d.p?

Q: A refrigeration system is used to cool water in the evaporator an 8 kg/s of water from 30C to 2C.…

A: The amount of heat that each pound of refrigerant retains from the refrigerated space to provide…

Q: Find COP of a reversible heat pump operating between temperatures 20 and 200 °c

A: Given, Temperature of hot reservoir = TH = 200 oC = 473 K, Temperature of cool reservoir = TL = 20…

Q: The higher temperature of a refrigerating system operating at a Reverse Carnot Cycle is 240 °F and…

A: Higher temperature in the cycle, TH=240oF=388.706 KLower temperature in the cycle, TL=266.483…

Q: 5- A steady flow of steam enters a condenser with an enthalpy of 2300 kJ/kg and velocity of 350 m/s.…

A:

Q: 2. Steam at 28 bar and 50 degrees Celsius superheat is passed through a turbine and expanded to a…

A:

Q: 3- A reaction turbine is supplied with steam at (60 bar, 600 C°). The condenser pressure is (0.07…

A: AS PER COMPANY GUIDELINES, ONLY FIRST QUESTION HAS TO BE SOLVED. FOR SOLUTION OF THE SECOND…

Q: 5.4 In the continuous stirring heating tank, the flow rate of the influent is 200lb/min, the…

A: Write the expression of temperature variation. T=T0e-kt     80=90e-kt   ...... (1)

Q: In a 14 TR ammonia refrigeration plant, the condensing temperature is 250C and evaporating…

A: TH=25°CTL=-10 °CSub-cooled by 5 °CTH'=20°Cx1=.97Assume vapor leaving the compressor is saturated…

Q: 10kg/sec of steam enters a condenser with enthalpy of 2300kJ/kg and velocity of 350m/s , the…

A:

Q: 3. A vapour compression refrigerator uses R-12 as refrigerant and the liquid evaporates in the…

A: Given: h1 = 180.88 kJ/kg h3 = h4 = 45.4 kJ/kg, h1 = 191.76 kJ/kg, s1 = 0.7051 kJ/kg K sg2 = 0.6921…

Q: A Carnot Refrigerator cycle absorbs heat at 270K and rejects it at 300K. Find the following: 1.Find…

A: Refrigerator is a device which maintains a body temperature lower than the normal temperature or…

Q: Steam at 5.1 MPa and 370°C enters a turbine and expands until it becomes saturated. The steam is…

A: T-S diagram:

Q: Steam is delivered by a steam generating unit at 1100 psia and 900 F. After expansion in the turbine…

A: a) Given Data: P1=1100 psiT1=900 FP2=P3=300 psiT3=900 FP4= 1 psi

Q: In the open-circuit steam plant, boiler feed water at atmospheric pressure 1 bar and 35oC is pumped…

A:

Q: an ideal adiabatic compressor compresses air from 1 atm to 5atm. The inlet temperature is 293K and…

A:

Q: An ammonia simple vapor operates between evaporator and condenser temperature of -20°C and 35°C…

A:

Q: A condenser takes in steam with enthalpy of 2450 kJ/kg and mass flowrate of 2 kg/s. It also…

A: in condenser process is constant pressure.

Q: The higher temperature of a refrigerating system operating at a Reverse Carnot Cycle is 240 °F and…

A:

Q: An 80 ton refrigeration system requires 105 KW from VECO. If motor compressor efficiency is 60%,…

A: Given data: ◆ The refrigeration effect: R.E. = 80 tons ◆ The compressor power: Wcomp = 105 kW ◆ The…

Q: and pressure ratio of the compressor and turbine is 8. If the ar are 1.0 bar and 300 K. find the…

A: Given:ηc=0.86ηT=0.90T3=1200 KT1=300 KP1=1 barrP=8γ=1.4

Q: Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam…

A: Calculate the total pump work of the cycle?

Q: Example 4.5: Steam expands in a turbine from 25 condenser pressare of 20 KPa. Evaluate the Rankine…

A: Draw the TS diagram for a better understanding of the problem. Since process 1-2 is isentropic…

Q: A Carnot engine rejects 50% of the heat absorbed from a source to a sink at 27°C. What is the source…

A: Given data: TL=27°C=300 KQL=0.5QH Need to determine the source temperature.

Q: An engine takes energy from a reservoir at Th=1200 K and gives out exhaust gas at Tc =300 K. What is…

A: Given data as per the question  Reservoir temperature Th=1200 K  Sink temperature Tc =300 K For…

Q: A 7.162M British Thermal Unit per hour is required for a gas turbine power plant in Palawan wherein…

A: Calculated air flow in lb/min.

Q: A two stage air compressor has a suction condition of 100 kpa, 30 o C and has a capacity of 3 m3 /s.…

A:

Q: A Factory uses a vapor absorption refrigerator to cool its products, the heat is supplied to…

A: Given that, Temperature of steam generator, TG=150 °C,Evaporator temperature, TE=-5 °C,Refigeration…

Q: A reheat cycle with two stages of reheating is executed, with steam expanding initially from 90 bar…

A:

Q: 5. Steam is generated at 6.10 MPa and 4500C and condensation occurs at 170 kPa. (a)For a Rankine…

A:

Q: Find the quanity of heat required to produce 79% dry steam at 8000 kpa from feedwater at 50 degrees…

A: Given:x=0.79P=800 KPaT=50°C

Q: 2.A steam throttling valve with inlet conditions of 3MPa and 500C is connected to the inlet of the…

A:

Q: In an absorption refrigeration system, heating cooling and refrigeration takes place at 140°C, 25°C…

A:

Q: Steam engine with incomplete expansion receives saturated steam at 1.04 Mpa, expands it to 0.105 Mpa…

A: Since, you have posted multiple subparts and each subparts, there is more than one question. So, as…

Q: A flashed steam geothermal powerplant is located where underground hot water is available as…

A:

Q: A reversible heat pump is working between 9°C and 28°C. The minimum power required per ton on…

A: Given, Temperature of source = TL = 9 oC = 282 K Temperature of sink = TH = 28 oC = 301 K Heating…

Q: A one-stage compressor with an ideal intercooler receives 0.5m3/s of Helium at 150kpa and 300K and…

A: Given data: V˙=0.5 m3/sP1=150 kPaP2=8600 kPaT1=300 K Need to determine the heat rejected at the…

Q: Q2 / Heat is transferred from a tank of water in a refrigerator at(OC) degrees to a tank of boiling…

A: As per our guidelines, experts can provide solution to only one problem in case of multiple…

Q: In an absorption type refrigerator, the heat is supplied to NH, generator by condensing steam at 2…

A:

Q: The pressure and temperature entering the turbine is 1800kpaa and 380oC. The temperature leaving the…

A:

Q: A belt-driven compressor is used in refrigeration system that will cool 10 liters per second of…

A: givenQ=10ltr/sT1=13oCT2=1oCηb=0.98%ηm=85%Wactual=0.7kW/ton refrigerationηo=65%

Q: A two-stage air compressor has an intercooler between the two stages, as shown in Figure. The inlet…

A: Let us consider, Inlet to first stage of compressor = state 1 Exit of first stage of compressor (and…

Q: A one pass steam generator receives saturated water at 20 bar, and converting it into steam at…

A:

Q: turbine. It expands to 40 r and 280 °C. It is then reheated to 490 °C and expands to 8 bar and 270…

A: As Given Data:- P1 = 250 bar , P2 = 40 bar and P3 = 8bar T1 = 500°C, T2 = 280°C,  T3=270°C

Q: Find the refrigeration capacity (in TR ) required to cool 29 m³/min from 29°C to 18°C if air from…

A:

Q: A steam power-plant, with a power of "Wnet", is working according to the Rankine cycle. Steam enters…

A:

Q: a. The theoretical minimum power input to the compressor b. The reversible COP, If the high and low…

A:

Q: Steam enters the steam-generating unit at a pressure of 20 bar and dryness of 0.96 and leaves at the…

A: Answer: The percentage increase in volume due to superheating is 44.9024%.

Q: steam enters the steam generating unit at a pressure of 20 bar and dryness of 0.96 and leaves at the…

A:

Q: A steam turbine developed 2372.2 hp when its inlet condition is 1300 BTU/lb enthalphy and 400 ft/s…

A: given data-  power developed P= 2372.2 hp mass flow rate = 200 lb/min inlet condition - h1 = 1300…