Table 1 Concentration of Concentration of Initial concentration Acetic Acid in Organic | Acetic Acid in Aqueous of Acetic Acid Layer, N Layer, N 1 N 0.0150 (A) (B) 0.5 N 0.0033 0.25 N 0.0011 (C) Table 2 Initial concentration of Acetic Кс Acid, N 1N - 0.5 N 1.6811 0.4505 0.5 N – 0.25 N 0.5731 0.6390 1 N- 0.25 Ν 1.1882 0.5297 Average (D) (E)

Table 1 Concentration of Concentration of Initial concentration Acetic Acid in Organic | Acetic Acid in Aqueous of Acetic Acid Layer, N Layer, N 1 N 0.0150 (A) (B) 0.5 N 0.0033 0.25 N 0.0011 (C) Table 2 Initial concentration of Acetic Кс Acid, N 1N - 0.5 N 1.6811 0.4505 0.5 N – 0.25 N 0.5731 0.6390 1 N- 0.25 Ν 1.1882 0.5297 Average (D) (E)

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter7: Statistical Data Treatment And Evaluation

Section: Chapter Questions

Problem 7.10QAP

See similar textbooks

Similar questions

Suppose the concentration of a solute varies along the length of a container according to c(x) = c0 - βc0x2, where c0 is the concentration at x = 0. Calculate the thermodynamic force on the solute at 25 °C and x = 8 cm and 16 cm given that the concentration falls to 1/2c0 when x = 15 cm. Hint: Start by finding the value of β.
Suppose the concentration of a solute decays linearly along the length of a container according to c(x) = c0 - αc0x, where c0 is the concentration at x = 0. Calculate the thermodynamic force on the solute at 25 °C and at x = 10 cm and 20 cm given that the concentration falls to 1/2c0 when x = 10 cm. Hint: Start by finding the value of α.
Hexanoic acid was added to an immiscible biphasic solvent sysem, water and CCl4 at 20.0OC and the equilibrium concentrations of hexanoic acid were determined to be 3.66 g/L in H2O and 67.0 g/L in CCl4. Caluclate the distrubution coeffiecent (D1) of hexanoic acid in CCl4 with respect to water.
A chemist obtained the following data for the percent compound Z in triplicates (n=3) of an insecticide preparation: 7.47, 6.98, and 7.27. Calculate the 90% confidence limit for the mean of the data assuming that only information about the precision of the method is the precision for the three data points.
determine sauturation properties of propane at the relieveimg pressure 115kpa?
An experiment was conducted to determine the effect of glucose on the freezing point of water. Experimental data showed thatthe freezing point depression of water in solution was –2.6°C when 1.0 g of glucose was dissolved in 10g of solvent. Calculatethe expected freezing point for such solution and compare the expected freezing point to the value found experimentally. Give aplausible explanation for any discrepancies. (M.W. of glucose= 180.16g/mol; i=1). Show all your work.
What is ΔSsys for a freezing phase transition at 29.7 °C for a compound that freezes at 29.7 °C and the ΔHsys = -19.45 kJ mol-1 for this process? Express your answer in J mol-1 K-1 to at least two significant figures.
Using the kinetic data pictured, estimate Vmax and Km for the catalysis of Substrate 1 by the following enzyme (using the correct units).
Glucose from molasses is fermented to alcohol using S. cerevisiae where 500 ml of CO2 (at standard temperature and pressure) is produced. If the volume of the fermentation medium is 500 ml, what is the concentration of ethanol in g/ml?
The osmotic pressure of a solution of polystyrene in toluene (methylbenzene} was measured at 25 °C with the following results:c/(g dm-3) 2.042 6.613 9.521 12.602∏/Pa 58.3 188.2 270.8 354.6Determine the molar mass of the polymer.
10.11/ A 1.5-kg specimen of a 90 wt% Pb-10 wt% Sn alloy is heated to 250°C (480°F), at which temperature it is entirely an a-phase solid solution . The alloy is to be melted to the extent that 50% of the speci- men is liquid, the remainder being the a phase. This may be accomplished either by heating the alloy or changing its composi- tion while holding the temperature con- stant. (a) To what temperature must the speci- men be heated? (b) How much tin must be added to the 1.5-kg specimen at 250°C to achieve this state? 10.15) A magnesium-lead alloy of mass 5.5 ka consists of a solid a phase that has a compo- sition that is just slightly below the solubility limit at 200°C (390°F). (a) What mass of lead is in the alloy? (b) If the alloy is heated to 350°C (660°F). how much more lead may be dissolved in the a phase without exceeding the solubility limit of this phase? 10.27 A hypothetical A-B alloy of composition 55 wt% B-45 wt% A at some temperature is found to consist of mass…
Chloroform (1)/methyl ethyl ketone (2) form a solution in vapor liquid equilibrium at 330 K. The chloroform concentration in the liquid phase is x1 = 0.55. Assuming an ideal gas and an ideal solutionof liquids, what are y1 and P (in kPa), to 3 significant figures?