The following diagram represents a cart (m1) (400 gm) and (m2) equal 60 gm, sliding on frictionless surface horizontally, if we take 20 gm from (m1) and add it to (m2) then the acceleration of the system will. netm total a EF EF net m 2.8 O incre O decrease O O m will not be changed Normal Force mig more information required. Tension Tension mag

The following diagram represents a cart (m1) (400 gm) and (m2) equal 60 gm, sliding on frictionless surface horizontally, if we take 20 gm from (m1) and add it to (m2) then the acceleration of the system will. netm total a EF EF net m 2.8 O incre O decrease O O m will not be changed Normal Force mig more information required. Tension Tension mag

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter4: The Laws Of Motion

Section: Chapter Questions

Problem 6CQ: A weight lifter stands on a bathroom scale. (a) As she pumps a barbell up and down, what happens to...

See similar textbooks

Similar questions

A block of mass 3m is placed on a frictionless horizontal surface, and a second block of mass m is placed on top of the first block. The surfaces of the blocks are rough. A constant force of magnitude F is applied to the first block as in Figure P4.68. (a) Construct free-body diagrams for each block. (b) Identify the horizontal force that causes the block of mass m to accelerate. (c) Assume that the upper block does not slip on the lower block, and find the acceleration of each block in terms of m and F. Figure P4.68
2. A 60-kg woman holds a 9-kg package as she stands within an elevator which briefly acceleratesupward at a rate of g/4. Determine the force R which the elevator floor exerts on her feet and thelifting force L which she exerts on the package during the acceleration interval. If the elevatorsupport cables suddenly and completely fail, what values would R and L acquire? ( 3 decimal places in final answer pls)
The head injury criterion (HIC) is used to assess the likelihood of head injuries arising from various types of collisions; an HIC greater than about 1000 s is likely to result in severe injuries or even death. The criterion can be written as HIC = (aavg/g)2.5Δt, where aavg is the average acceleration during the time Δt that the head is being accelerated, and g is the free-fall acceleration. Shown is a simplified graph of the net force on a crash dummy’s 4.5 kg head as it hits the airbag during a automobile collision. What is the HIC in this collision?
A person has a reasonable chance of surviving an automobile crash if the deceleration is no more than 30 "g's." Calculate the magnitude of the force on a 62-kg person accelerating at this rate. Express your answer to two significant figures and include the appropriate units. F= ____________ units What distance is traveled if brought to rest at this rate from 120 km/h? Express your answer to two significant figures and include the appropriate units. d= _____________ units
A 0.450-kg hammer is moving horizontally at 7.00 m/s when it strikes a nail and comes to rest after driving the nail 1.00 cm into a board. Assume constant acceleration of the hammer-nail pair.a. Calculate the duration of the impact.b. What was the average force exerted on the nail?
•When two people push in the same direction on an object ofmass m they cause an acceleration of magnitude a1. When thesame people push in opposite directions, the acceleration of theobject has a magnitude a2. Determine the magnitude of the forceexerted by each of the two people in terms of m, a1, and a2.
1. A driver who does not wear a seatbelt continues to move forward with a speed of 18.0 m/s (due to inertia) until somethingsolid like the steering wheel is encountered. The driver nowcomes to rest in a much shorter distance—perhaps only a fewcentimeters. Find the magnitude of the net force acting on a65.0-kg driver who is decelerated from 18.0 m/s to rest in 5.00 cm. Graph and Explain
I was told that if an equal amount (same mass, velocity, time interval) of non bouncy and bouncy balls fall on tray i am holding... force to hold up the tray will be 2x as much for bouncy balls, since they bounce back up. Can there be a case where force to hold the tray can be equal for both? like if 2x as many non bouncy balls drop on my tray? math reasoning: p= m(-v)-mv for bouncy balls, so -2mv p=0-mv for non bouncy, so -mv Question: If I hold a tray for bouncy vs. non bouncy (same mass, time interval, velocity) I will use 2x as much force to hold up the tray for the bouncy ball. What if I had 100 non bouncy balls and 50 bouncy balls, will force be equal?
3. Jasmine is driving her car at 90.0km / h when she sees a squirrel . She slams on her breaks and is able to stop after moving 15.0 m . If the mass of the car is 1500.00 kg determine the coefficient of kinetic friction acting on the car .
Two teams of four members each engage in a tug of war. Each of the first team’s members has an average mass of 62.0 kg and exerts an average force of 1317 N horizontally. Each of the second team’s members has an average mass of 68.0 kg. The second term pulls with a larger force so that the acceleration of the two terms is 0.169 m/s2. What is the average force exerted in the horizontal direction by each member of the second term? Whoever is answering this I truly appreciate you <3
A small engine causes a 0.20-kg model airplane to accelerate at a rate of 12 m/s2 . What is the net force on the model airplane? A. 2.4 N B. 60. kg•m/s C. 2.4 kg•m/s D. 60 N
A 620 kg car pulling a 495 kg trailer accelerates forward at a rate of 2.20 m/s2. Assume frictional forces on the trailer are negligible. Ignore air drag. (d)What is the resultant force exerted by the car on the road? (Assume that the forward direction is along the +x-direction to the right and that the +y-direction points upward. Enter the magnitude in N and the direction in degrees measured from the left of the −y-direction.) Magnitude (in N): Direction: (measured from the left of the −y-direction in degrees)