The exhibit shows a small switched network and the contents of the MAC address table of the switch. PC1 has sent a frame addressed to PC3. What will the switch do with the frame? 7. a) b) The switch will discard the frame. c) The switch will forward the frame only to port 2. d) The switch will forward the frame to all ports except port 4. e) The switch will forward the frame to all ports. f) The switch will forward the frame only to ports 1 and 3.

The exhibit shows a small switched network and the contents of the MAC address table of the switch. PC1 has sent a frame addressed to PC3. What will the switch do with the frame? 7. a) b) The switch will discard the frame. c) The switch will forward the frame only to port 2. d) The switch will forward the frame to all ports except port 4. e) The switch will forward the frame to all ports. f) The switch will forward the frame only to ports 1 and 3.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter6: System Integration And Performance

Section: Chapter Questions

Problem 14VE

See similar textbooks

Similar questions

//Project2.sMysteryFunction1: movl $1, %eax // jmp .L2.L3: imulq %rdi, %rax movl %edx, %esi.L2: leal -1(%rsi), %edx testl %esi, %esi jg .L3 ret MysteryFunction2: movl $0, %edx movl $0, %ecx jmp .L5.L6: addl $1, %ecx.L5: cmpl $31, %ecx ja .L8 movl $1, %eax sall %cl, %eax testl %edi, %eax je .L6 movl $-2147483648, %eax shrl %cl, %eax orl %eax, %edx jmp .L6.L8: movl %edx, %eax ret MysteryFunction3: movq (%rdi), %rcx movl $1, %eax jmp .L10.L11: addl $1, %eax.L10: cmpl %esi, %eax jge .L14 movslq %eax, %rdx movq (%rdi,%rdx,8), %rdx cmpq %rcx, %rdx jle .L11 movq %rdx, %rcx jmp .L11.L14: movq %rcx, %rax ret MysteryFunction4: movl $0, %eax jmp .L16.L17: movl %edi, %edx andl $1, %edx addl %edx, %eax shrq %rdi.L16: testq %rdi, %rdi jne…
previously: 24-bit virtual addresses and 4kb pages.
Computer Science How large a buffer would you need on a communications channel that supports 5 GB/sec outside the computer and 1024 GB/sec inside the microprocessor. Normal communication to the outside is 3 GB/sec. A burst may last ½ second.
Q2: A gaming device has to transfer a high definition 1280 x 720 x 3 video frame @ 30 frames/sec. The 32-bit system bus operates in burst mode (burst size of 4). It takes one clock cycle to make one transfer through the bus and there is an overhead of five clock cycles per transfer. What should be the minimum bus frequency?
If there are page defects 99 percent of the time, then this indicates that they occur often (that is, a page is not in the TLB). In order to find a page in the TLB, it takes 50 nanoseconds, and it takes 12 milliseconds to read a page from the hard drive.
16-bit virtual addresses
ques9 plz provide handwritten ans asap
Explain the Address Resolution Protocol(ARP).
Describe the procedure of passive scanning and active scanning during the Host-AP association, respectively.
Describe the role of "gateway addresses" within a subnetted environment.
[ Direction: Any how solve the question please. Don't reject the question. if you need 2 /3 hours to solve the question please take it but don't reject the question. solve it properly,correctly.You can consult any resources such as books, online references, and videos for this assignment, however, you have to properly cite and paraphrase your answers when it is necessary. ] The following figure represents both datapath and controlpath for MIPS architecture that implements most of the fundamental instrucons.
Describe devices that operate at layers 4 to 7 of the OSI model.