The forces F1 = 500 N, F2 = 400 N, and F3 = 700 N all of which act on point A of the bracket, are specified in three different ways. F1 F2 3 35 4 0.1m F0.2 m- 0.3m F3 B -0.4 m-

Q: What is the capital cost of a plant that produces 250,000 tons per year of ethanol (fuel grade) cons...

A: Given: Plant capacity (Q)=250000 metric tons per year Required to find : Capital cost of the plant u...

Q: Consider two closed systems A and B. System A contains 2000KJ of thermal energy at 20°C whereas syst...

A: Here , two closed systems are there. A and B .

Q: 1 Kg of 02 gas occupies a volume of 10°m at a temperature of 300K, so the work needed to compress th...

A: At constant pressure, the work done is obtained from the product of pressure and change in volume. t...

Q: remaining steam expands through the third-stage turbine to the condenser pressure of 3.5 lbf/in hps ...

A:

Q: As reported in the production of nylon intermediates. The separation and purification section for cy...

A: Azeotropic mixtures can be observed in chemical , pharmaceuticals industries. The system is said to ...

Q: How many grams of antifreeze would have to be added to 15 kg of water in the trucks cooling system t...

A: Given Details: Freezing point of pure water = 0°C Freezing point of solution = -20°C Mass of water =...

Q: A process for ethanol synthesis has been developed and the ethylene hydration operating conditions h...

A: The Vant's Hoff equation is relation between two equilibrium constants at their respective temperatu...

Q: Q2- Water flows inside a steel pipe with an ID of 2.5 cm. The wall thickness is 2 mm, and the convec...

A: Cylinder critical thickness of asbestos is the ratio of thermal conductivity of asbestos and convect...

Q: 25. In an aldehyde or ketone, the term a-carbon is applied to which of the following? a. A terminal ...

A:

Q: (b) Fig. Q3(b) shows the typical stress-strain curves for three different categories of materials. B...

A: ans.3(b)-i  From given Figure, Curve A suitably describes the property of Ceramics. while curve B sh...

Q: 1- If the process fluid is corrosive, what are the considerations that must be taken in the design o...

A: Given, Fluid is corrosive. What condition must be taken for design of a heat exchanger...

Q: The rate law for the reaction A +3B →C + 2D +E in an inert solvent (liquid) has been found to be (-r...

A:

Q: One kg of water at 305°C expands a piston in a cylinder until it reaches ambient pressure of 105kPa,...

A:

Q: Q3: A. The frictionless piston shown in Figure below has a mass of 20 kg. Heat is added until the te...

A:

Q: Q2/ A counter-flow double-pipe heat exchanger is to heat water from 20 °C to 80 °C at a rate of 1.2 ...

A: Given: For cold fluid (water): Tc1 = 20oCTc2 = 80oCmc = 1.2 kg/sCpc = 4.18 kJ/kg.oC For hot fluid (g...

Q: What is the capital cost of a plant that produces 250,000 tons per year of ethanol (fuel grade) cons...

A: Given: plant capacity(Q) =250,000 per year required to find capital cost using Bridgewater's method?...

Q: Use the van der waals constant for CH4 in table 1.3 to calculate the intial slopes of the plot of th...

A: Use the van der waals constant for CH4  a=2.26 atm-L2/mol2 b=0.0430 L/mol Boiling point=109.2K Fin...

Q: Q4/Prove that the heat transfer in a constant pressure is Q = W, K-1 Where Q: Heat transfer, W: Work...

A:

Q: Sketch a graph of the cooling curve. The data points do not have to be in the exact positions accord...

A: Data of Time(sec) vs Temperature (0C) is given  Find the graph of the cooling curve and when it begi...

Q: consider a steam power plant operating .8 on the ideal Rankine cycle. The steam enters the turbine a...

A: Given: given steam operating on a Rankine cycle with saturated liquid having From steam tables  for ...

Q: Fifty moles of ideal gas are to be expanded isothermally at 250°C from an initial pressure of 100 ba...

A:

Q: A mixture containing 30% acetone and 70% chloroform is extracted with a mixed solvent containing ace...

A: Given Feed=F, E=100 Kg Overall material balance, F+S=E+R F+S=100+R          (1) Component balance ov...

Q: Determine the concentration of a 187 L solution that contains 0.33 moles of NaCN. - report answer ou...

A: Given Volume of solution=187L Moles of NaCN=0.33 Find Concentration of NaCN

Q: nium has a density of 22.6 g/cm3. The mass of a block of osmium that measures 1.01 cm x 0.233 cm x 0...

A: As we know density= mass/ volume  Density of osmium 22.6g/cm^3  Volume of block=1.01*.233*.648cm^3  ...

Q: eN .O-S-0 HO Он но он O=D=O

A: Given, four molecular structures of respective types of surfactants. here, we need to identify the t...

Q: 2. In order to remember the difference between macroscopic and molecular scale energies, I... Answer...

A:

Q: 5. How does the Pump work input change when a simple ideal Rankine cycle is modified with reheating?...

A: Reheating is applied to increase the quality of steam at the exit of the turbine. This means to incr...

Q: (a) Discuss the concept of 'rate of chemical reaction' from the perspectives of reacting and product...

A: Rate of a chemical reactions tells us at what speed the reaction proceeds but it does not tell the e...

Q: What is the maximum change in entropy and work that can be produced in a steady state flow process f...

A: Given: 12 moles of nitrogen at 800 K and 50 bar, if the ambient temperature and pressure are at 300 ...

Q: Of the objects below,. _is the most dense. A an object with a volume of 3.91 x 10-24 nm³ and a mass ...

A: Calculate the density of each of the objects in one standard unit as g/m3. Carry out all the necessa...

Q: Q4: Join the following sentences using relative clauses (who, which, that, where). 1. This is the ho...

A: Relative Clauses Explanation Where - Refers to Place  Who - Refers to Person or Subject That - Refer...

Q: Estimate the molar volume of CO2 at 400 K and 125 atm by treating it as a Van der Waals gas.

A: From Van der Waals gas Equation we get, P = RT(Vm-b) - aV2m Rearrange this Equation and multiple by ...

Q: Aromatic, anti aromatic, or non aromatic

A: From Huckle  rule, The Given compounds is not forming conjugation. It is also not forming (4n +2) Pi...

Q: Evaporation of sweat requires energy and thus take excess heat away from the body. Some of the water...

A: There are two different heats that need to be calculated. For this purpose, the human body temperatu...

Q: 1: Air at 1.02 bar and 22°C initially occupying a cylinder of 0.015m3, is compressed reversibly and ...

A:

Q: At room temperature sucrose is hydrolyzed by the catalytic action of the enzyme sucrase as follows: ...

A:

Q: Sugarcane is produced by dissolving the sugar in the sugarcane in water, filtering the solution, hea...

A: The solubility chart is constructed from given data. The material balance of water of the total syst...

Q: Two well-known gas phase reactions take place in the dehydration of ethane: CH, - C2H + H2 C2H6 + H2...

A:

Q: Find the magnitude of the resulting complex number, 6 (cos 120° + i sin 120°) x 4 (cos 30° + i sin 3...

A: cos 120o = -12cos 30o = 32sin 30o = 12sin 120o = 32 First, simplify the given complex number as foll...

Q: A drum 8 in. in diameter and 45 in, long contained acetylene at 275 psia and 90oF.  After some of th...

A: Given Diameter of  drum= 8 in. Length of drum=45 in, long Initial pressure of acetylene =275 psia an...

Q: A cylinder piston contains 100/ air at 110 kPa. The air is then compressed in a reversible polytropi...

A:

Q: Question: 2. Given The Following Composition Of The Fuel Gas (Table 1 Supplied At 1 Atm, 80°F And 10...

A: Given Fuel gas supplied at (100% RH) T=80F P=1 atm Air supplied at (50% RH) T=80F P=1 atm No exce...

Q: What is the complete flue gas analysis and the orsat analysis? Given 70% Methane and 30% ethane were...

A: Hi and thanks for the question. Since you have not specified whether the fuel is burnt with O2 or ai...

Q: Q.)In the synthesis of ammonia stoichiometric amounts of N2 and H2 are sent to reactor where the fol...

A:

Q: Consider the following chemical reaction between component A and B: A(l) + 2B(g) → C(g)+ 3D(l) ….....

A: The given reaction is an exothermic reaction Exothermic reaction is one in which heat is evolved. He...

Q: The density of air under ordinary conditions at 25°C is 1.19 g/L. How many kilograms of air is in a ...

A: Given that density of air (d)=1.19 g/L dimension of room=11.0 ft×11.0 ft×10.0 ft  

Q: Steam undergoes an Isentropic process where it is initially at 1.05 MPa and 304C. The isentropic pro...

A: From the steam table, we will obtain the enthalpy and entropy for the given temperature and pressure...

Q: te fhe pressure in psid The boto -f spneical fank Oll. The top of the tank is vented to the atmosphe...

A:

Q: What is the value of the Langmuir constant "a"? *

A: Isotherm explains the change in amount of adsorbate with change in concentration. Langmuir adsorptio...

Q: A fuel containing 75% ethane and 25% propane is burned with dry air. All the H subscript 2 burns to ...

A: Given Fuel=75% ethane+ 25% propane Products-H2,H2O,CO2 and CO CO2/CO=10/1 Excess air=15% Find a. M...