Determine the direction of the inductive current flowing through resistor R in the circuit.1.1 When removing the moving South Pole from the coilNa Ř bChoiceA)The induced current flows from point a to point b.B)The induced current flows from point b to point a.C)No induced current flows through resistor R.

Answered: Image /qna-images/answer/c271a9d6-c5da-44c4-9066-88a79a57ae81.jpg

termine the direction of the inductive current flowing through resistor R in the cire 1.1 When removing the moving South Pole from the coil N S а R b a Choice A)The induced current flows from point a to point b. B)The induced current flows from point b to point a. C)No induced current flows through resistor R.

termine the direction of the inductive current flowing through resistor R in the cire 1.1 When removing the moving South Pole from the coil N S а R b a Choice A)The induced current flows from point a to point b. B)The induced current flows from point b to point a. C)No induced current flows through resistor R.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 63A

See similar textbooks

Similar questions

Use the picture below to answer. The metal bar has a length of 2 meters, the magnetic field has a strength of 3.5 T, the bar is moving 4 m/s, and the resistance is 10 Ω. a) Calculate the voltage generated when the bar is moving at 4 m/s. b) Using the right hand rule and Faraday’s/Lenz’s Law determine the direction of the current in the circuit. c) Using the voltage from part a), calculate the value of the current flowing through the circuit. d) Calculate the force that the metal bar feels due to the current flowing through it in part c) and the magnetic field. Also right down the direc- tion of this force.
The circular conducting loops shown in the accompanying figure are parallel, perpendicular to the plane of the page, and coaxial. (a) When the switch S isclosed, what is the direction of the current induced in D? (b) When the switch is opened, what is the direction of the current induced in loop D?
Please answer this and explain how you found the answer! Indicate the direction of the induced current in each loop by writing clockwise, counterclockwise, or none.
Indicate the direction of the induced current in the wire using Lenz’s law and explain how you determined it to be in that direction
State the direction of the induced current for each case shown below, observing from the side of the magnet.
A rectangular loop of wire is placed midway between two long straight parallel conductors as shown in figure (11). The conductors carry currents i1 and i2 as indicated. If i1 is decreasing and i2 is constant, then the induced current in the loop is:
The circular conducting loops shown in the accompanying figure are parallel, perpendicular to the plane of the page, and coaxial. (a) When the switch S is dosed, what is the direction of the cun’ent induced in D? (b) When the switch is opened, what is the direction of the current induced in loop D?
Please Do not Give Directly answers otherwise give Downvote. And proper Hand written. A small square loop of wires of side / is placed inside a large square loop of wire of side (L>> I). The loops are coplanar and their centres coincide. The mutual inductance of the system is proportional to. (A) I/L (B) I^2L (C) L/l (D) L^2/L.
Please just answer this question: Qualitatively discuss what effect considering the resistance of the conducting rails would have on your estimate of terminal velocity. Make sure to consider that as the rod slides,the overall resistance of the circuit increases as a function of that distance slid. Do you think this would lead to a larger or smaller terminal velocity than the one you calculated in part (b)? (Note if it helps: I calculated an induced current of 0.049A for part b).
Please answer it fast The primary voltage of a 2300/230 volts transformer has a frequency of 60 cycles. What is the frequency of the secondary voltage?
PLSS ANSWER WITHIN 8MINS An electric field of 185 x10-6 VIm is induced within the loop of long solenoid with cross sectional area of 3.18 cm2. The radius of the loop is 3.31 cm. Calculate the number of turns if the current in the winding is increasing at a rate of 87 A/s. • Final answer should be expressed in two (2) decimal places. Round up or down accordingly. • For the final answer, please write/include the unit, express you answer in "Turns"