Answered: The beam above is supported by a pin at…

The beam above is supported by a pin at A and a rocker at B. Which of the following is closest to the magnitude of the force reaction at point B?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 12.1CYU: Check Your Understanding Solve Example 12.1 by choosing the pivot at the location of the rear axle.

See similar textbooks

Related questions

Q: Consider the situation shown in Figure below. The uniform 0.60KN beam is hinged at P. Find the…

Q: Three forces F, = 20 N, F, = 10 N and F, = 5.0 N act on the structure shown in fi fourth force F, to…

Q: Compute the center of gravity of the barbell system shown. Assume that the weight of the 36-in…

Q: A uniform heavy rod AB of length L and weight W is hinged at A and tied to a weight W, by a string…

A: If any system is in equilibrium, the net force as well as net torque on it is always zero. Torque is…

Q: As shown in the figure below, a uniform beam is supported by a cable at one end and the force of…

A: Given: Length of beam, L = 3.25 m coefficient of static friction, μs = 0.4 angle the cable makes…

Q: Suspend the meter stick on a pin through the hole at the 25 cm mark. Add weights on the string at…

A: Let’s first determine the average mass of the meter stick (ms) from the given data.

Q: The figure below shows an outstretched arm (0.61 m in length) that is parallel to the floor. The arm…

Q: A weight of 55 N is located a distance of 18 cm from the fulcrum of a balance beam. How far away…

Q: The topic is torque A uniform horizontal beam is attached to a wall by a pin connection that allows…

A: Let the Tension be T Weight of beam (Wb) = Mg Wb = 35.7×10 =357 N Weight of the person (Wp) = mg=600…

Q: A beam AB is attached to a rocker at A and a pin at B. it is subjected to three forces as shown in…

A: Need to calculate the vertical component of reaction at pin B.

Q: The meterstick weighs 10N. If a rock hangs on one end and the whole system is balanced at the 20 cm…

Q: A weightlifter is holding a 50.0-lb weight (equivalent to 222.4 N) with his forearm, as shown in…

A: Note: figure is not attached to the question so, forearm length was assumed to be…

Q: A 60kg student stands on a very light rigid board that rests on a bathroom scale at each end as…

A: Given data: Mass of the student is, m = 60 kg Length of the board is, L= 2 m Position of the student…

Q: A post with a horizontal and inclined member supports a box whose weight is P, as shown in the…

Q: A store's sign has a mass of 20 kg and is 3.0 m long. It is uniform, so its center of gravity is at…

A: Draw the free-body diagram of the system.

Q: If a pivot point of a scale is located one quarter the length of the scale with 50.0 kg rest on the…

A: Given Let the length of the scale be L mass on short side m = 50 kg

Q: Assume a person bends forward to lift a load “with his back” as shown. The spine pivots mainly at…

Q: Auniform rod 1 m long with weight 6 N can be supported in a hortzontal its ends. What is the…

A: Draw the free-body diagram of the system. Here, x denotes the position of the balance.

Q: Approximately what magnitude force, FM, must the extensor muscle in the upper arm exert on the lower…

Q: 30.0/ 60.0°

A: Given data: In the given problem uniform rod is in equilibrium on frictionless support. Formula…

Q: a vertical rod is hinged at its lower end and attached to a cable at its upper end.A horizontal…

Q: Is the net torque changed when a partner on a seesaw stands or hangs from her end instead of…

A: No, if one simply hangs or stands, the force on the lever arm does not change. As, torque stands for…

Q: Consider a bar, of length 4.5 m, shown in the figure, being acted on by trained to rotate about it's…

A: The length of the bar is L = 4.5 m and the three forces act on the bar is given as The magnitude…

Q: A 49.5-kg, 6.17-m long beam is supported by, but not attached to, the two posts as shown below. A…

A: Given Length of the beam = 6.17 m Weight of the beam = 49.5 kg Weight of the boy = 23.4 kg We have…

Q: For the system of pulleys shown, determine the ratio of W to P to maintain equilibrium. Neglect axle…

Q: A person with 100kg mass is standing erect on the tip of both feet. Find the contact force Cexerted…

A: Given that :m=100 kgg=9.8 m/s2θ=37°

Q: Imagine a see-saw. On one side, there is a person with itting 3.5m away from the pivot. On the other…

A: Given values:- Weight of first-person,(W1)=700 N -----(1) (Sitting 3.5 m away from pivot) Weight of…

Q: A uniform beam of weight 12 N and length 10 m is mounted by a small hinge on a wall. The beam is…

Q: A weight of 30 N is located a distance of 10 cm from the fulcrum of a balance beam. At what distance…

Q: A bar has four forces, exerted on it, as shown. What is the sign of the torque shown. 3F 3F F аxis…

A: Given: Four forces are given

Q: The horizontal beam in the figure weighs 150 N, and its center of gravity is at its center. Find the…

A: Given: Weight of beam, wb = 150 N Length of beam, l = 4 m Weight of object, wo = 300 N Let 'T' be…

Q: The cantilevered W530x 150 beam shown is subjected to a 5.6-kN force Fapplied by means of a welded…

A: As per guidelines we are suppose to do only one question from multiple questions, kindly post the…

Q: Auniform rod 1 m long with weight 6 N can be supported in a hortzontal its ends. What is the…

A: Note:- We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: gymnast with mass 55.0 kg stands on the end of a uniform balance beam as shown in the figure below.…

A: Given data as per question m= 55kg M =250kg L =5m

Q: A 5.0-m weightless strut, hinged to a wall, is used to support an 650-N block as shown. The vertical…

A: The weightless strut is hinged to wall and supporting the 650 N block. Where FH = F Sinθ…

Q: The cg of the pole held by the pole vaulter is 2.00 m from the left hand, and the hands are 0.700 m…

A: Given:- The cg of the pole held by the pole vaulter is 2.00 m from the left hand,…

Q: ne system of knotted cords shown in the figure below supports the indicated weight. Compute for the…

Q: At what distance from the fulcrum should a 20 N weight be placed to balance the system?

A: A beam is placed evenly on pivot point(fulcrum) On one side a 50N weight is placed 20cm from the…

Q: An 8 m long uniform seesaw of 20 kg mass is supported at P by a 50 kg student at one end, an 80 kg…

Q: A uniform rod of length 3m and weight 100N with ends A and B resting on two brackets and bearing 50N…

A: For equilibrium net force as well as net torque acting on the system must be zero.

Q: The figure below shows an outstretched arm (0.61 m in length) that is parallel to the floor. The arm…

Q: A bean of wood with negligible mass and the lenght 5.0 m is placed on a tirangular support. A mass…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

1.5 kN
400 N/m
В
4
A
3 m
3 m
The beam above is supported by a pin at A and a rocker at B.
Which of the following is closest to the magnitude of the force reaction at point B?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Men are opening a 1,250-kg, 1.75m-wide door (with well-lubricated hinges) by applying to its edge a combined force of 250N perpendicular to the door. How much time does it take to open the door through a 90-degree angle?
The cg of the pole held by the pole vaulter is 2.00 m from the left hand, and the hands are 0.700 m apart. Calculate the force exerted by (a) his right hand and (b) his left hand. (c) If each hand supports half the weight of the pole in Figure 9.18, show that the second condition for equilibrium is satisfied for a pivot other than the one located at the center of gravity of the pole. Explicitly show how you follow the steps in the Problem-Solving Strategy for static equilibrium described above.
The uniform bars AB and BC are connected with a pin at B and placed on a horizontal surface. The coefficient of static friction between the bars and the surface is μs = 0.85. Can the bars be in equilibrium in the position shown?
A uniform beam of weight 39 N and length 6.0 m is mounted by a small hinge on a wall at it left end. The beam is held in a horizontal position by a vertical rope at the location as shown. What is the magnitude of the tension force in the rope, in Newtons?
Determine the magnitude of force P about the hinge reaction at A for the equilibrium position of the bar AB. Take the length of the bar as 10 m.
A uniform rod of weight mg and length L is in equilibrium on frictionless support as shown in the above figure. Find θ.
A 65 kg diver stands at the end of a 29 kg springboard, as shown in the figure. The board is attached to a hinge at the left end but simply rests on the right support. What is the magnitude of the vertical force exerted by the hinge on the board?
A 60 kg diver stands at the end of a 30 kg springboard, as shown. The board is attached to a hinge at the left end but simply rests on the right support. What is the magnitude of the vertical force exerted by the hinge on the board?
In Figure 9.21, the cg of the pole held by the pole vaulter is 2.00 m from the left hand, and the hands are 0.700 m apart. Calculate the force exerted by (a) his right hand and (b) his left hand. (c) If each hand supports half the weight of the pole in Figure 9.19, show that the second condition for equilibrium (net =0 ) is satisfied for a pivot other than the one located at the center of gravity of the pole. Explicitly show how you follow the steps in the Problem-Solving Strategy for static equilibrium described above. Figure 9.21 A pole vaulter is holding a pole horizontally with both hands. The center of gravity is to the left side of the vaulter.
In the What If? section of Example 12.2, let d represent the distance in meters between the person and the hinge at the left end of the beam. (a) Show that the cable tension is given by T = 93.9d + 125, with T in newtons. (b) Show that the direction angle of the hinge force is described by tan=(323d+41)tan53.0 (c) Show that the magnitude of the hinge force is given by R=8.82103d29.65104d+4.96105 (d) Describe how the changes in T, , and R as d increases differ from one another.
The upper leg muscle (quadriceps) exerts a force of 1250 N, which is carried by a tendon over the kneecap (the patella) at the angles shown in Figure 9.38. Find the direction and magnitude of the force exerted by the kneecap on the upper leg bone (the femur). Figure 9.38 The knee joint works like a hinge to bend and straighten the lower leg. It permits a person to sit, stand, and pivot.
A 27.8 ft long board, whose weight is 14.9 lbs, is supported from below on each end. A 244.4 lb person is standing 10.8 ft from the left end. What is the support force (in pounds) applied to the board from the left support?