The current in an RL circuit increases to 98 % ofits final value 2.29 s after the switch is closed.Part AWhat is the time constant for this circuit?T =SubmitPart BR =VOSubmitΑΣΦSymbolsRequest AnswerIf the inductance in the circuit is 0.292 H, what is the resistance?VE ΑΣΦRequest Apower?****S?

Answered: Image /qna-images/answer/3d591a93-32d6-464f-993d-d8926b943974.jpg

The current in an RL circuit increases to 98 % of its final value 2.29 s after the switch is closed. Part A What is the time constant for this circuit? T= Submit Part B 15. ΑΣΦ Symbols Request Answer ? S If the inductance in the circuit is 0.292 H, what is the resistance?

The current in an RL circuit increases to 98 % of its final value 2.29 s after the switch is closed. Part A What is the time constant for this circuit? T= Submit Part B 15. ΑΣΦ Symbols Request Answer ? S If the inductance in the circuit is 0.292 H, what is the resistance?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 12CQ: When the current in the RL circuit of Figure 14.12(b) reaches its final value /R, what is the...

See similar textbooks

Related questions

Q: Batteries are rated in terms of ampere-hours (A h). For example, a battery that can produce a…

A: GivenVoltage Ampere rated

Q: A crate with a mass of m=254kg rests on the horizontal deck of a ship. The coefficient of static…

A: The objective of the question is to find the minimum force required to get the block moving from…

Q: An electric current in a conductor varies with time according to the expression I(t) = 90 sin…

Q: 1. A 46.5-V battery and resistor 1, R₁ (21 −2) and R₂ (93-) are connected in series. Calculate the…

Q: Shown in the following figure is a long, straight wire and a single-turn rectangular loop, both of…

Q: What are the largest and smallest resistances you can obtain by connecting a 36 , a 55 , and a 2902…

A: Rmax=381Ω Rmin=20.23ΩExplanation:Step 1:Step 2:

Q: A hemispherical surface of radius b = 16.5m is fixed in a uniform electric field of magnitude E0 =…

Q: Pls help ASAP and show all work

A: A. if she takes the shortest path( a straight line), the time taken will be at the leastB. During…

Q: A box is given a push so that it slides across the floor. Part A How far will it go, given that the…

A: Note:- The kinetic force of friction acts in the direction opposite to the motion of box. Therefore,…

Q: A proton enters the uniform electric field produced by the two charged plates shown below. The…

Q: Problem 3: Suppose the aqueous humor in a person's eye exerts a force of 0.28 N on the 1.35-cm² area…

Q: A ring of diameter 18 cm straddles a number line at x=0 cm such that the number line runs straight…

Q: A block and sphere are connected by a cord that passes over a pulley as shown. Neglect friction and…

A: The objective of the question is to find the minimum value of the coefficient of static friction μ…

Q: A person is running a temperature of 39.6°C. What is the equivalent temperature on the Fahrenheit…

A: Temperature is Find:The equivalent temperature on Fahrenheit scale.

Q: Bob has just finished climbing a sheer cliff above a level beach and wants to figure out how high he…

Q: 6.00 με 150 μ.. -2.00 μ. 3.00 cm - 2.00 cm Figure P15.10 Problems 10 and 18.

Q: What is the electric potential at the point on the axis which is at z = 3.60 m. The length of the…

A: 3.972 VExplanation:

Q: In a standard room, the lowest frequency in the audible range is ___Hz. What are the lengths of the…

Q: On a particular day, the following appliances are used for the times indicated: a 1600-W coffee…

Q: There are two blocks, masses m₁ and m2, attached by a taut, massless string on a frictionless table…

Q: Suppose you are standing on a train accelerating at 0.23 g Part A What minimum coefficient of static…

Q: When an ideal gas is compressed isothermally Scegli un'alternativa: A. heat flows into the gas. OB.…

Q: 1. A block of iron with a mass of 2.00 kg is initially at a temperature of 600° C. It is dropped…

Q: A lab tech builds a circuit as shown in the figure. Find the following. (Assume C₁ = 34.0 μF and C₂…

Q: 7. Suppose the net force acting on a body of mass ? along the x-axis is given as a function of its…

A: The objective of the question is to derive the position of the particle as a function of time and to…

Q: The height of the Eiffel tower is 324 m, and let's assume it's made completely of steel, which has a…

Q: A parallel-plate capacitor has the capacitance of C₁ = 10 µF when the distance of the two plates is…

Q: A fully ionised lithium atom with charge Q = 3e enters a region where there exists a vertical…

Q: The distance traveled (approximate) in the first fifty seconds.

Q: Two identical concrete slabs lie flat and in contact with each other as shown in the figure. If the…

Q: How many half-lives would have to elapse for a sample of a radioactive isotope to decrease from an…

A: No = 192 cpmN = 3 cpm

Q: A crate is given an initial speed of 3.3 m/s up the 30 plane shown in the figure(Figure 1). Assume μ…

Q: Suppose you observe a tight eclipsing binary with orbital period of 3 days, and radial velocity…

A: 1. Suppose you observe a tight eclipsing binary with orbital period of 3 days, and radial velocity…

Q: A 48 – V battery and resistor 1, R₁, 26.5 – and R₂, 91 - are connected in parallel. Calculate the…

Q: 345 nm light incident on a 0.364-mm wide single slit produces a vertically-oriented diffraction…

Q: A periodic wave has a frequency of 2.8 Hz. What is the wave period?

Q: You are watching a National Geographic Special on television. One segment of program is about archer…

A: Initial speed is The vertical height is Note:Find:The launch angle.

Q: Forces of F1 = 1150 N, F2 = 875 N, and F3 = 1450 N are applied at the same point. The angle between…

Q: A dog in an open field runs 12.0 m east and then 30.0 m in a direction 48.0° west of north. Part A…

A: The objective of this question is to find the direction and distance the dog must run to end up 10.0…

Q: Figure 10 15 10 15 < 1 of 1 20 Field strengths in N/C ▾ Part B What is the field strength? O 5 N/C O…

Q: A capacitor with plates separated by 0.0290 m is charged to a potential difference of 5.50 V. All…

A: 11.0 VExplanation:Formula Derivation:To find the new potential difference across a capacitor after…

Q: Light of wavelength 105 nm falls on a metal surface for which the work function is 5.00 eV. What is…

Q: Four forces (measured in Newtons) act on a crate. The forces are given by the vectors: F₁ =…

Q: A block and sphere are connected by a cord that passes over a pulley as shown. Neglect friction and…

Q: An explorer in Antarctica leaves his shelter during a whiteout. He takes 31 steps northeast, then 82…

Q: Including uncertainty, calculate the expected resistance of an orange-green-red-gold resistor. 2. A…

Q: The acceleration of the hanging mass is less than greater than M2 O equal to m1 the acceleration due…

Q: Iron uses 1000 W energy to heat up its base plate. The material of base plate is Aluminum alloy…

Q: Problem 2.20 An unmanned satellite orbits the earth with a perigee radius of 10,000 km and an apogee…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

The current in an RL circuit increases to 98 % of
its final value 2.29 s after the switch is closed.
Part A
What is the time constant for this circuit?
T =
Submit
Part B
R =
VO
Submit
ΑΣΦ
Symbols
Request Answer
If the inductance in the circuit is 0.292 H, what is the resistance?
VE ΑΣΦ
Request Apower
?
****
S
?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Calculation of the time constant and resistance

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Can a circuit e1eent have both capacitance and inductance?
The self-inductance and capacitance of an LC circuit e 0.20 mH and 5.0 pF. What is the angular frequency at which the circuit oscillates?
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
An emf of 9.7 × 10-3 V is induced in a coil while the current in a nearby coil is decreasing at a rate of 2.7 A/s. What is the mutual inductance of the two coils?
When the current in the RL circuit of Figure 14.12(b) reaches its final value /R, what is the voltage across the inductor? Across the resistor?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
Does the time required for the current in an RL circuit to reach any fraction of its steady-state value depend on the emf of the battery?
Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U
Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of its final value after 5.0 s, what is the inductive time constant? (b) If R=20 , what is the value of the self-inductance? (c) If the 20 resistor is replaced with a 100 resister, what is the time taken for the current to reach 90% of its final value?
Suppose a coil has a self-inductance of 20.0 H and a resistance of 200 . What (a) capacitance and (b) resistance must be connected in series with the coil to produce a circuit that has a resonant frequency of 100 Hz and a Q of 10?