The forklift travels forward with a constant speed of 0.27 m/sec. Determine the maximum deceleration (in the units of misec) of the torklift when the brake is applied without causing any of the wheels to leave the ground. The forklift has a mass of 1,040 kg with center of Gravity at G1, and the load mass 430 kg with center of gravity at G2. Neglect the weight of the wheels. G2 975 mm B.

The forklift travels forward with a constant speed of 0.27 m/sec. Determine the maximum deceleration (in the units of misec) of the torklift when the brake is applied without causing any of the wheels to leave the ground. The forklift has a mass of 1,040 kg with center of Gravity at G1, and the load mass 430 kg with center of gravity at G2. Neglect the weight of the wheels. G2 975 mm B.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The snowmobile has a mass of 200 kg, centered at G1, while the rider has a mass of 80 kg, centered at G2. If h = 0.8 m, determine the snowmobile’s maximum permissible acceleration so that its front skid does not lift off the ground. Also, find the traction (horizontal) force and the normal reaction under the rear tracks at A. Rounding numbers to 2 decimal places at the end. Gravity (the acceleration due to gravity) is 9.81 meters per second squared. g = 9.81 m/s2
The double pulley consists of two wheels which are attached to one another and turn at the same rate. The pulley has a mass of 15 kg and a radius of gyration kO=110mm. If the block at A has a mass of 40 kg, determine the speed of the block in 3 s after a constant force F=2kN is applied to the rope wrapped around the inner hub of the pulley. The block is originally at rest. Neglect the mass of the rope.
17-35. The sports car has a mass of 1.5 Mg and a center of mass at G. Determine the shortest time it takes for it to reach a speed of 80 km/h, starting from rest, if the engine only drives the rear wheels, whereas the front wheels are free rolling. The coefficient of static friction between the wheels and the road is u, = 0.2. Neglect the mass of the wheels for the calculation. If driving power could be supplied to all four wheels, what would be the shortest time for the car to reach a speed of 80 km/h? G 0.35 m A -1.25 m-- -0.75 m
The wheel has a mass of 100 kg and a radius of gyration of kO = 0.2 m. A motor supplies a torque M = (40u + 900) N #m, where u is in radians, about the drive shaft at O. Determine the speed of the loading car, which has a mass of 300 kg, after it travels s = 4 m. Initially the car is at rest when s = 0 and u = 0°. Neglect the mass of the attached cable and the mass of the car’s wheels
An inexperienced driver of a front drive car applies too much throttle in an attempt to accelerate from rest up the slippery 10 percent incline. The result is a wheel spin of the tires, each of which have the same gripping ability. Determine the vehicle acceleration for the conditions where the tire on the surface have ux = 0.01.
It takes 34 s for the 60-Mg tugboat to increase its speed uniformly to 25 km/h, starting from rest. The propeller provides the propulsion force F which gives the tugboat forward motion, whereas the barge moves freely. The barge has a mass of 84 Mg . (A) Determine the force of the rope on the tugboat. Express your answer to three significant figures and include the appropriate units. The answer is not 17145.882
Determine the deceleration of (a) a 2200-kg car and (b) a 1100-kg car, if thebrakes are suddenly applied so that all four tires slide. The coefficient of friction η=0.6 on the dry asphalt. (η = F/N where N is the normal force and F is the frictional force). Give the complete solution with free body diagram.
If the track is designed so that the passengers of the roller coaster do not experience a normal force less than 1/2 or more than 3 times their weight, determine the limiting heights hA and hC so that this does not occur. The roller coaster starts from rest at position A. Neglect friction. Please show every single step of the process
It takes 34 s for the 60-Mg tugboat to increase its speed uniformly to 25 km/h, starting from rest. The propeller provides the propulsion force F which gives the tugboat forward motion, whereas the barge moves freely. The barge has a mass of 84 Mg . (A) Determine the force of the rope on the tugboat. Express your answer to three significant figures and include the appropriate units. The answer is not 17145.882 or 12254.12 N
The 100-kg spool is resting on the inclined surface for which the coefficient of kinetic friction is μk = 0.13. The radius of gyration about the mass center is kG = 0.22 m Determine the angular velocity of the spool, measured clockwise, when t = 7 s after it is released from rest. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise
The disk rotates at a constant acceleration of 0.005 revolutions per second and starts movement from rest, and what is its angular speed after one minute 1 If an external force does not act on an object, that means: 2. If the body is in free fall then: 3- One of the ways in which the friction between the contact surfaces can be reduced 1 ................ f
The spring-held follower AB has a mass of 0.5 kg and moves back andforth as its end rolls on the contoured surface of the cam, where r = 0.15 m and z =(0.02 cos 2θ) m. If the cam is rotating at a constant rate of 30 rad/s, determine theforce component Fz at the end A of the follower when θ = 30°. The spring isuncompressed when θ = 90°. Neglect friction at the bearing C.