Answered: The Capacitor is dead immediately after…

Engineering

Electrical Engineering

The Capacitor is dead immediately after it is disconnected from the line. PR Select one: True False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.32MCQ

See similar textbooks

Related questions

Q: Calculate the capacitive reactance of a 38 µF capacitor when connected to a 240 V, 48 Hz supply. Xc=

A: Find the capacitive Reactance of the system?

Q: The maximum value of mutual inductance of two inductively coupled coils with self inductance of L₁ =…

A: Given: Self inductance, L1=36 mH Self inductance, L2=9 mH

Q: A dielectric slab of Teflon ( x=2.1 is inserted between the plates of a parallel-plate capacitor…

A: In the question, Dialectic slab = 2.1 Parallel plat A= 2.3cm2 Separation distance d= 0.03cm Find…

Q: A 100 µF capacitor rated for 400 V, 50 Hz has tan ō = 0.01. What will be the rated dielectric loss?

A: Given, Capacitance, C = 100 μF Rated voltage, V=400 V Frequency, f = 50 Hz tanδ=0.01 Where δ is…

Q: Coupling Capacitors are used to prevent High Frequency Low Power Communication Signals leaking into…

A: We need to tell about the given statement is true or false.

Q: What is the capacitance of a capacitor with 8.5 m² plates cross-sectional area and 0.02 m apart in…

Q: The relative dielectric constant is given as 2.5. The inside and outside radiuses are 0.5 mm and 2.5…

A: Need to find range of capacity

Q: Time left C Question 18 A 50 Q distortion less transmission line has a capacitance of 10 10 F/m.…

A: Step 1 Inductance: It is a property of a circuit that tells when a change in current in the circuit…

Q: Capacitance is directly proportional to the dielectric constant and the distance between its plates…

A: Need to find true false for the given capacitance statement

Q: An impedance coil having a resistance of 25 ohms and an inductance of 20 mH is connected in parallel…

A: The solution is given below

Q: Find i) Total number of coils i) Turns per coil i) Commutator pitch

A: Number of Poles P=4. Number of Slots S=31 Number of Coils per slots =4 Number of Conductors =496…

Q: Problem 9. A parallel plate capacitor has nineteen interleaved plates each 75 mm by 75 mm separated…

Q: 10.55 Determine the steady-state voltage across each capacitor and the amount of charge stored in…

A: According to question:

Q: PR1 + REF1 V 2 R1 V1 1k2 | 2V 1kHz 0° С1 REF1 1000F 1. (+

Q: 7) The following readings are obtained in the measurement of an inductor: 1.003,0.998, 1.001, 0.991,…

Q: The capacitance of a parallel plate capacitor is inversely proportional to area of the plate.(TRUE…

A: As from formula of capacitance, C=εoAdC∝A Where, A is area and d is distance between two plates.…

Q: The capacitive reactance of a capacitor is 5555 ohm. What will be the frequency of the input ac…

A: The reactance of a capacitor of capacitance C F can be expressed as

Q: An inductor L is connected in parallel to the series combination of capacitor C and resistor R. If L…

Q: A parallel plate capacitor has 19 interleaved plates each 75 mm by 75 mm separated by 18 mica sheets…

Q: In distribution systems, fixed capacitors are usually sized for minimum base-load conditions. Select…

A: Distribution system

Q: A capacitor has a capacitive reactance of 50 Ω when connected to a 60-Hz line. What will be the…

A: Capacitive reactance of a capacitor is given by the following equation Xc = 12πfCwhere,f=…

Q: Capacitance is directly proportional to the area of the plates and inversely proportional to the…

A: Capacitance, C = εAd where, ε is the absolute permittivity of the dielectric material used A is the…

Q: Given a parallel combination of a 1mF, 2mF and 4mF capacitor operated at a frequency of 20 kHz, find…

A: In this question we will find total admittance of parallel capacitors...

Q: The transient response of a second order system is given below, for 5% * criterion the settling time…

A: General second order step response equation is c(t)=1-e-ℰωnt/√(1-ℰ²) ×sin(ωdt+φ) Given second order…

Q: Coupling Capacitors are used to prevent High Frequency Low Power Communication Signals leaking into…

A: In this question we need to verify the given statement is true or false

Q: Plate area A of a parallel plate capacitor, the distance between them d and the current through…

A: Plate area A of a parallel plate capacitor, the distance between them d the current through their…

Q: Find the equivalent inductance in the given circuit, where each L = 10 H and L1 = 37 H

A: If two inductors are connected in parallel than equivalant inductance is (L1×L2)/(L1+L2) If they are…

Q: Vc(0)= 13.3V a. When A1 switch is closed, the capacitor is charged to 32V. Calculate the duration…

A: If Vc(0)= 13.3V a. When A1 switch is closed, the capacitor is charged to 32V. Calculate the duration…

Q: Derive the following law RE Z; = 1 (RE + RC)] RF

A: Draw the AC equivalent circuit: From the figure, the output current is, I0=I'+βIb and the output…

Q: The Capacitor is dead immediately after it is disconnected from the line. Select one: O True O False

A: the capacitor is dead immediately after it is disconnected from the line to statement whether the…

Q: Calculate the capacitance of a capacitor made of 21 circular plates separated by sheets of mica…

Q: In your own words what’s the difference between inductance and inductor

A: Inductance is the property of an electric circuit by which a voltage is induced in it by a changing…

Q: 6.2.1 The voltage across a capacitor with 56 uF capacitance has energy function 13. cos- (a · t) J,…

Q: Capacitor Banks that can be used to simulate the Load is provided in the Distribution Line…

A: Yes. Capacitor Banks that can be used to simulate the Load is provided in the Distribution Line…

Q: resistor of 100 Ω, a coil of 4.50 μH, and a capacitor of 220 pF are in parallel. What is the…

A: We need to calculate admittance for given parallel RLC circuit .

Q: Using Root Locus method, transient response of a system can be determined directly. Select one: True…

A: Root locus is used to determine nature of roots and stability analysis not for transient response

Q: Determine the capacitor voltage at t = 2 ms

A: Using KVL and KCL we will find diffrential equation relating capacitor voltage. Using diffrential…

Q: Calculate the frequency at which a 2.2µF capacitor and a 8.7mH inductor have the same value of…

Q: A coil of inductance 159,3mH and resistance 40 ohms is connected in parallel with a 30 microfarad…

A: inductive reactance=2×π×f×L capacitive reactance=12×π×f×C. current=Voltageimpedance. We will apply…

Q: in your own words what is the definitions of the following : 1. Capacitor 2. Electric field 3.…

A: As per Bartleby policy we can answer only three sub parts, as you not mentioned so I am solving…

Q: A capacitor has a reactance of 80 ohms when connected to a 50 Hz supply. Calculate the value of…

Q: 1. Calculate the phase angle difference for each capacitor value capacitance, C = 0.33 µF, 1µF and…

A: Given table,

Q: Problem 5.3 Find the total inductance of the circuit shown.

Q: Q) A source of 10 V and frequency 1000 KHz with internal resistance of 10 Q is connected to the…

A: Given data : Source voltage V= 10V f=1000 KHz Internal resistance = 10 Ω Capacitance (C) =0.001μF…

Q: The reactance X of capacitance =jwc O True False

A: We need to tell about whether the given statement is true or false

Q: Consider the following system , plot the root locus with all details and find the value of K for…

A: Root Locus-The root locus is the graphical location of roots of the characteristic equation as the…

Q: supply. · Capacit alculate (a) the equivalent circuit capacitance, (b) the charge on each capacitor…

Q: A capacitor of capacitance 120 µF is connected across a 220 V, 60 Hz A.C. mains. Calculate the value…

A: 22)

Q: Draw a phasor diagram showing the following parameters after the capacitor is inserted (calculate…

A: Given:VS=120 Vf=60 HzRated power, P=1.2 kW

Q: T =Pi = RC, Calculate The Ratio Q/Q_0 During Discharging Of A Capacitor. Show Your Calculation.

Concept explainers

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.

Question

The Capacitor is dead immediately after it
is disconnected from the line.
Select one:
True
Oo False
• A:MV

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In series reactive power compensation, the series capacitors are not used to increase the capabilities of transmission lines. Select one: True False
A cable has inductance of 0.22 mH per km and capacitance of 0.202 microF per km. The surge impedance of the cable is ?
Determine: re, Zi, Zo, Av (use appropriate approximation)
A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.
Solve for the admittance, Yab, of the circuit shown. (magnitude only)
Use nodal analysis to solve the circuit complete soolution
LTI SYSTEM FREQUENCY RESPONSE ( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
3. A transmission line has a capacitance of 0.1 μF per phase. Determine the inductance of Peterson coilto neutralize the effect of capacitance of (i) complete length of the line, (ii) 97% of the line, (iii) 90%length of the line. The supply frequency is 50 Hz. [(i) 33.80H (ii) 34.84H (iii) 37.55H]
A single circuit three phase 50 Hz, 55 km transmission line consists of three conductors arranged in triangle. d1=5m, d2=9 m and d3=19 m. The radius is 0.7 cm. Calculate a) GMD b) Inductance per km c) Total Inductance and d) Inductive reactance.
Q12) Three identical capacitors are connected in Delta to a 415V, 50Hz, 3-phase supply. If the line current is 15A, calculate the Capacitance of the each capacitor. a. 66.45 µF b. 79.5 F c. 66.45 F d. 50.42 µF
In a single-phase transmission line circuit, three 0.25 It consists of a conductor with a radius of cm (a, b, c). The return circuit likewise consists of three parts of the same radius. consists of two conductors (d, e, f). of conductors placement is given. of each conductor Calculate the inductance and the total inductance.
The total capacitance and inductance are C=2x10^(-6) F and L=3x10^(-6) H. The physical length of the line is 900 m. (up to 4 decimal places) >time delay t_d >velocity factor k >velocity of propagation v_p in m/s using the distributed parameters >velocity of propagation v_p in m/s using the relative dielectric constant.