Given the following set of data for the determination of density of solid material: Mass of emptybeaker = 37.54 g, Mass of empty beaker + solid 48.36 g, Initial graduated cylinder reading =25.00 mL; Final graduated cylinder reading 26.50 mL; The density (g/cm3) of the solid is:%3D%3DO a. 7O b. 7.2O c. 7.21d. 7.2133e. 7.213

Answered: Image /qna-images/answer/b43cb206-a0b0-4da7-9d08-b5d1234c45fb.jpg

Answered: ; The density (g/cm3) of the solid is:

Science

Chemistry

; The density (g/cm3) of the solid is:

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter2: Basic Statistical Analysis With Excel

Section: Chapter Questions

Problem 12P

See similar textbooks

Related questions

Q: Calculate the volume of the sample ar constont

Q: Which of the following are observed general properties of liquids? (a) fixed volume (b) mix…

A: The general properties of liquids has to be predicted.

Q: Explain the following changes in states of matter. Write one example for each. (a) Boiling (b)…

A: Boiling - It is a rapid heating of a liquid which further convert into its vapor when temperature…

Q: Temper From solid to gas O From gas to liquid O From liquid to gas Erom o to solid

Q: nen equal volumes of the following pairs of liquids are mixed thnoroughly and allowed to stand,…

A: ANSWER IS

Q: Tetra Pak are commonly consist of layers of materials as shown in the figure. This classification of…

A: What is another name of tetra pack material is given below.

Q: The melting point is the temperature where a solid becomes liquid. The melting poi of acetone is…

A: State of matter below its melting point is solid and above its melting point is liquid.

Q: Is volume i

Q: For eac the solu SO

A: Four multiple choice questions about solubility concept, which are to be accomplished.

Q: Contrast the arrangement of particles in solids and liquids

A: The three different types of matter are solid, liquid and a gas. The major difference between solid,…

Q: The gap between two panes of glass is filled with what?

A: Noble gases are the elements of group-18 of the periodic table. They are placed in group-18 of the…

Q: . The curves do not need to be to sca differences between the three cases. aragraph that describes…

Q: What are the units and numerical value of standardtemperature?

A: The standard unit of temperature is Kelvin.

Q: Why are some substances gases, some liquids, and others solids?

A: Matter : Matter is anything which occupies space and it has mass. A phase is that form of matter…

Q: a 11.1 g sample of 02 at standard temperature and pressure (STP) would occupy what volume in liters?

Q: Liquids and gases take the following characteristic(s) of their containers. Which is/are it?…

A: Generally there are three types of substances solid, liquid and gas.

Q: How much time (in minutes) is required to depos

Q: Compare the compressibility of solids and liquids. Support your answer by describing the arrangement…

A: To compare the compressibility of solids and liquids.

Q: Match the following terms with appropriate definition

A: In order to match the options with the correct categories, we have to know the definitions and the…

Q: The volume keeeps saying it's incorrect

A: From given Volume is calculated as follows

Q: Density of solid substance of any shape

A: Density of solid substance of any shape can be determined by only two parameters I) mass of the…

Q: olecule in units

A: Dear student I have given answer to your question in the image format.

Q: he volume (in L

Q: an endothermic phase

Q: What volume of water in gallon would be required to fill 25ml container?

Q: TWO agueous solutjons of BaloH and MgBra are mixed. write Out whet major chemical speces will e…

A: This is an example of double displacement reaction.

Q: Ablock of coper of unknown mass has an nial temperalure of 0.0C The copper is immersed in a beaer…

Q: What are all of the si units

A: SI units are International system of units.

Q: Explain what happens to the density of the water when it changes from liquid to solid. What is the…

A: The density of water decreases when it changes from liquid to solid.

Q: When a 750 mL balloon at 25 degrees C is cooled in liquid nitrogen to -196 degrees C, what is the…

A: According to Charles’ law, the volume shows direct relation with temperature that is, it is directly…

Q: A process that may be applied to a mixture of two substances which sublime closely together *

A: Given statement is : A process that may be applied to a mixture of two substances which sublime…

Q: what are the different levels of strucure of a material

Q: Mass of evaporating dish in grams is 138.29 what is the mass in kg, lbs, tons, and dg?

A: Given : Madd of dish = 138.29 g

Q: Which of the following is not a form of energy?

A: Capactity to do work is called energy various types of energies are 1. Thermal energy 2.…

Q: What is the substance undergoing a chemical or physical change known as?

A: A substance undergoing a physical or chemical change known as reactant. reactant is the substance…

Q: Rank from fastest to slowest. To rank items as equivalent, overlap them

Q: Enumerate the characteristics of a substance for it to be separated from the heterogeneous mixture…

A: Steam distillation is a process of distillation at temperatures Lower than the normal boiling point…

Q: A compound is a pure substance whose smallest representative is identified as?

A: Applying definition of compounds.

Q: At one atmosphere pressure, mercury solidifies at -38.0 oF. Express this temperature in degrees…

A: At one atmosphere temperature, mercury solidifies at -38.0 °F. We have to convert this temperature…

Q: A 1.59g sample containning KI was analyzed gravimetrically and .0538g of barium iodate was…

Q: s of kilopascals (kPa)? Do

Q: wo pans of water are on different burners of a stove. One pan of water is poiling vigorously, while…

A: ANSWERE IS DISCUSSED BELOW :

Q: OF2 expressed as an Integer?

A: The number of electron groups can be determined by the summation of bond pair and summation of lone…

Q: Which of the following is a method for separating a solid-liquid mixture?

A: Applying concept of separation of liquid- solid mixture by filtration.

Q: At what temperature in oF at which liquid water has the highest density?

A: Density of water first increases and then decreases upon decreasing temperature. It has been…

Q: What is a unit of volume of solids

A: Volume of any substance is defined a the space that particular substance takes up,at any particular…

Q: The Magnitude of the unit is the same between ----- and ----- scales, They differ in the position of…

A: There are mainly 3 types of temperature scales commonly used. These are - The Celsius scale The…

Question

Given the following set of data for the determination of density of solid material: Mass of empty
beaker = 37.54 g, Mass of empty beaker + solid 48.36 g, Initial graduated cylinder reading =
25.00 mL; Final graduated cylinder reading 26.50 mL; The density (g/cm3) of the solid is:
%3D
%3D
O a. 7
O b. 7.2
O c. 7.21
d. 7.2133
e. 7.213

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

In a river with a constant flow rate, the factory releases wastewater containing NaCl at a concentration of 200 mmol / L to the river at 20.0 L / s. The Na+ and Cl- concentrations at the downstream observation point were 1.00 mmol / L and 0.800 mmol / L, respectively. What is the river flow Q and Cl- concentration before the inflow of drainage? The river originally contains 0.500 mmol / L of Na+.
-If ethanol (S.G. = 0.790) were used rather than water in measuring the density of the irregular objects, how would that have affected the result? Explain. -When you were measuring the volume of the irregular solid you were told to stir to eliminate bubbles. If the bubbles were not eliminated, how would that affect the density? Explain. -Suppose the density of 65.0 mL of some liquid was found to be 0.748 g/mL. What would be the specific gravity of 45.0 mL of this liquid?
The molar volumes of pure acetone and pure chloroform at room temperature are 72.0 cm^3 and 81.0 cm^3, respectively. The volume of a liquid mixture containing 0.6 moles of acetone and 0.5 moles of chloroform is
the net force on a vehicle that is accelerating at a rate of 1.5m/s2 is 1,800 newton’s . what is the mass of the vehicle to the nearest kilogram
The density of air is 1.29 grams/L. What is the weight, in kilograms, of a cubic meter (1.00m^3) of air?
Torricelli, who invented the barometer, used mercury inits construction because mercury has a very high density,which makes it possible to make a more compact barometerthan one based on a less dense fluid. Calculate the densityof mercury using the observation that the column of mercury is 760 mm high when the atmospheric pressure is1.01 x 105 Pa. Assume the tube containing the mercury isa cylinder with a constant cross-sectional area.
To identify a liquid substance, a student determined itsdensity. Using a graduated cylinder, she measured out a 45-mLsample of the substance. She then measured the mass of thesample, finding that it weighed 38.5 g. She knew that the substancehad to be either isopropyl alcohol 1density 0.785 g>mL2or toluene 1density 0.866 g>mL2. What are the calculated densityand the probable identity of the substance?
Gypsum is the hydrate of calcium sulfate, CaSO4 · 2 H2O. It is the primary material in sheet rock, used to make walls in houses. If you heat 21.05 g of the hydrate and drive off the water, what is the weight of the anhydrous salt remaining? Report your response to the proper degree of certainty and include the correct unit symbol (i.e., g, mL, km, etc.).
High fructose corn syrup is a sweetener found in everyday food items especially carbonated beverages. It is derived from the "fruit" of corn using a bioprocess that degrades corn starch into its constituent sugars. Given the quantity of corn syrup (d = 1.4 kg L^-1) needed for many industries. It should be no surprise that this product is often transported from place to place in tank cars (via railway) where the typical transport mass is 2.290 x 10^5lbs. In the space provided below, calculated the diameter in (meters) of such a tank car's 11.12m long-cylindrical transport container. Recall that 1 gal =3.785 L, kg= 2.205lbs, and 1cm^3 =exactly 1mL
Why do you suppose Km values are so frequently standardized and published, drawing attention to the value Vmax/2, rather than Vmax itself?
The density of air at ordinary atmospheric pressure and 25 ∘C is 1.19 g/L. What is the mass, in kilograms, of the air in a room that measures 13.5 × 17.5 × 6.0 ft?
A partially filled one-gallon [gal] pitcher, that has a mass of 0.35 kilograms [kg] when empty, is sitting on a kitchen counter. Assume the total mass of the pitcher and its contents is 2 kilograms [kg]. The pitcher contains a liquid that has a molecular weight of 19.5 grams per mole [(g)/(mol)] and a molarity of 57 moles per liter [(mol)/(L)]. (a) Determine the volume of the liquid in the pitcher in units of liters [L]. (b) Determine the specific gravity of the liquid in the pitcher.