The analysis of DDT in a water sample resulted to a peak area of 0.250. Calibration curve is NOT prepared since standard solutions are limited. Therefore, a 1.00 ppm DDT standard is spiked in the same water sample. This resulted to an increase in peak area. The peak area of the spiked sample is now 0.315. What is the DDT concentration in the water sample? 3.75 ppm 3.85 ppm 5.09 ppm 1.43 ppm 1.65 ppm

The analysis of DDT in a water sample resulted to a peak area of 0.250. Calibration curve is NOT prepared since standard solutions are limited. Therefore, a 1.00 ppm DDT standard is spiked in the same water sample. This resulted to an increase in peak area. The peak area of the spiked sample is now 0.315. What is the DDT concentration in the water sample? 3.75 ppm 3.85 ppm 5.09 ppm 1.43 ppm 1.65 ppm

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

ChapterA1: Evaluation Of Analytical Data

Section: Chapter Questions

Problem A1.22QAP

See similar textbooks

Similar questions

00 mL of a diprotic acid primary standard solution was accurately prepared to a concentration of 0.1431 M. Three samples of this primary standard solution were used as samples in a titration to standardize an aqueous solution of sodium hydroxide, NaOH, which would be used as a titrant. Using the following table of data for the titration of the primary standard acid with NaOH, calculate the average concentration of NaOH. Trial # Volume of primary standard Initial titrant volume Final titrant volume 1 10.00 mL 8.21 mL 27.22 mL 2 10.00 mL 27.22 mL 46.23 mL 3 10.00 mL 30.28 mL 49.29 mL 0.1506 M 0.0753 M 0.0376 M 0.1431 M 0.0526 M
Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value (ET) for the quantity being sought by writing either <, >, or = on the space provided. TOPIC: Measured mass of the precipitate 1. Overignition which causes the conversion of BaSO4 precipitate to BaO. EX _____ ET2. Precipitate was not washed thoroughly. Ex _____ ET TOPIC: Standardization of Titrant 3.Distilled water was not equilibrated to room temperature before the preparation of NaOH titrant. EX _______ ET
The water sample from the polluted estuary (number 4), was then subjected to a series ofinstrumental analysis like chromatography and spectroscopy to determine the exact identities of thepollutants. What kind of analysis are done to the unknown?a. Qualitative analysisb. Quantitative analysisc. Characterization analysisd. Fundamental analysis
SCE students measured the concentration of HCl in a solution by titrating with different indicators to find the end point.Indicator Mean HCl concentration (M)(± standard deviation)Number of measurementsBromothymol blue 0.09565 ± 0.00225 28Methyl red 0.08686 ± 0.00098 18Bromocresol green 0.08641 ± 0.00113 29Is the difference between indicators 1 and 2 significant at the 95% confidence level? Answer the same question for indicators 2 and 3
A first-stage recovery of magnesium from seawater is precipitationof Mg1OH22 with CaO:Mg2+(aq) + CaO(s) + H2O(l)---->Mg(OH)2(s) + Ca2+(aq) What mass of CaO, in grams, is needed to precipitate 1000lb of Mg(OH)2?
Calculate the concentration of A when chemical AB is dissolved in pure water. Ksp = 0.00001331 AB2(s) ⇌ A2+(aq) + 2B¯(aq) Enter answer to 3 sig figs using exponential format.
Illegal mining affected many rivers with extremely high deposits of heavy metals and particulate matter in the river of America making them unwholesome for drinking. With the help of your knowledge on analytical separation and analysis outline suitable analytical protocol that can be employed to recover polluted river bodies and make them wholesome for drinking.
A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g. Compute for the theoretical % SO3 obtained by the student and the theoretical mass (g) of SO3 that should be obtained by the student using his weighed sample
A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g.29. Compute for the mass (g) of BaSO4 from the experiment.A) 0.3933B) 0.3393C) 0.3133D) 0.3951E) 0.359130. Compute for the experimental mass (g) of SO3 in grams obtained by the student.A) 0.1439B) 0.1349C) 0.1943D) 0.1394E) 0.359131. Compute for the experimental % SO3 obtained by the student.A) 73.21B) 56.33C) 17.89D) 56.89E) 72.8032. Compute for the theoretical % SO3 obtained by the studentA) 0.3933B) 56.37C) 17.33D) 17.89E) 0.425233. Compute for the theoretical mass (g) of SO3 that should be obtained by the student…
As part of the analysis of water samples, the hardness of water is commonly measured and calculated. It is commonly expressed in ppm by mass (parts per million) of CaCO3. Parts per million is also equivalent to milligrams of CACO3 per liter of water. In a sample taken by an environmentalist, he was able to observe a hardness count of 205 mg CacO3/L. Given this hardness count of the sample, what is the molar concentration of Ca2+ ions in the water sample?
The solubility of borax, which is made up of sodium tetraborate (Na2B4O5(OH)4 8H2O), was analyzed. The dissolution of borax is: Na2B4O5(OH)4 • 8H2O(s) ⇌ 2 Na+(aq) + B4O5(OH)42–(aq) + 8 H2O(l) A 50 mL saturated solution was prepared. After filtration of solution, 5 mL aliquot was transferred to a flask and titrated using 0.432 M HCl. The endpoint was found to be 4.73 mL of the titrant. Tetraborate anion (B4O5(OH)42-) is a weak base which reacts with HCl like the following reaction: B4O5(OH)42–(aq) + 2 H+(aq) + 3 H2O(l) ⇌ 4 H3BO3(aq) What is Ksp expression for the dissolution? What is the tetraborate ions concentration in the filtrate? What is the molar solubility and Ksp of borax if the titration was done at room temperature (298 K)?
Calculate MW from Average EM. MW (g/mol) = n (eq/mole) x EM (g/eq) where n is the number of H+ ions titrated per moelcule of acid TRIAL # moles of OH- # moles of H+ # equivalents H+ Equivalent Mass (g/eq) 1 0.00264 0.00264 0.00264 113.26 2 0.003295 0.003295 0.003295 91.05 113.26 + 91.05 = 204.31/2 = 102.155 g/eq average EM Acid is Sulfamic Acid