The fireman wishes to direct the flow of water from hishose to the fire at B.(Figure 1)Figure-35 ft-B<1 of 1 >20 ftPart ADetermine two possible angles 0₁ and 2 at which this can be done. Water flows from the hose at VA = 45ft/s.Enter your answers numerically separated by a comma. Assume angles below the horizontal aspositive.01, 02 =SubmitProvide Feedback% ΑΣΦΗ ΤΗ↓↑Request Answervec?Next >

Name: The fireman wishes to direct the flow of water from hishose to the fi
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The fireman wishes to direct the flow of water from hishose to the fire at B.(Figure 1)Figure-35 ft-B 20 ftPart ADetermine two possible angles 0₁ and 2 at which this can be done. Water flows from the hose at VA = 45ft/s.Enter your answers nu

Answered: Image /qna-images/answer/9253d01f-8e24-463a-bcc0-0221416486bf.jpg

Engineering

Mechanical Engineering

The fireman wishes to direct the flow of water from his hose to the fire at B.(Figure 1) Figure VA 35 ft B 1 of 1 20 ft Part A Determine two possible angles 0₁ and 2 at which this can be done. Water flows from the hose at V₁ = 45 ft/s. Enter your answers numerically separated by a comma. Assume angles below the horizontal as positive. 01.02 = Submit Provide Feedback 17| ΑΣΦ | | | vec Request Answer ? ° Next >

The fireman wishes to direct the flow of water from his hose to the fire at B.(Figure 1) Figure VA 35 ft B 1 of 1 20 ft Part A Determine two possible angles 0₁ and 2 at which this can be done. Water flows from the hose at V₁ = 45 ft/s. Enter your answers numerically separated by a comma. Assume angles below the horizontal as positive. 01.02 = Submit Provide Feedback 17| ΑΣΦ | | | vec Request Answer ? ° Next >

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water flows at the rate of 5 ft³/s through an inclined pipe. At point A, where the diameter is 12 inches, the pressure is 15 psi. At point B, the diameter is 6 inches and the center of the pipe is 2 feet lower than at point A. Draw a clear diagram of the pipe system that indicates the following: (a-1) water flow reflecting the quantities involved in describing fluid flow and (a-2) the object of interest and the quantities that describe Bernoulli’s equation. Write the Bernoulli’s Equation using subscripts U ad L for the upper and lower points respectively and determine the pressure at point B?
Use g=32.2 */sec2 (9.81 m/s2) and 60°F (16°C) water unless told to do otherwise.• Google schedule-40 pipe’s thickness at different nominal size to obtain the innerdiameter of the pipe for accurate determinaLon of flow velocity.• Must show your work to support your selecLon. Otherwise, no points will be given.Water flows through a schedule-40 pipe that changes gradually in diameter from 6 in (154mm) at point A to 18 in (429 mm) at point B. The volumetric flow rate is 5.0 *3/sec (130 L/s). The respecLve pressures at points A and B are 10 psia (70 kPa) and 7 psia (48.3 kPa). All lossesare insignificant. What are the direcLon of flow and velocity at point A? (A) 3.2 */sec (1 m/s); from A to B(B) 25 */sec (7.0 m/s); from A to B(C) 3.2 */sec (1 m/s); from B to A(D) 25 */sec (7.5 m/s); from A to B
In Figure 8 three pipes discharge water at 20 ° C stationary to a large outlet pipe. The velocity V2 = 5 m / s and the outlet flow Q, = 120 m / h. Calculate (a) V1. (b) V3 and (c) V4 if it is known that, by increasing Q3 by 20 percent, Q̟4 increases by 10 percent.
Water flow from a large tank (T1) through a pipe Pipe X which splits into two smaller pipes, which discharges and flow out freely on Pipe Y and Pipe Z on as shown on the figure below. Diameter of Pipe W and Pipe X =50 mm Diameter of Pipe Y = 30 mm Diameter of Pipe Z = 20 mm The velocity in meter per second through Pipe X is Blank 1 m/s. **EXPRESS YOUR ANSWER in TWO (2) DECIMAL PLACE and DO NOT PUT UNITS**
As water is flowing from a water tower to someone house, water is flowing at a speed of 3 m/s in a pipe with diameter of 0.3 m. The pipe gradually increases to a diameter of 1.8 m and then gradually decreases to a diameter of 1.1 m. Draw neat sketch. i) what is the speed of the water when it reaches the pipe diameter of 1.1 m? ii) what is the flow rate of water flowing through the pipe in lit/hr?
Hello! I am given this: "A tide pool generating stations produces electricity (power) by utilizing the natural ebb and flow of the tides. Figure 2 (see attached) shows a tidal station at high tide - note that some mass (m) of water has been elevated by the tide. This mass will flow through the generator and out to sea over the next 6 hours. The range of the tide (range = 2h) is the difference between the low water and high water marks. Based on this information, write down an equation for the gravitational potential energy associated with the mass of water m. (Hint: some of the water is at a height of 2h above the low water mark but some is at the low water mark) Use the low water mark as your reference height.
Use g=32.2 */sec2 (9.81 m/s2) and 60°F (16°C) water unless told to do otherwise.• Google schedule-40 pipe’s thickness at different nominal size to obtain the innerdiameter of the pipe for accurate determinaLon of flow velocity.• Must show your work to support your selecLon. Otherwise, no points will be given.• No peer discussion is allowed.1. A schedule-40 pipe necks down from 24 in at point A to 12 in at point B. 8 *3/sec of 60°Fwater flow from point A to point B. The pressure head at point A is 20 *. FricLon is insignificantover the distance between points A and B. What are the magnitude and direcLon of theresultant force on the water? (A) 2900 lbf; toward A(B) 3500 lbf; toward A(C) 2900 lbf; toward B(D) 3500 lbf; toward B
A liquid (SG = 0.920) is being pumped from a reservoir as shown. The pressures at points 1 and 2 are -8 psi and 44 psi, respectively. The rate of flow in the pipe is 0.714 ft3/s. Neglect energy (friction) losses in the system. Use x = 4 ft., y = 7 ft. Use 1 hp = 550 lb-ft/s. Efficiency of the pump is 91%. What is the output power of the pump, in hp? Round off to two decimal places.
A turbine has the following data: inlet radius = 2.2 m outlet radius = 1.5 m blade width at inlet = 0.8 m blade width at outlet = 2.1 m inlet blade angle = 66º outlet blade angle =18.5ºN = 100 rpm Q = 85 m3/s Calculate the angle at the inlet by which the wicket gates should turn the flow from radial. Round off your final answer to two decimal places.
In the method of measuring fluid through a channel, describe the method for obtaining the inlet velocity and the outlet velocity of the fluid. Use Bernouly's formula in full
#19.12 PROVIDE ALL THE GIVEN, REQUIRED, EQUATION, FORMULA USED AND SOLUTION DONT USE PAPER AND BALLPEN (I CANT SEE)
A battery harnesses a chemical reaction to extract energy in the form of useful electrical work. (a) A certain battery runs a toy truck and becomes par- tially discharged. In the process, it performs a total of 117.0 J of work on its immediate surroundings. It also gives off 3.0 J of heat, which the surroundings absorb. No other work or heat is exchanged with the sur- roundings. Compute q, w, and AU of the battery, making sure each quantity has the proper sign.