The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s= 350, in units of 106 N/m². What are (a) the Young's modulus and (b) the approximate yield strength for this material? Assume ε = 0.010. (a) Number i (b) Number i Stress (106 N/m²) Units Units E Strain 28

Q: As part of a department store display, a model train D runs on a slight incline between the store's…

A:

Q: An airplane is heading north at an airspeed of 750 km/hr, but there is a wind blowing from the…

A:

Q: A roller coaster of mass 2420 kg is rolling down a track with an instantaneous speed 10 m/s. What is…

A: Given data,   Velocity  =   v   Mass   =  m      To find ,      Kinetic energy

Q: A truck of mass 5845 kg is travelling over a hill with a radius of curvature of 18.7 m, at a speed…

A:

Q: A 1.40 kg block hangs from a spring. A 280 g body hung below the block stretches the spring 2.70 cm…

A:

Q: You hire a tow truck that attaches a rope to your car at an angle of 25 degrees above the…

A: Given data:  Angle above the horizontal (θ) = 25° Tension force (F) = 1800 N Horizontal displacement…

Q: A 6.00-m long string sustains a three-loop standing wave pattern as shown. The wave speed is 2.00 ×…

A: Given Data:- Length of the string is L=6.0 m Speed of the wave is v=2.00×102 m/s. Required:- Lowest…

Q: 1.5 Is there a range of timestep choices At where the solution is unstable (oscillating up and down…

A: (1.5) If we increase the time step by keeping the mesh size fixed (fixed size of particles) then…

Q: A plane flies 435 miles with the wind and 345 miles against the wind in the same length of time. If…

A:

Q: How is cyclic integration related to carnot cycle?

A:

Q: An object hangs from a spring balance. The balance registers 35 N in air, 25 N when this object is…

A:

Q: Imagine that you are observing a star and you find the wavelength of peak emission for the star to…

A: As part of our policy, we are answering only 3 subparts.  Given,  Peak emission wavelength of start…

Q: Whenever you directly touch a hot plate, you immediately feel the heat transfer to your hand the…

A: Whenever you directly touch a hot plate, we immediately feel the heat transfer through our  hand  .…

Q: Does the value of gravity depend on the mass of the pendulum?

A: The value of g does not depend on the mass of the pendulum. The formula of gravity is  g=GM/r^2.…

Q: An object of mass 2.0 kg tied to a string is spinning around in a circle with a radius of 1.0 m, at…

A:

Q: A bus is accelerating at a rate of 10 m/s2. What is the new acceleration of the car if the force is…

A:

Q: 5. A 1.0-2 resistor is connected across a battery having an emf of 6 v. If the resistor has to…

A:

Q: Two forces F1 = (-1.5i-0.8j+0.7k) N and F2 = (-0.7i+1.2j) N, are applied to a moving object. what…

A:

Q: A new planet is discovered in another (distant) solar system. The planet has a mass of 9.00 *1024 kg…

A: Given Mass of a planet = M = 9.00 × 1024 kg Radius of a planet = R = 8.00 × 106 m WWe have to…

Q: An object with net charge of 4.80*10^-6 Coulomb experiences an electrostatic force having a…

A:

Q: Given A= (-3i+7j-4k) B= (6i-10j+9k), calculate A X B.

A: Given  A= (-3i+7j-4k) B= (6i-10j+9k) We have to calculate A X B.

Q: A 162 cm long aluminum rod (thermal conductivity = 205 W/m-K) has a cross-section area of 1 cm2. If…

A:

Q: Typically, scuba tanks are immersed in water to cool them as they are filled with compressed air. If…

A:

Q: If an object transistions from the phase liquid to solid, what will happen to the potential energy…

A:

Q: What does a Michelson Interferometer physically do? Group of answer choices Shows interference…

A: Michelson Interferometer physically measures the speed of light.  Option (b) is correct choice.

Q: Find the equivalent capacitance for these circuits. Show all your work. Upload your work and box…

A:

Q: You push your 1,000 N car up a ramp that is 15 m long and forms an angle of 15 degrees above the…

A: Given data:  Weight of car (mg) = 1000 N Distance (d) = 15 m Angle (θ) = 15°, above the horizontal…

Q: What is the length of a simple pendulum whose full swing from left to right and then back again…

A: Given data:  A simple pendulum Period (T) = 2.7 s Required: Length (L)

Q: F₁-300 lb 30° IF₂=600 lb Fig. P2-47 60⁰ F₁-750 lb The three forces shown in Fig. P2-48.

A:

Q: Material Vacuum Air Water Ice Glass Diamond Index of Refraction (n) 1.000 1.000277 1.333333 1.31…

A: Given refractive index of glass (ng)=1.5 Refractive index of water (nw)=1.333333 Required refractive…

Q: What does the unit of current, that Ampere, stand for? (Standard SPS10 a) O a O b d Coulombs/second…

A:

Q: What equation is almost similar to the electric potential energy?     electric potential…

A: Introduction: The electric potential energy of the charged particle is equal to work done on the…

Q: While working on a refraction experiment you are trying to find the critical angle defined by the…

A: Option (b) is correct choice. Boundary between two media involved.  Critical angle is the angle of…

Q: A parallel plate capacitor is constructed with plates of areas 0.038 m² and separation 0.6 mm. (a)…

A: Answer Given data Area of the capacitor A = 0.038 m2 Distance between plates d = 0.6 mm = 0.6×10-3 m…

Q: A 70.0 kg astronaut lands on a planet with a mass of 5.3 x1023 kg and a radius of 2.7 x106 m.…

A:

Q: A person is spinning an object around their head at a constant speed. At this moment, the object's…

A: Solution: Given: A person is spinning an object around his head at a constant speed. At this moment,…

Q: In the figure, a lead brick rests horizontally on cylinders A and B. The areas of the top faces of…

A:

Q: When you apply increasing thermal energy to a certain material, it reaches a temperature of 50…

A: Assuming ideal situation.  Energy is not lost during the heat transfer.

Q: 1. Determine the charge entering the element fro t=0 to t=2s if the current flowing through the…

A:

Q: The capacitance of an empty capacitor is 2.30 uF. The capacitor is connected to a 12-V battery and…

A:

Q: UTM Two block of masses 30 kg and 6 kg are connected by a light string via a light and smooth pulley…

A:

Q: A radar pulse returns to the transmitter–receiver after  a total travel time of 4.00 3 1024 s. How…

A:

Q: 150g book is initially at rest on a table that has no friction. A force of 3.2 N is applied to the…

A: Given: The mass of the object is 150 g. The applied force is 3.2 N. The distance traveled by the…

Q: The following figure shows a 4 m bar fixed to the wall through a hinge that rotates freely, but is…

A:

Q: Consider the energy levels for a hydrogen atom, listed in the table below. Each energy represents…

A:

Q: As part of a department store display, a model train D runs on a slight incline between the store’s…

A:

Q: Simple Harmonic Motion 1) A mass attached to a spring, on a frictionless surface, makes one complete…

A: Given:- T= Time period of SHM= 2.4 sec. A= Amplitude of SHM= 0.2 m From T we can find w= angular…

Q: Subtracting Vectors Graphically: A Woman Sailing a Boat A woman sailing a boat at night is following…

A:

Q: 1.angle of deviation 2.angle of incidence 3.critical angle 4.angle of refraction

A:

Q: Question 7 A metal wire is arranged vertically with its upper end held fixed in a support. A load of…

A: Sound is longitudinal wave and hence it needs material medium to travel. The speed of sound in…

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).