The circuit shown in the figure below is connected for 3.30 min. (Assume R, = 8.80 2, R, = 1.80 0, and V = 15.0 V.)5.00 Ω 3.00 ΩR231.00 NR4.00 V(a) Determine the current in each branch of the circuit.branchmagnitude (A)directionleft branch0.8818downmiddle branch0.6266downright branch1.5084up(b) Find the energy delivered by each battery.0.49624.00 V batteryIf you know the current through a battery, how do you determine the power delivered by the battery? J15.0 V battery 4.4799kJ(c) Find the energy delivered to each resistor.8.80 Ω resistor5.00 2 resistor1.00 0 resistor3.00 2 resistor1.80 Ω resistor

The circuit diagram and the current flowing through the branches is given . To find = a) energy…

The circuit shown in the figure below is connected for 3.30 min. (Assume R, = 8.80 N, R, = 1.80 N, and V = 15.0 V.) 5.00 Ω 3.00 Ω R2 1.00 N R| 4.00 V (a) Determine the current in each branch of the circuit. branch magnitude (A) direction left branch 0.8818 down middle branch||0.6266 down right branch 5084 up (b) Find the energy delivered by each battery. 0.4962 4.00 V battery If you know the current through a battery, how do you determine the power delivered by the battery? J 15.0 V battery 4.4799 V kJ (c) Find the energy delivered to each resistor. 8.80 Q resistor 5.00 N resistor 1.00 N resistor 3.00 N resistor 1.80 N resistor

The circuit shown in the figure below is connected for 3.30 min. (Assume R, = 8.80 N, R, = 1.80 N, and V = 15.0 V.) 5.00 Ω 3.00 Ω R2 1.00 N R| 4.00 V (a) Determine the current in each branch of the circuit. branch magnitude (A) direction left branch 0.8818 down middle branch||0.6266 down right branch 5084 up (b) Find the energy delivered by each battery. 0.4962 4.00 V battery If you know the current through a battery, how do you determine the power delivered by the battery? J 15.0 V battery 4.4799 V kJ (c) Find the energy delivered to each resistor. 8.80 Q resistor 5.00 N resistor 1.00 N resistor 3.00 N resistor 1.80 N resistor

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 53P: For the circuit shown below, =20V , L = 4.0 mH, and R = 5.0 . After steady state is reached with S1...

See similar textbooks

Similar questions

The switch is closed in Figure 18.20. After a long time compared with the time constant, of the circuit, what will the current be in the 2- resistor? (a) 4 A (b) 3 A (c) 2 A (d) 1 A (c) More information is needed. Figure 18.20 (Quick Quiz 18.9)
When the switch is open in Figure 18.8, power Po is delivered to the resistor R1. When the switch is closed, which of the following is true about the power Pc delivered to R1? (Neglect the internal resistance of the battery.) (a) Pc Po (b) Pc = Po (c) Pc Po Figure 18.8 (Quick Quizzes 18.5 and 18.6)
Find the direction of the current in the resistor shown in Figure P20.16 (a) at the instant the switch is closed, (b) after the switch has been closed for several minutes, and (c) at the instant the switch is opened. Figure P20.16
When the switch is open in Figure 18.8, power Po is delivered to the resistor R1. When the switch is closed, which of the following is true about the power Pc delivered to R1? (Neglect the internal resistance of the battery.) (a) Pc Po (b) Pc = Po (c) Pc Po Figure 18.8 (Quick Quizzes 18.5 and 18.6)
For the circuit shown below, =20V , L = 4.0 mH, and R = 5.0 . After steady state is reached with S1 closed and S2 open, S2 is closed and immediately thereafter (at t = 0) S1 is opened. Determine (a) the current through L at t = 0, (b) the current through L at r = 4.0 x 10-4 s, and (c) the voltages across L and R at t = 4.0 x 10-4 s.
Integrated Concepts (a) What energy is dissipated by a lightning bolt having a 20,000-A current, a voltage of 1.00102 MV, and a length of 1.00 ms? (b) What mass of tree sap could be raised from 18.0°C to its boiling point and then evaporated by this energy, assuming sap has the same thermal characteristics as water?
With the switch in the circuit of Figure 21.18a open, there is no current in R2. There is current in R1, however, and it is measured with the ammeter at the right side of the circuit. If the switch is closed (Fig. 21.18b), there is current in R2. What happens to the reading on the ammeter when the switch is closed? (a) The reading increases. (b) The reading decreases. (c) The reading does not change.
Integrated Concepts (a) Assuming 95.0% efficiency for the conversion of electrical power by the motor, what current must the 12.0-V batteries of a 750-kg electric car be able to supply: (a) To accelerate from rest to 25.0 m/s in 1.00 min? (b) To climb a 2.00 102-m- high hill in 2.00 min at a constant 25.0-m/s speed while exerting 5.00 102 N of force to overcome air resistance and friction? (c) To travel at a constant 25.0-m/s speed, exerting a 5.00 102 N force to overcome air resistance and friction? See Figure 20.44.
If the battery in the circuit below is 7.16V, resistor R1=331.15ΩΩ, and resistor R2=51.49ΩΩ, what is the magnitude of the current flowing through the circuit? Please give your answer in units of milli-Amps (mA).
In the accompanying figure, the rails, connecting end piece, and rod all have a resistance per unit length of 2.0 Ω/cm. The rod moves to the left at v = 3.0 m/s. If B = 0.75 T everywhere in the region, what is the current in the circuit (a) when a = 8.0 cm? (b) when a = 5.0 cm? Specify also the sense of the current flow.
In the circuit shown, R1 = 5 Ω ,R2 = 10 Ω , and R3 = 15 Ω, and ε1 = 10 V, and ε2 = 15 V. Using Kirchhoff's loop and junction laws, determine the currents I1, I2, and I3 flowing through R1, R2, and R3, respectively, where the direction of each current is as indicated in the figure.
Given a double-loop circuit above, with emfs B1 = 49.09V, B2 = 31.31V, and resistors R1 = 49.41Ω, R2 = 18.36Ω and R3 = 53.45Ω, The values of currents I1, I2 and I3 are ?