The 2 kg physics book in figure is connected by a string to a 0.2 kg coffee cup. The book is given a push up the slope and released with a speed of 2.9 m/s. The coefficients of friction are µs =0.50 and µk =0.20. (i) How far does the book slide? (ii) At the highest point, does the book stick to the slope, or does it slide back down? 200

The 2 kg physics book in figure is connected by a string to a 0.2 kg coffee cup. The book is given a push up the slope and released with a speed of 2.9 m/s. The coefficients of friction are µs =0.50 and µk =0.20. (i) How far does the book slide? (ii) At the highest point, does the book stick to the slope, or does it slide back down? 200

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The super-container vessel in the figure has a total mass displacement of (4000) long tons. This vessel towed by a tugboat with α=20⁰ angle with horizontal. If a constant tension is applied as F= 400 kN by the tugboat, please calculate the time to bring the vessel to a speed of 2 knot from the rest. At these low speeds, please neglect the hull resistance that created by the motion. Note: (1 long tons = 1016.05 kg, 1 knot=1.151 mi/hr= 0.5144 m/s)
You are given a drone with an average chord length of 8 in., a wingspan of 2.5 ft, and a weight of 300 g. Based on figure 2, would it stay in the air at a speed of 5 m/s? (Assume ρ=1.225 kg/m3 and Nu=1.516*10-5 m^2/s)
In order to burgle a local McDonald's, the Hamburglar must climb onto the roof. To do this, a ladder of length 3.31 m and mass 21.2 kg is placed leaning against a vertical wall, as shown in the image below. There is negligible friction between the ladder and the wall, but the same is not true for the ladder and the ground: us ≠ 0 between those two surfaces. Even with that friction, the ladder will start slipping if the angle ø ladder makes relative to the ground is less than 71.0°. Assuming the ladder is uniform (so that its center of gravity is located at its geometric center), what must be the maximum static frictional force (in N) that exists between the bottom of the ladder and the ground? Explain how you solved the problem involving a ladder leaning against a wall. Be sure to state what your known and unknown quantities are, what concepts were applied, and what equations were used!
A box on a rough floor is pulled with a force of 1000N along a rope that creates an angel 25° above the horizon. The coefficient of friction is 0.40. If the box accelerates at a rate of 5m/s^2, what is the mass of the box?
3.) Automotive engineers work very hard to improve the value of the drag coefficient for cars. Suppose you have a car with a mass of 3000. kg and an effective surface area of 4.00 m^2. The engine can generate a maximum force of 28,000. N. Let the coefficient of kinetic friction be 0.200, and the coefficient of static friction be 0.400. Air has a density of 1.21 kg/m^3. (back on earth) (3a) Draw a free-body diagram for your car, including both drag and friction, when the car is moving at its maximum velocity. (3b) If the maximum value of your car's velocity is 150.0 m/s, then what is the drag coefficient for the car? (3c) Suppose your engineers change the drag coefficient to 0.300 - what would be your maximum velocity then with the same force from your engine.
A speedboat with a mass of 529 kg (including the driver) is tethered to a fixed buoy by a strong 28.3 m cable. The boat's owner loves high speed, but does not really want to go anywhere. So the owner revs up the boat's engine, makes a lot of noise, and runs the boat in circles around the buoy with the cable supplying all the necessary centripetal force. When the tension of the cable is steady at 12300 N, with what force is the boat's engine pushing the boat? Different physics textbooks treat drag force somewhat differently and use different formulas. For the present purpose, take the water's drag force on the boat to be (450 kg/m)×v2, where v denotes the boat's speed. Ignore any drag force on the cable. What is the force of the engine?
Topic: Impulse and Momentum Sand drops at a rate of 2000 kg/min from the bottom of a hopper onto a belt conveyer moving horizontally at 250 m/min. Determine the force needed to drive the conveyer, neglecting friction.
A vehicle manufacturer is considering an engine for a new sedan (CD = 0.34, Af = 22 ft2). The car is being designed to achieve a top speed of 100 mi/h on a paved surface at sea level (ρ = 0.002378 slugs/ft3) and a grade of 2%. The car currently weighs 2000 lb, but the designers initially selected an underpowered engine because they did not account for aerodynamic, grade, and rolling resistances. If 2 lb of additional vehicle weight is added for each unit of horsepower needed to overcome the neglected resistance, what will be the final weight of the car if it is to achieve the 100-mi/h top speed? What is the maximum initial acceleration this car can achieve from rest on this particular road?
If your lift to drag ratio is 15 for airline A flight and the airplane weighs 15,000-lb for L/Dmax, what’s the speed for L/Dmax at 22,500 lbs.?
A car (m = 2000kg; Cd = 0.3; Ac = 2.5m ^ 2) travels on a flat track at a speed of 100 km / h. Air: 1.2 kg / m ^ 3; u = 1.8 x 10 ^ -5 Pa.s. a) Calculate the power required to overcome the drag. How much power does a 27 km / h head wind blow? b) What is the power required to climb a ramp, with a 5º slope, at 100 km / h? Consider the absence of wind and neglect rolling friction. Tip: Start by calculating the force the engine has to exert.
A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft<, and is traveling at 90 mi/h. How much power (in ft-lb/s) is required to overcome aerodynamic drag if air density is 0.002378 slugs/ft?
A 24 kg box is being pushed across the floor by a constant force <111, 0, 0> N. The coefficient of kinetic friction for the table and box is 0.18. At t= 8 s the box is at location <16, 5, -6> m, traveling with velocity <3, 0, 0> m/s. What is its position and velocity at t= 9.2 s? What is the new velocity and new position?