The following system is in static equilibrium with the strings AB, BC, and CD connected to suppor and 50N weights as shown. The middle string BC is exactly horizontal, and points A and D are co a rigid support. Calculate the tension forces T₁, T2, T3, and the angle 8. A T₁ 35° B T₂ 0 C D T3

Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…

A:

Q: Q.3 A boiler drum consists of a cylindrical portion 2 m long, 1 m diameter, and 25 mm thick, closed…

A:

Q: Cite three reasons why ferrous alloys are used so extensively

A:

Q: The car A has a forward speed of 22 km/h and is accelerating at 3.1 m/s². Determine the velocity and…

A: Given data: vA=22 km/s=6.11 m/saA=3.1 m/s2ω=3.1 rev/min=0.325 rad/s Need to determine the relative…

Q: 1. Show the steps in the derivation of the continuity equation. 2. Show the steps in the derivation…

A:

Q: Water flows in a 3.5-cm-diameter pipe so that the Reynolds number based on diameter is 2000 (laminar…

A:

Q: Determine the equivalent spring stiffness constant of the following.

A:

Q: Ethylene is heated at a constant pressure of 5 MPa and 20 degrees Celsius until the temperature…

A:

Q: Patm = 100 kPa A = 0.0078 m² mpiston = 10 kg mgas = 0.5 kg k = 9000 N/m Heat -X₂ = 0.06 m -x₁ = 0m

A:

Q: For a large plate, the geometry factor, f, is 1.03. Suppose a steel casting alloy has a critical…

A:

Q: Shown in the figure, Fluid 1 is flowing in a horizontal tube and a U-tube manometer containing Fluid…

A: According to hydrostatic law, the pressure at any location fluid inside a static fluid is the…

Q: 50 grams of water executes a Carnot power cycle. During the isothermal expansion, the water is…

A: Given: mass of the water→m=50 gm=0.05 Kg At 10 MPa: From the steam table: →hf=1407.97…

Q: Determine the forces in members BE and CE of the loaded truss. The forces are positive if in…

A:

Q: Refrigerant 134a enters an insulated diffuser as a saturated vapor at 100°F with a velocity of 1200…

A: Given: At inlet to diffuser: R-134a = saturated vapor T1=100 °Fc1=1200 ft/sA1=1.4 in2 At exit to…

Q: Compute the fracture stresses in MPa for internal cracks that are 6.00 cm long in a composite of…

A: Given:- Internal crack length (a) = 6 cm  a = 0.06 m Fracture toughness (K) = 23 MPa-m1/2  Crack…

Q: Under the weight of the sign, the tension in cable BC is 180 N and Cable BD is 90 N. Determine the…

A: Given data :- Force FBC = 180 N Force FBD = 90 N Find the resulting moment about point A in…

Q: In the setup seen in the image, an oil tank's central circular opening is sealed off by a solid…

A:

Q: O2) Using the figure  a. Determine the x and y components of F1 and F2 b. Slide F1 wherein its…

A: as per guidelines we need to answer only 1st three subparts

Q: A steel fin (k= 54 W/m-K) with a cross-section ofan equilateral triangle, 5 mm in side is 80 mm…

A: Given:-A steel fin havingk= 54 W/m-KCross section is equilateral triangle of side (a) = 5 mm = 0.005…

Q: A motorboat and its load weigh 2150 N. Assume that the propeller force is constant and equal to…

A: Given: Let us consider the given, Propeller force,P=110 N Resistance force, R=6.7v Mass of the boat,…

Q: Calculate the moment about point A when F1 = 436 lbs. and F2=400 lbs. If the resultant moment is…

A: Given:F1=436 lbsF2=400 lbsFind:The moment about point A, MA

Q: A rigid bar of weight hangs from three equally spaced wires: two of steel and one of aluminum (see…

A:

Q: 62.4 μw = 23.6 x 10-6 lbs) flows through the 7-in. diameter lb > ft ft2 Water (Y pipe below with an…

A:

Q: A 13-mm-diameter steel (E = 193 GPa) rod (2) is connected to a 27-mm-wide by 10-mm-thick rectangular…

A: Given:Diameter of steel rod, d=13 mmModulus of elasticity of steel rod, Est=193 GPa=193*103 MPaWidth…

Q: 5.1 Determine the forces in the members of the planar truss shown. A F C 23 kN 8m D 3m

A: Find the forces in all members.

Q: Determine the coordinate direction angles of the force vectors FA & FB. FA is 149 lb and FB is 100…

A: Given data :- Force  FA= 149 lb             FB = 100 lb Find the coordinate direction angles of the…

Q: Under what condition can entropy decrease in a system? It will naturally decrease. Only if the…

A: Question 3: When temperature of body will reduce it's entropy will decrease and temperature will…

Q: Determine the phase for each of the following water states at 120◦C, 0.5 m^3/kg , show your…

A:

Q: The results from a settling column test performed on a municipal sewage from a certain town were as…

A: We know that velocity = depth/tim v= cm/min Area of tank = π4d2 velocity = Q/cross section area When…

Q: In the figure, aluminum [E = 68 GPa] links (1) and (2) support rigid beam ABC. Link (1) has a…

A:

Q: c) During his rotational throwing motion, a discus athlete increases his angular velocity from 3.9…

A: Write the given data. ωi=3.9 rad/sωf=21.6 rad/st=0.8 s

Q: Determine the force in each member of the loaded truss. The forces are positive if in tension,…

A:

Q: 1 Mechanical Wave A string is set up as shown. One end of the string is attached to an oscillator…

A:

Q: At the pressure of P=0.1MPa, the saturation temperature of water is Tsot-100 °C, the specific volume…

A: Given data  Pressure = 0.1 Mpa Tsat = 100°C Specific volume  vf = 0.001043 m3/kg vg = 1.6720 m3/kg…

Q: It has been shown (Pounds, 2011) that an unloaded UAV helicopter is closed-loop stable and will have…

A: Given: Characteristic equation s3+mghIq2+kkd+q1gs2+kmghIs+mghIkki+q1=0 To find: Show that the…

Q: Replace the loading by an equivalent resultant force and couple moment acting at point Suppose that…

A: Given data: w=65 lb/ft Need to determine the resultant force and couple moment about the point O.

Q: A forklift with a mass of 3.0 x10³ kg is Carrying a crate, white position on a incline angle @ =…

A: Given data: mass m=3.0*103Kgθ=15°

Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…

A:

Q: What is the rate of heat transfer, temperature gradient, and the direction of the heat transfer…

A: Given data  Area = 3 × 8 ft^2 = 24 ft^2 Thickness = 1 in Temperature T1 = 80°F And T2 = 60 °F…

Q: As shown in the figure, a 300-ft³ tank contains 25 lb of H₂O initially at 30 lbf/in². The tank is…

A:

Q: A 3 ft 200 lb 3 ft + -3 ft 5 30° 100 lb 50 lb Replace the loading system by an equivalent resultant…

A: Given:Forces acting:F1=200 lbF2=50 lbF3=100 lb

Q: Air (cp = 1.005 kJ/kg·°C) is to be preheated by hot exhaust gases in a cross-flow heat exchanger…

A:

Q: A compound steel (G= 70 GPa) shaft consists of a solid 59-mm-diameter segment (1) and a solid 39-mm-…

A:

Q: Five kg of steam is contained within a piston- cylinder assembly. It undergoes an expansion from…

A:

Q: The assembly shown starts from rest when a constant 15-N force T is applied at time t = 0. Find the…

A: Given data as per the question Force T =15 N Mass of ball =3 kg time t =10 s

Q: For water with pressure of P=8MPa and secific volume v=0.023525 m3/kg, (6) Find the quality if…

A: Given data as per the question  P=8MPa  secific volume v=0.023525 m3/kg,

Q: Determine the x and y centroids of each shape based on the given axis. b. Determine the x and y…

A: as per guidelines we need to answer only first 3 subparts of question

Q: Determine the combined moment made by the two pairs of forces about point O and about point C. 6.0…

A:

Q: Air enters the compressor of a regenerative ideal air-standard Brayton cycle at 100kPa, 300K, with…

A:

Q: For the mechanism of the figure at the instant shown O1 is the center of curvature of the slotted…

A: Given Data W2= 10rad/s clockwise α2= 23rad/s2 counter-clock wise θ2= 44° β=52° O1O6=115cm O1O4=39cm…