t = 01 HellF2 cos 41 VFigure Q2(a) Q2(a)Figure Q2(a) shows the RLC circuit in the time domain with Vs= 2 cos 4t Vand the complete response if v (0) = 2V when the switch is closed.(i)Draw the equivalent circuit in frequency domain when t> 0(ii)Determine the voltage, v(t) in s-domain and time domain when t > 0.

Answered: Image /qna-images/answer/27701435-b957-4295-9d30-cbcc693915fc.jpg

Answered: t = 0 6Ω 1H 2 cos 41 V F Figure Q2(a)

Engineering

Electrical Engineering

t = 0 6Ω 1H 2 cos 41 V F Figure Q2(a)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For the circuit below with the switch closed and then opening at t=0, and R1= 9Ω, R2= 4Ω, L = 9H, C=3F, vg = 7V, calculate the initial conditions. For t > 0, develop the differential equation for the solution using mesh analysis.
The response of a system, h(t) is given as in Figure 1 below where the amplitudeof this signal is 7. Then,this system is excited by an input of x(t) = (u(t) × (u(-t)+u(t))) /1. 1)Illustrate the input signal, x(t). 2)Calculate the convolution output of the system y(t) = x(t) ∗ h(t). Nextdetermine y(t) when t is 1 sec 2)Prove the solution in Q2 is comparable when solving in frequency domain(Laplace). Next, sketch the signal for convolution output.
A)Perform the N=5 point circular convolution of x and h using DFT. B)Perform the N=5 point circular convolution of x and h in time-domain.
A) Reduce the block diagram. B) G1(s)= 2/s, G2(s)= 1/4s+2, G3(s)=4, H(s)=0.5 According to these; find the time constant, natural frequency, damping rate, and dynamic behavior. C)G1(s)= 2/s, G2(s)= 1/4s+2, G3(s)=4, H(s)=0.5 Find the poles, zeros, and reverse Laplace of the system. Is it stable or not?
For the circuit shown below, the initial conditions are zero, Vdc is a voltage source continuous and switch S is closed at t = 0.a)Determine the equivalent impedance to the right of points a and b of the circuit, Z(s).b)Obtain the input current of the circuit in the frequency domain, I(s). employ the properties of the initial and final value and calculate the values of i(0) and i(∞).c)Find the expression for i(t). Check if the values of i(0) and i(∞) agree with those calculated in the previous item.d)Obtain voltages v1(t) and v2(t).
The system whose characteristic equation is given as s3 + 2s2 + Ks + 20 = 0 is asymptotically stable for which K values
For the system with forward path gain G(s)=s+5s2+3s+2G(s)=s+5s2+3s+2 and feedback gain H(s)=1s+3H(s)=1s+3, input R(s)=8sR(s)=8s will be applied. Find the steady-state error (ess) that will occur in the system and enter it into the space given below
Consider two systems one is second order and the other is third order. The characteristic equations are: as2+bs+c for the second order and as3+bs2+cs+d for the third order, where a,b,c,d are positive real numbers. Then which of the following is correct with regard to the stability of these two systems? a. stability of either system cannot be confirmed with the given data b. third order is definitely stable but second order cannot be confirmed c. both systems are definitely stable d. second order is definitely stable but third order cannot be confirmed
There is no energy stored in the capacitors in the circuit at the time the switch is closed. 1. a) Construct the s-domain circuit for t>0. 2. b) Find I1, V1, and V2. 3. c) Find i1, v1, and v2.4. d) Do your answers for i1, v1, and v2 make sense in terms of known circuit behavior? Explain.
The mathematical models of some continuous time systems are given above. x(t) is the input signal of the system, and y(t) is the output signal of the system. Which of the following systems is linear and which is nonlinear? For linear systems, write "linear" in the space next to the option. For non-linear systems, write "non-linear" in the space next to the option.
Given the ff. second-order differential equation: y[n] + 1.4y[n-1] + 0.45y[n-2] = x[n] - x[n-1] with an input of x[n] = 0.1nu[n] and initial conditions y[-1] = 0 and y[-2] = 1. Find the following: 1. Characteristic equation and its roots. 2. Form of the homogeneous solution 3. Particular solution
The RLC network below:a) Provide the second order differential equation describing this circuit b) Compute the undamped natural frequency of the circuit and the damping ratio.c) What type of response does i(t) exhibit for t > 0 ? Explain why.