The current in the circuit shown in the figure is 0.20 A. What is the potential difference AVat across the battery traveling in the direction shown in (Figure 1)? Express your answer in volts. I Review 30 Ω

Q: Check which of the following systems is dynamic. a. y(n) = x(-n) b. y(n) = x(n) + x(n-1)

A: Given governing equations of two system. Asked to check which are dynamic?

Q: Consider a linear time-invariant system whose input r(t) and output y(t) are related by the…

A: Given: The linear time-invariant system is, d2ytdt2+4yt=6rt.

Q: In the given circuit, find the current in the 12 resistor. 6 ohm +12V 4 ohm 8 ohm 12 ohm

A: Given circuit,

Q: An appliance uses 114 watts and is on 8 hours per day. If electricity costs 18 cents per…

A:

Q: Ultra High frequency(UHF) is used propagation method of

A:

Q: A 100 kVA, 220/440 V, 50 Hz power transformer is tested at 75 Hz to evaluate the core los while its…

A: Given, A 100 kVA, 220/440 V, 50 Hz power transformer is tested at 75 Hz to evaluate the core loss,.…

Q: A transistor connected in a common base configuration has the following readings I = 2 mA and I, =…

A: Given: A common base configuration transformer has the following readings, IE=2 mA,IB=20 μA.

Q: A power transformer is joined in star-delta. Its line voltage ratio is 66 kV/11 kV. The current…

A:

Q: 2. What is the current through R₂? VS1 15V R1 68 A. 3.19 A B. 319 mA D. C. 1.73 A 173 mA VA R2 30 22…

A: Circuit is given as;

Q: The RMS value of the signal shown in the figure is: f(t) 10 -10 0 1 23 4 5 6 t(sec)

A: We need to find out RMS Value of given signal

Q: 23 Given a 100 kVA, 50 Hz power transformer. The maximum efficiency of the transformer is 97.5 %…

A: Transformer: An device used in the transfer of electric energy is a transformer. AC current is used…

Q: Find the equivalent inductance between A and B if L₁ = 6 H, L₂ = 6 H, L3 = 20 H, L4 = 8 H and L5 =…

A: Given circuit, L1=6 HL2=6 HL3=20 HL4=8 HL5=10 H

Q: Calculate the equivalent resistance in the given circuit below: R1 11.6 ohms; R2 = 27.6 ohms; R3 =…

A: Given, The circuit is, Value of resistors are, R1=11.6 Ω,R2=27.6 Ω,R3=7.36 Ω,R4=7.64 Ω.

Q: B. Find, graphically, y(t) = f(t) * h(t) where h(t) = 8(t)- 8(t-1) and f(t) is the signal shown 2 1…

A: Given:

Q: IOU V₁ = 4√ Soa M Z Micke 2502 5005 199 Ix + 2KG V₂

A:

Q: 4. Find Vo and lo in the circuit. 18 V (+) 2K0 3K 4K6 Vo X ΓΧΩ ска Io

A: Given data: A network of voltage supply and resistors  DC voltage supply, V = 18 V 5 resistors,  2…

Q: The three loads in are fed from a line having a series impedance 0.01 + j0.08 , as shown in Fig.…

A:

Q: Find the Thevenin and Norton equivalent circuits between terminals/points (a) and (b) for the…

A:

Q: C₁ = [0.05P2 + 20P₂ + 30]; $ hr C₂ = [0.056P2 + 15P₂ +40]; hr Here P₁ and P₂ are in MW. Each…

A:

Q: 10. In a step-down transformer, the number of turns in the secondary coil is 20 and the number of…

A: The given transformer is a step-down transformer. Thus the output secondary voltage will be lower…

Q: The span of the same level transmission line is 300 meters. The diameter of the conductor is 15 mm.…

A:

Q: d Construct the truth table for the following circuit: D D -

A:

Q: SPIELE Rotate Clipboard Shapes 4.16 The resistances of the armature and field windings of a series…

A:

Q: Consider the system shown in Figure (1). This is a PID control of a second-order plant G(s). For the…

A:

Q: What kind of cable uses BNC connectors?

A: A cable is a bundle of wires, which is used to deliver electricity or carry the flow of electrons.…

Q: In the network below, find the power associated to the current source, for V1 = 8 V. V₁ 24 Select…

A:

Q: In the centre-tap circuit shown in Fig. 6.31, the diodes are assumed to be ideal i.e. having zero…

A: WE have an center-tap circuit as shown in figure, We need to determine, DC output voltage Peak…

Q: A protective put can be used for risk management.   A. TRUE B. FALSE

A: ANSWER      TRUE          A protective put can be used for risk…

Q: QUESTION 8 How many input instructions are in this ladder rung? L1 O O O 2 3 4 Inputs o-1/1 0-1/2…

A: The ladder rung is a representation of PLC control logic which contains few inputs and a single…

Q: Find the transfer function, G(s)=82(s)/T(s), for the shown rotational mechanical system driven by…

A: GIVEN: rotational mechanical system FIND:  determine the transfer function…

Q: 3. The following waveform was derived from an oscilloscope. CH1 (Yellow) Settings Volts/Div: 50V…

A: Given: Oscilloscope functions: Waveform of the oscilloscope

Q: 12 v 100 Ω B 200 Ω A E 300 Ω How much power is the battery supplying?

A: Given circuit:

Q: voltage gain. For the circuit shown in Fig. 25.32, find (i) input impedance (ii) differential

A: We have an circuit as shown above and we have been asked to find, Input Impedance Differential…

Q: A machine is attached to the following loads for light in the winding shop. The light affixse…

A:

Q: An electric supply company having a maximum load of 50 MW generates 18x 10^7 units per annum and the…

A: We have been given data of an electric company supplying electricity which has, Maximum demand = 50…

Q: A three phase six pulse converter having input 430 V, 50Hz supply is controlling a de motor. Motor…

A:

Q: Q: Draw output voltage waveform for this circuit if ß=50. +10v +5v -1vF Vi 2 3 4 t(ms) 50k +10v 10k…

A:

Q: Investigate the stability of the following system (Consider quadratic Lyapunov system) ( 4 =- (यँ-1)…

A:

Q: The strain gauge with a resistance of 250 ohm undergoes a change of 0.15 ohm. During a test the…

A: Given a strain gauge with, Resistance, R=250 Ω. Change in resistance, ∆R=0.15 Ω. Strain,…

Q: A strain gauge having a resistance of 500 ohm and a gauge factor 3.0 is bonded on a member of…

A:

Q: CLK f=12KHz 6KHz 4KHz 2KHz 7493 4CKA QA OCKB QB R01 QC R02 QD In reference to the circuit above, the…

A:

Q: 16v (+ Swen the 8A ← ww RUL RL Wowing 1212 RA +२५४ 1. aven that. R₂ is the load resistance, find the…

A:

Q: b. Find the current I, e. Draw the power triangle. d. Find the type of elements and their impedance…

A:

Q: E Ę Referring to Fig. 12.87, we have, and Subtracting 10,000 210-5774 210 volts (5686+/1003) volts…

A: Given here a data and asked to explain one equation.

Q: The diodes in the circuit in Figure Q7 have V₂ = 0.7. Determine the output voltage Vo and the…

A: Given, Vγ=0.7V1=2VV2=3VTo calculate,Vo=?ID1,ID2,ID3  and I

Q: List the elements included in the total input resistance of a common-collector amplifier. What is…

A: Given: List the elements included in the total input resistance of a common-collector amplifier and…

Q: 10. A 47 resistor and a capacitor with a capacitive reactance of 120 are in series across an ac…

A: SOLUTION GIVEN-->           LET                   RESISTOR = R ohm…

Q: 18 Given a 100 kVA, 50 Hz power transformer. The maximum efficiency of the transformer is 98.0 %…

A:

Q: If an energy meter makes 5 revolutions in 100 seconds, when a load of 225 W is connected, the meter…

A: Given an energy meter having, Number of revolution = 5. In time, t = 100 seconds = 1003600 hours.…

Q: A PN-junction diode has a reverse saturation current rating of 20nA at 32C, if the forward voltage…

A: Given data, Reverse saturation Current  IS=20 nA=20×10-9 A Forward Voltage drop VD=0.5 V

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.