Submit Answer 2. Pick a "for every" statement about copper and silver nitrate for this balanced reaction Hint: The correct balanced equation is Cu + 2A9NO, → 2Ag + Cu(NO)2 For every 1 mole of Cu, the reaction uses 2 moles of AgNO, For every 1 mole of Cu, the reaction makes 2 moles of AGNO, For every 1 mole of Cu, the reaction uses 3 moles of AgNO, For every 1 mole of Cu, the reaction uses 1 moles of AgNO, Submit Answer 4/4 submissions remaining

Submit Answer 2. Pick a "for every" statement about copper and silver nitrate for this balanced reaction Hint: The correct balanced equation is Cu + 2A9NO, → 2Ag + Cu(NO)2 For every 1 mole of Cu, the reaction uses 2 moles of AgNO, For every 1 mole of Cu, the reaction makes 2 moles of AGNO, For every 1 mole of Cu, the reaction uses 3 moles of AgNO, For every 1 mole of Cu, the reaction uses 1 moles of AgNO, Submit Answer 4/4 submissions remaining

Chemistry by OpenStax (2015-05-04)

1st Edition

ISBN:9781938168390

Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Publisher:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser

Chapter18: Representative Metals, Metalloids, And Nonmetals

Section: Chapter Questions

Problem 25E: A chemist dissolves a 1.497-g sample of a type of metal (an alloy of Sn, Pb, Sb, and Cu) in nitric...

See similar textbooks

Similar questions

Pure copper may be produced by the reaction of copper(I) sulfide withexcess oxygen gas as follows:Cu2S(s) + O2(g) ---> 2Cu(s) + SO2(g)What mass of copper(I) sulfide is required in order to prepare 0.610 kg ofcopper metal?A. 0.610 kgB. 0.764 kgC. 0.305 kgD. 0.459
A student is performing an experiment in the laboratory to determine the oxidation of copper (Cu). Cu reacts with oxygen in the air to formCuO in thefollowing reaction: Cu (s) + O2(g) →CuO (s) The student weighted 1.528gof Cu (s)powderin a crucible and heatedthe sample with a Bunsen burner.Even by using the Cuinpowderform and heating the sample there is unreacted Cu left in the crucible.After heating the student weighted the substance inside the crucible to be 3.647g. 1) If the student weighted 3.647 g of substance in the crucible. Calculate how much of this is unreacted Cu (s) and how much is CuO (s). (Hint: use the balanced chemical equation). 2) Once you know the amount of CuO (s) obtained in this experiment, calculate the percent yieldof CuO in this experiment.
Which answer represents the correct balancing coefficients (in order from left to right) & the type of reaction for: ___ PbSO4 ---> ___ PbSO3 + ___O2
Please view the video* below and answer the following questions.https://www.youtube.com/watch?v=1ocQhkHw_MM1. Two reactions were demonstrated in the video above. Write the balanced equations for both reactions below.a.b.2. What catalyst was used in the decomposition of hydrogen peroxide?3. Which safety rule is broken during the demonstrations shown in this video?4. View the video and complete the table below.https://www.youtube.com/watch?v=_G7sNq7R29w Observations Balanced Reaction Equation 5. View the video and complete the table below.https://www.youtube.com/watch?v=yLsjsy_Dqd0 Observations Balanced Reaction Equation
In the In the old Weldon process, chlorine was made from by-product HCl by the reaction: MnO2 + HCl → MnCl 2 + Cl 2 + H2O Into a retort were charged 500 lb pyrolusite (86% MnO2) and 3500 lb hydrochloric acid (S.G. 1.098,20% HCl). The reaction was 92% complete. Determine (a) the limiting reactant based on mole ratio(b) lb Cl2 produced, (c) % excess reactant (d) % yield of MnCl2 if the actual amount of MnCl2 producedis 500lb. (MW: Mn=54.94, Cl = 35.45)
A chemist setup a synthesis of phosphorus trichloride by mixing 12.0gP with 35.0gCl _(2) and obtained 42.4gPCl _(3). Calculate the percentage yield of this compound. P(s)+Cl_(2)(g)->PCl _(3)(l) Please type answer note write by hend
A chemist carries out the reaction below and obtains 3.45g of iron Fe (Fe, MW=55.845g/mol). Fill in the blanks below to determine the percent yield of the reaction when 8.30g of Fe2O3 (MW= 159.69g/mol) and 3.50g of CO (MW=28.01G/mol)were used in the reaction. Fe2O3(s) + 3CO(g) = 2Fe(s) + 3CO2(g) Note that for two of the blanks, will be the same answer. 1. What would be the mass in grams of Fe produced based on the mass of Fe2O3 used? answer: (blank) 2. What would be the mass in grams of Fe produced based on the mass of CO used? answer: (blank) 3. What is the theoretical yield of Fe in grams? answer: (blank) 4. What is the limiting reagent? Enter the formula of compound. answer: (blank) 5. What is the percent yield of this reaction? answer: (blank)
One day in lab, while taking apart a complicated distillation apparatus, your friend Maya (an expert chemist) says this: "Metal sulfides roasted with oxygen produce the corresponding oxide and sulfur dioxide gas." Using Maya's statement, and what you already know about chemistry, predict the products of the following reaction. Be sure your chemical equation is balanced! ZnS(s) +O2(g) ->
In a test tube add a few trops off sulfuric acid to 3g of MnSO4 . After that add 2-3 drops of Silver nitrate solution in the end add 2 g of K2S2O8. Give the reaction equation.
A 0.8102 g sample of impure Al2(CO3)3 was decomposed with HCl; the liberated CO2 was collected on calcium oxide and found to weigh 0.0515 g. Calculate the percentage of aluminum in the original sample. [Note: Assume all the collected CO2 came from the Al2(CO3)3 and Hint: Write the balanced chemical reaction.]
When the reaction below is balanced, what is the coefficient for Mn2+? Mn2+ + ClO2 --> Cl- + MnO2 a. 6 b. 5 c. 12 d. 2
A sample of ultrapure silicon was reacted with excess oxidizing yielding SiO2. After properfiltration and drying, the precipitate weighed 3.1754 g. If ultrapure silicon is 99.98% Si, what massof sample was used?