The chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension T₁ is 2.3 kN when 8 -29°, determine the force P required on the lever and the corresponding tension T₂ for this position. Assume that the surface under A is perfectly smooth. Assume a - 100 mm, b-550 mm. Custom T₁ B Answers: P- i T₂- i kN kN مام T₂

The chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension T₁ is 2.3 kN when 8 -29°, determine the force P required on the lever and the corresponding tension T₂ for this position. Assume that the surface under A is perfectly smooth. Assume a - 100 mm, b-550 mm. Custom T₁ B Answers: P- i T₂- i kN kN مام T₂

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Similar questions

The chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension T1 is 2.6 kN when θ = 22°, determine the force P required on the lever and the corresponding tension T2 for this position. Assume that the surface under A is perfectly smooth.Assume a = 110 mm, b = 430 mm.
A 17 kg block rests on a 32 degree inclined frictionless surface and is attached by a light string to a 34 kg hanging mass where the string passes over a massless frictionless pulley. If g = 9.8 m/s^2 what is the tension in the connecting string?
The weight of the box is W = 90 N and the coefficient of static friction between the box and the floor is μ=0.65. Neglect the weights of the bars. What is the largest value of the force F that will not cause the box to slip?
Determine the tension in the rope AC and BC ( take g=10 m/s^2)
The drawing below shows a person whose weight is W = 603 N doing push-ups. Assume L1 = 0.880 m and L2 = 0.435 m. Calculate the normal force exerted by the floor on each hand, assuming that the person holds this position.
A tutor told me that the answer to 1b was 10N but I don't understand why it would be 10N for the tension. If that is correct could someone break it down for me?
The distance between two telephone poles is d = 54.0 m. When a 1.20 kg bird lands on the telephone wire midway between the poles, the wire sags h = 0.206 m. How much tension (in N) does the bird produce in the wire? Ignore the weight of the wire
A small mass, m = 200 grams, hangs vertically from a thin cable that is attached firmly to the ceiling. The thin cable has negligible mass. Calculate the magnitude of the tension, T, in the cable. Also, state the direction of the tension in the cable. T = 1.96 N, acting downward. T = 19.6 N, acting downward. T = 1.96 N, acting upward. T = 19.6 N, acting upward.
The box B weighs 50 lb. The coefficients of friction between the cable and the fixed round supports are μs= 0.40 and μk= 0.30. What is the minimum force F required to support the box? What force F is required to move the box upward at a constant rate?
A 110 kg scaffold is 5.80 m long. It is hanging with two wires, one from each end. A 420 kg box sits 1.90 m from theleft end. What is the tension in the right hand side wire? (g = 9.8 m/s2) please show the full solution, thank you.
The coefficient of static friction between the block and the sloping plane is 0.38, and the coefficient of friction between the rope and the fixed cylindrical shaft is 0.11. Determine the range of values of P in newtons for which the 68 kg block does not move. (Enter the magnitude. Max force - Min force -
A 10 m uniform rope of 100 N is supported at two ends. A person (400 N) sits 2 m from the left side. What is the tension on the right side?