The block shown is pulled across the roughhorizontal surface at a constant speed bythe force shown. If m=5 kg, F=11, and 0 =37°, what is the coefficient of kinetic frictionbetween the block and the surface? considerg = 10 m/s?.mA. 0.3025B. 0.3525C. NoneD. 0.4025

Name: The block shown is pulled across the roughhorizontal surface at a con
Uploaded: 2024-03-20T06:57:25.000Z
Channel: Bartleby
Description: The block shown is pulled across the roughhorizontal surface at a constant speed bythe force shown. If m=5 kg, F=11, and 0 =37°, what is the coefficient of kinetic frictionbetween the block and the surface? considerg = 10 m/s?.mA. 0.3025B. 0.3525C.

Answered: Image /qna-images/answer/1a3bde8f-cac0-4afa-a781-efff697b5a0c.jpg

Science

Physics

The block shown is pulled across the rough horizontal surface at a constant speed by the force shown. If m=5 kg, F=11, and e = 37°, what is the coefficient of kinetic friction between the block and the surface? consider g = 10 m/s?. m A. 0.3025 B. 0.3525 C. None D. 0.4025

The block shown is pulled across the rough horizontal surface at a constant speed by the force shown. If m=5 kg, F=11, and e = 37°, what is the coefficient of kinetic friction between the block and the surface? consider g = 10 m/s?. m A. 0.3025 B. 0.3525 C. None D. 0.4025

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section5.3: Forces In Two Dimensions

Problem 39PP

See similar textbooks

Similar questions

J.D. runs on a treadmill and his VO2 is measured to be 45 ml/kg/min at a 4% grade. What is his running speed in meters/min and mph?
Sam, whose mass is 74.0 kg, takes off across level snow on his jet-powered skis. The skis have a thrust of 220.0 N and a coefficient of kinetic friction wtih the snow of 0.07. Unfortunately, the skis run out of fuel after only 11.5 seconds. What Sam's top speed (in m/s) assuming that the acceleration due to gravity is 9.80 m/s2? How far (in m) has Sam traveled when he finally coasts to a stop?
A 15 kg box is initially sliding across a frictionless floor with a constant speed of 2.5 m/s.Then, the box encounters a rough surface and travels for 12 meters before coming to astop. What is the coefficient of kinetic friction between the box and rough surface?
A 800kg car and driver accelerates at rate of 35 m/s/s. What force is necessary to bring the car to a complete stop?
How much force is needed to accelerate a 10.0kg sled along a frictionless surface at 1.5 m/s2?
A 3kg block is acted on by a 25-N force that acts 37 degree from the horizontal. The kinetic of coefficient friction is 0.2. What is the acceleration of the block?KINDLY ANSWER PLS WITH COMPLETE SOLUTION
Il a 45 kg skater is moving at 17.1 m/s when he starts up a hill, how high will he go before he stops?
A 197N sled is pulled up a 32 degree slope at a constant speed by a force of 172N. What is the coefficient of kinetic friction between sled and slope? Gravity is 9.8ms and please round to 3 decimal places.
We tie an 80 cm long rubber cord to the ceiling and attach a 50 g weight o its other end. The cord gets extended by 4.0 cm. We raise the weight to the ceiling and let it down. What is the force of the string, when the weight reaches its lowest point?
A 20-Mg train is traveling at a speed of 50 m/s at an angle of 10o. But the driver noticed that the bridge 300-m ahead is missing. At once, he pulls the break, thus applying a frictional resistance of Ff = 1000 N. At the same time Super Botting pushes back the train with a force of Fs=(123)d +100, where d is the distance that the train travels before stopping. Determine the stopping distance d, and mention whether or not Superperson would be able to save the train.
A 5kg block is pulled westward across a frictionless horizontal surface by a 30 N force applied at 87° angle above the horizontal. What is the block’s acceleration?
What happens to the motion of the object when there is very little friction present? What did the surface look like? (hint: think: Ffr = ?Fn) What happens to the motion of the object when there is lots of friction present? What did the surface look like? What happens to the motion of the object when there is no friction present What did the surface look like?