The flow rate between tank A and tank B shown in the figure will decrease by 30% by adhering a second pipe that goes from point C to tank B. If the surface elevation of tank A is 25 ft higher than that of tank B, determine the diameter, D, of the second pipe. Despise lost minor and assume that the friction factor is 0.02.

The flow rate between tank A and tank B shown in the figure will decrease by 30% by adhering a second pipe that goes from point C to tank B. If the surface elevation of tank A is 25 ft higher than that of tank B, determine the diameter, D, of the second pipe. Despise lost minor and assume that the friction factor is 0.02.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter9: Moments And Products Of Inertia Of Areas

Section: Chapter Questions

Problem 9.94RP: The properties of the unequal angle section are Ix=80.9in.4,Iy=38.8in.4, and Iu=21.3in.4. Determine...

See similar textbooks

Similar questions

The triangular plate is fixed at its base, and its apex A is given a horizontal displacement of 5 mm. Suppose that a= 640 mm
The timber AB of Figure Y is 7.20 m long by 15 cm square. Find the specific weight of the timber and the total weight of the anchor (sp. gr. 2.40)
A block of stone is cut so that its cross‑section is a parallelogram. The width of the bottom side is ?=0.655 m, the height of the top of the block is ℎ=0.915 m, and the top right corner overhangs a distance ?oh=0.195 m from the bottom corner as shown. Assume that the block is of uniform density, so that the center of gravity of the block is located at the geometric center.
Two circular shafts, one hollow and one solid, are made of the same material and have the diameter shown below.If TH is the twisting moment that the solid shaft can resist, what is the ratio of Th to Ts
What is the area of the cross section a-a in mm2?What is the normal force Pn on section a-a in KN? What is the shearing force V on section a-a in KN?
can you resolve the problem but with 10mm diameter, l=100mm, P=7850N, change in diameter = 3.25x10^-3mm
The maximum torsional shear stress of a shaft with diameter D can be found at what distance from the center of the shaft?
A thick cylinder internal diameter 240mm external diameter 240mminternal diameter ‘D’ is subject to external pressure of 40MPa. Determine the diameter‘D’ if the minimum hoop stress in the cylinder is not to exceed 200MPa in mm.
What are the Internal Resultant Loadings?
Figure (a) shows the cross-sectional dimensions for the structural steel section known as C1020 (channel with a nominal depth of 10 in., weighing 201b/ft). The American Institute of Steel Construction Structural Steel Handbook lists the following properties for the cross section: A=5.88in.2,Ix=78.9in.4, and Iy=2.81in.4. If two of these channels are welded together as shown in Fig. (b), find Ix and Iy for the resulting cross section.
The properties of the unequal angle section are Ix=80.9in.4,Iy=38.8in.4, and Iu=21.3in.4. Determine Ixy.
A steam engine cylinder has an effective diameter of 35 cm and the maximum steam pressure acting on the cylinder cover is 12.5 kg/cm2. Calculate the number of 2-cm diameter required to fixthe cylinder cover. Assume that the permissible stress in the bolts is 330 kg/cm2.