that transmission efficiency increases with increasing transmission voltage or By increasing the cross-sectional area of the conveyor wire When the power generated is proven and line length The specific and resistance of the wire and the power factor

Q: The stator of a 3-phase, 16-pole alternator has 144 slots and there are 4 conductors per slot…

A: Given :No. of phases=3No. of poles, P=16No. of slots, S=144Speed of the alternator, n=375 rpmAir gap…

Q: A lossless parallel-plate transmission line having a characteristic impedance 50 is terminated…

A: Solution:Given Data :characteristic impedance =50 (ohm)Z=impedance= (40+30) frequency = 200…

Q: LRC circuit + { +qC 1 -9 +Qmax L Dr <I а так S2 -IR-L - 1²/12 = 0 + &#+++ 4 = 0 R L (-B/L) + ⇒ 9 = A…

A: Given Data:An RLC source-free circuit with, the charge equation as,To Find:The expression for…

Q: x+y+z=9 2x + 5y + 7z = 52 2x+y z = 0

A:

Q: 5) Consider the sampling system at the right. The input signal xe(t) has the Fourier transform shown…

A: To determine the minimum sampling rate without aliasing, we need to consider the bandwidth of the…

Q: Number 4 Number 5

A: The above question pertains to the operation of a simple motor.As requested, only parts 4 and 5 are…

Q: Determine Thevenin equivalent voltage of the following circuit + E = 20 V R₁ ≤6N 6Ω R₂- 6Ω 6Ω M R3

A: Circuit diagram is given as,

Q: A DC Optimal Power Flow problem is to be solved for a 3-bus network. The per-unit reactances of the…

A: per unit reactance of the interconnecting busses are reference bus 1  as base MVA is 100 MVAthe…

Q: Question 8: a- Use superposition theorem to find the current and power through R₂ in the following…

A:

Q: 2. The plot below is a sketch of the magnitude response of the asymptotic Bode plot of a system…

A: A bode plot which has two slopes of 6 and -12 dB per octave.

Q: Write the mathematical expression for bandwidth efficiency of M-ary signals. Find the bandwidth…

A:

Q: 2. Consider the circuit shown below: V₁ ▷ R₁ ww + Vo Assume that the diode can be modelled using the…

A:

Q: 8- Find the sequence for the following z-transform z² + 2z X(z)= (z-1)(z + 3) If the ROC is: i) |z|3

A: Given:To find:The sequence x[n] corresponding the given X(z), if ROCs are as:

Q: What is the permeability of a material that has a relative permeability of 900?

A: Relative permeability Permeability of free space

Q: Find (a)V1 and (b)V, in the circuit in the figure using nodal analysis. 1 mA (a) (b) + 8 mA V 4 ΚΩ +…

A:

Q: 4. In the circuit in figure, write the system of the mesh method and find i2. 10 2 40 V 10 WWW + Vo…

A:

Q: Determine VCE and IC in the stiff voltage divider-biased transistor circuit in the Figure below if…

A: We need to find out collector current and collector to emitter voltage for given circuit.

Q: Q-1. A 0.25 H.P., 110 volt, 60 Hz, 4-pole split - phase motor has the following constant and losses:…

A: Given data, , , , , Slip, To find outWe have to determine the stator current, power factor, output…

Q: Let x[n] be an absolutely summable signal with rational z-transform H(z). If H(z) is known to have a…

A:

Q: 4. a) Use the node-voltage method to find the branch currents ia - ie in the circuit shown in…

A: Since multiple questions have been asked, only the first one (Q4) has been solved as per Bartleby…

Q: FET amplifier

A:

Q: G(s) = G(s): |a+51|² (s+a+5i) (s+a-5i) = a s+a For a = 3, 4, 10 For a= 1, *** 8 (fixed complex part…

A: Here's a MATLAB program that will plot the step response of the given transfer function for…

Q: A generating station has 4 sections busbars. Bach section busbar has a generator connected to it of…

A: Each section busbar has a generator connected to it with a rating of 5000 KVA and a reactance of…

Q: 3) The total power delivered to a balanced Y-connected, three-phase load is 720 kW at a lagging…

A: A balanced Y-connected, three-phase load is 720 kW at a lagging power factor of 0.8. The line…

Q: 4. a) Explain why infrared imaging systems are important in the operation of military aircraft, and…

A: Fibre Optical Gyroscope:It is a gyroscope that uses the interference of light waves to measure…

Q: 3. Determine Vx and Ix: 5mA ΙΚΩ + Vx >1.8KQ2 Ix Si Ge ΙΚΩ 20 V

A:

Q: A 40 KW, 220V compound DC generator (as shown in the figure), has the given parameters: Rse = 0.03…

A: Given data, , To find outWe have to determine the load resistance, load current, armature current…

Q: 11. Find the three currents 11, 12, 13 in the circuit (Figure 9) by using Kirchhoff's rules, where…

A: A simple circuit is given we need to calculate the value of currents I1,I2,I3 for the circuit.

Q: -pot the series RC circuit in Fig. 14.7: a) Find the transfer function between the source voltage…

A: A RC low pass filter is given we need to calculate -a) Transfer function T(s)=Vo(s)/Vi(s)b) The cut…

Q: Problem 1 The 2 blocks are originally at rest. The pulleys are smooth. The coefficient of friction…

A: Given:Mass of block A mA = 100kgMass of block B mB = 200kgCoefficient of kinetic friction Slope…

Q: IInitial conditions are frequency 5 ×106 Hz and current 1.5 A A magnetic far field of an antenna has…

A: The relation between the electric field and the magnetic field is described by Maxwell's Equation.It…

Q: 2₁ Z₁ 92 Z₂ Z₂ 3 93 U₁ = 10 V 93 =j5 A Z₁ = 10 +j10 Q Ξ, =j10 Ω 2 Ξ=-j5 Ω 2₁ = ? 2₂ = ? Výsledky…

A:

Q: Find the equivalent resistance in the following circuit. 12V A B D 4Ω 15Ω 7.4Ω Μ 10.4Ω 5Ω ΕΩ 40.

A:

Q: A series generator is connected in series to a feeder having 0.522 resistance to boost the voltage.…

A: Given a series generator connected in series with feeder having resistance of The induced voltage,…

Q: Use source transformation (down to a single source) to find Vo in the circuit shown.

A: The voltage Vo needs to be calculated by using the source transformation techniques and reduce the…

Q: 1. a) IN I 2 fe Figure Qla. A half-wavelength dipole antenna and EM wave generation. In the figure…

A: To find the frequency of the sinusoidal signal for maximum efficiency in converting electrical…

Q: 1-1 ) = (¹-¹u(n − 2) if the input sign Q4] Determine the output of LTI system h(n) x(n) = 3"u(n)

A:

Q: Let us observe a car with a mass of m = 8.2300 × 10² kg and driving v = 180 km. If we observe the…

A:

Q: 1- Determine the resistance spreads for 3-bit D/A convertor for binary weighted resistor and for the…

A:

Q: For the following discrete-time signals, determine the z-transform, ROC and if they are BIBO stable…

A:

Q: /1/ A single - phase, half-wave, controlled has a source 220V at 50 HZ and is eding a load R=2002…

A: To solve this problem, we need to use the following equations:where Vm is the maximum voltage of the…

Q: Determine VA in the circuit shown. Find powers by each element. Signs are important. Kadi 2.4A P Iz…

A:

Q: What type of FET that the two channels are enhanced after applying proper voltage at the gate

A: Given Data:As per Question Explain type of FET that the two channels are enhanced after applying…

Q: 2. Reduce the block diagram shown in the figure to a single transfer function, T(s) = C(s)/R(s).…

A: In this questionWe need to determine the transfer function of the given system. We are solving this…

Q: 1- Derive the truth table for the following Logic Gates combination:

A: For the given logic circuit the truth table needs to be obtained and the same can be obtained by…

Q: Example 1: Find iD. VD1.VD2, VR If Vs- 10V and R-3.3k2. Assume D₁ is Ge and D₂ is Si. + VD1 + VD2 D₁…

A:

Q: Use the z-transform to solve the following difference equation: y[n+ 2] = 3y[n+ 1] - 2y[n], y[0] = 1…

A:

Q: X> H W- N Determine the output M of the following logic circuits according to the inputs X, Y, Z and…

A: Logic circuit,Determine the output M.

Q: Question 9: a- Use Thevenin's theorem to find the voltage and power through R₂ in the following…

A: Given data, , , To find outWe have to determine the voltage and power through ,  and the maximum…

Q: 6 V iL H +1 20 ΚΩ t=0 ic 250 mF: + VC iR 0.1 Ω .

A: Given Data:A DC RLC circuit with,Input voltage source To Find:The value of the capacitor voltage for…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.