The figure below shows a metal plate with a width of w 2 cm and a thickness of t = 0.1 cm. An electric current I= 20A is applied to it and placed in a magnetic field B in the direction shown in the figure. When the applied magnetic field is 2 tesla, the resulting Hall voltage of 4.28 V. Based on the above, determine the electron drift velocity (Vd)!

The figure below shows a metal plate with a width of w 2 cm and a thickness of t = 0.1 cm. An electric current I= 20A is applied to it and placed in a magnetic field B in the direction shown in the figure. When the applied magnetic field is 2 tesla, the resulting Hall voltage of 4.28 V. Based on the above, determine the electron drift velocity (Vd)!

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter11: Magnetic Forces And Fields

Section: Chapter Questions

Problem 89AP: The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole...

See similar textbooks

Similar questions

Verify the units obtained for magnetic field strength B in Example 24.1 (using the equation B=Ec ) are in fact teslas (T).
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?
(a) An oxygen16 ion with a mass at 2.661026kg travels at 5.00106m/s perpendicular to a 1.20T magnetic field, which makes it move in a circular arc with a 0.231-m radius. What positive charge is on the ion? (b) What is the radio of this charge to the charge of an electron? (c) Discuss why the radio found in (b) should be an integer.
An alpha-particle ( m=6.641027kg , q=3.21019C ) travels in a circular path of radius 25 cm in a uniform magnetic field of magnitude 1.5 T. (a) What is the speed of the particle? (b) What is the kinetic energy in electron-volts? (c) Through what potential difference must the particle be accelerated in order to give it this kinetic energy?
A conducting sheet lies in a plane perpendicular to a magnetic field B that is below the sheet. If B oscillates at a high frequency and the conductor is made of a material of low resistivity, the region above the sheet is effectively shielded from B . Explain why. Will the conductor shield this region from static magnetic fields?
The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole moment of the loop. (b) What is the torque on the loop if it is in a uniform 0.20-T magnetic field such that p and B are directed at 300 to each other? (C) For this position, what is the potential energy of the dipole?
A Hall-effect probe operates with a 120-mA current. When the probe is placed in a uniform magnetic field of magnitude 0.080 0 T, it produces a Hall voltage of 0.700 V. (a) When it is used to measure an unknown magnetic field, the Hall voltage is 0.330 V. What is the magnitude of the unknown held? (b) The thickness of the probe in the direction of B is 2.00 mm. Find the density of the charge carriers, each of which has charge of magnitude e.
A mass spectrometer is being used to separate common oxygen16 from the much rarer oxygen18, taken from a sample of old glacial ice. (The relative abundance of these oxygen isotopes is related to climatic temperature at the time the ice was deposited.) The ratio of the masses of these two ions is 16 to 18, the mass of oxygen-16 is 2.661026kg, and they are singly charged and travel at 5.00106m/s in a 1.20T magnetic field. What is the separation between their paths when they hit a target after traversing a semicircle?
Is the direction of the magnetic field shown in Figure 24.6 (a) consistent with the right—hand rule for current (RHR-2) in the direction shown in the figure?
A particle’s path is bent when it passes through a region of non-zero magnetic field although its speed remains unchanged. This is very useful for “beam steering’’ in particle accelerators. Consider a proton of speed 4106m/s entering a region of uniform magnetic field 0.2 T over a 5-cm-wide region. Magnetic field is perpendicular to the velocity of the particle. By how much angle will the path of the proton be bent? (Hint: the particle comes out tangent to a circle.
Explain why the magnetic field would not be unique (that is, not have a single value) at a point in space where magnetic field lines might cross. (Consider the direction of the field at such a point.)
A 25-cm nod moves at 5.0 m/s in a plane perpendicular to a magnetic field of strength 0.25 T. The rod, velocity vector, and magnetic field vector are mutually perpendicular, as indicated in tire accompanying figure. Calculate (a) the magnetic force on an electron in tire rod, (b) the electric field in the rod, and (c) the potential difference between the ends of the rod. (d) What is the speed of the rod if the potential difference is 1.0 V?