The figure is an edge-on view of a 12-cm-diameter circular loop rotating in a uniform 4.4x10-2 T magnetic field. (Figure 1) Figure B Pivot Circular loop lat 1 of 1 Part A What is the magnetic flux through the loop when is 0°? Express your answer with the appropriate units. $= Submit Part B $ = Submit μA Part C Value What is the magnetic flux through the loop when is 30°? Express your answer with the appropriate units. Previous Answers Request Answer μA Value Units 1 Request Answer ? Units ? What is the magnetic flux through the loop when 0 is 60° ?

The figure is an edge-on view of a 12-cm-diameter circular loop rotating in a uniform 4.4x10-2 T magnetic field. (Figure 1) Figure B Pivot Circular loop lat 1 of 1 Part A What is the magnetic flux through the loop when is 0°? Express your answer with the appropriate units. $= Submit Part B $ = Submit μA Part C Value What is the magnetic flux through the loop when is 30°? Express your answer with the appropriate units. Previous Answers Request Answer μA Value Units 1 Request Answer ? Units ? What is the magnetic flux through the loop when 0 is 60° ?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter22: Magnetic Forces And Magnetic Fields

Section: Chapter Questions

Problem 27P

See similar textbooks

Similar questions

Two flat, circular coils, each with a radius R and wound with JV turns, ace mounted along the same axis so that they are parallel a distance d apart. What is the magnetic field at the midpoint of the common axis if a current I flows in the same direction through each coil?
Two long wires, one of which has a semicircular tend of radius R, are positioned as shown in the accompanying figure. If both wires carry a current I, how far apart must then parallel sections be so that the net magnetic field at P is zero? Does the current in the straight wire flow up or down?
Suppose the parallel-plate capacitor shown below is accumulating charge at a rate of 0.010 C’s. What is the induced magnetic field at a distance of 10 cm from the capacitator?
The cross-sectional dimensions of the copper strip shown are 2.0 cm by 2.0 mm. The strip carries a current of 100 A, and it is placed in a magnetic field of magnitude B = 1.5 T. What are the value and polarity of the Hall potential in the copper strip?
12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
When the current through a circular loop is 6.0 A, the magnetic field at its center is 2.0104 T. What is the radius of the loop?
A current of 1.5 A flows through the windings of a large, thin toroid with 200 turns per meter. If the toroid is filled with iron for which =3.0103 , what is the magnetic field within it?
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
How is the percentage change in the strength of the magnetic field across the face of the toroid related to the percentage change in the radial distance from the axis of the toroid?
A 0.50-kg copper sheet drops through a uniform horizontal magnetic field of 1.5 T, and it reaches a terminal velocity of 2.0 m's. (a) What is the net map,-, eh: force on the sheet after it reaches terminal velocity? (b) Describe the mechanism responsible for this force, (c) How much power is dissipated as Joule heating while the sheet moves at terminal velocity?