The drawing shows a wire tooth brace used by orthodontists. The topmost tooth is protruding slightly, and the tension in the wire exerts two forces T and T' on this tooth in order to bring it back into align- ment. If the forces have the same magnitude of 21.0 N, what is the mag- nitude of the net force exerted on the tooth by these forces? 55. 16.0° Dans 16.0⁰ T Brace

The drawing shows a wire tooth brace used by orthodontists. The topmost tooth is protruding slightly, and the tension in the wire exerts two forces T and T' on this tooth in order to bring it back into align- ment. If the forces have the same magnitude of 21.0 N, what is the mag- nitude of the net force exerted on the tooth by these forces? 55. 16.0° Dans 16.0⁰ T Brace

Name: Ch.4 #55 . Please see attached image for Physics question . Thank you
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: Ch.4 #55 . Please see attached image for Physics question . Thank you The drawing shows a wire tooth brace used by orthodontists. Thetopmost tooth is protruding slightly, and the tension in the wireexerts two forces T and T' on this tooth in order to

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter2: Vectors

Section: Chapter Questions

Problem 26P: In a tug-of-war game on one campus, 15 students pull on a rope at both ends in an effort to displace...

See similar textbooks

Similar questions

Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to either side. As they lift and hold it up so that it is motionless, each handle makes a different angle with respect to the vertical side of the chest (Fig. P5.76). If the angle between Jamals handle and the vertical side is 25.0 and the angle between Dayos handle and the vertical side of the chest is 30.0, what are the tensions in each handle? FIGURE P5.76
In a tug-of-war game on one campus, 15 students pull on a rope at both ends in an effort to displace the central knot to one side or the other. Two students pull with force 196 N each to the light, four students pull with force 98 N each to the left, five students pull with force 62 N each to the left, three students pull with force 150 N each to the right, and one student pulls with force 250 N to the left. Assuming the positive direction to the tight, express the net pull on the knot in terms of the unit vector. How big is the net pull on the knot? In what direction?
What is the y-component of a 95.3 N force that is exerted at 57.1degree to the horizontal.
There are two forces on the 1.19 kg box in the overhead view of the figure but only one is shown. For F1 = 15.7 N, a = 14.7 m/s2, and θ = 34.1°, find the second force (a) in unit-vector notation and as (b) a magnitude and (c) a direction. (State the direction as a negative angle measured from the +x direction.)
In the wheelbarrow, the load has a perpendicular lever arm of 7.50 cm, while the hands have a perpendicular lever arm of 1.02 m. (a) What upward force must you exert to support the wheelbarrow and its load if their combined mass is 45.0 kg? (b) What force does the wheelbarrow exert on the ground?
The figure shows a person whose weight is W = 782 N doing push-ups. Find the normal force exerted by the floor on (a) each hand and (b) each foot, assuming that the person holds this position.
The block shown in the figure is along a frictionless horizontal surface The block's mass is m = 4.70 kg , the magnitude of the applied force is F= 26.5N, and the angle of the applied force from the horizontal is theta = 26.0 degrees. What is the magnitude of the normal force acting on the block.
A mountain climber practices his technique in a mountain climbing school by balancing while suspended by two ropes attached to the ceiling. As shown by the figure, the left rope makes an angle of 60 degrees with the horizontal ceiling and the right rope makes an angle of 30 degrees with the horizontal ceiling. If the right rope has tension T1=322 N, what is the weight of the mountain climber?
Using the same force table that you used, a student was given two forces and asked to find a single force that would produce equilibrium with the two forces. The two forces were given by providing one of the components and the angle the force made with the positive x- axis. The two forces were as follows: Force 1: Fx = −2.70 N; Theta = 220.0 degreees Force 2: Fy = 3.20 N; Theta = 60.0 degrees (a) For each force, calculate the magnitude of the force and the mass required to produce it. (b) Calculate the mass and its angle of application to produce equilibrium with these two forces. Please specify your angle as counterclockwise positive with respect to the positive x-axis.
The figure below shows a bird feeder that weighs 177.7 N. The feeder is supported by a vertical wire, which is in turn tied to two wires, each of which is attached to a horizontal support. The left wire makes a 60° angle with the support, while the right wire makes a 30° angle. What is the tension in each wire (in N)? left wire= ? N right wire= ?N bottom wire= ?N
A 15-kg block is pushed across a rough horizontal surface by a force that is angled 30.0◦ below the horizontal. The magnitude of the force is 100 N and the acceleration of the block as it is pushed is 4 m/s2. What is the magnitude of the contact force (the vector addition of normal force and friction) exerted on the block by the surface?
A force of magnitude 7.50 N pushes three boxes with masses m1=1.30kg ,m2=3.20kg, and m3=4.90kg. Find the magnitude of the contact force between boxes 1 and 2.