The gate is designed to hold water and spin about the hinge at point A. The gate is an isosceles triangle, hinged at the base, forming a = 39° angle with the horizontal. If the total water level is h = 6.0 ft, what is the moment created by the water force on the gate? The base width is 2.5 ft h Water Gate Hinge A Ө

The gate is designed to hold water and spin about the hinge at point A. The gate is an isosceles triangle, hinged at the base, forming a = 39° angle with the horizontal. If the total water level is h = 6.0 ft, what is the moment created by the water force on the gate? The base width is 2.5 ft h Water Gate Hinge A Ө

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The face of a dam adjacent to the water has the shape of an isosceles trapezoid of altitude 20 m, upper base 50 m, and lower base 40 m. Find the total force exerted by the water on the dam when the water is 15 m deep.
The gate of the figure supports a maximum moment of 180kN-m in the support in a. Determine the height maximum h of water that supports. The width is 2.0m. mass of the gate 1000 kg.
Find the total (resultant) pressure acting on the tail end of the container containing gasoline (S = 0.7) accelerating at 3m/sec² to the right.
Find the resultant force and its direction which is exerted on the hemi-sphere shape of gate as shown in figure below.
Find the force P required to hold the gate in the position as shown in the figure. The gate is 5 meters wide.
If the vertical wall is 20 feet wide. Calculate the force on the wall caused by the water pressure and locate its center of pressure. Also determine the moment exerted by the force at the base of the wall.
The distance between the two plates, which are 2 m x 2 m in size and parallel to the earth surface, is 9 mm, and there is water at 20 ° C between them. Find the force in (N) to be applied to pull the top plate to the right at 10 m / s.
The 5-m wide sluice gate “ab” shown, tangent to the vertical wall at “a”, holds back water. The surface of the gate in contact with the water can be taken as part of a cylinder with radius 4 m. a. Determine the horizontal force acting on the curve. b. Determine the total force on the curve. c. Determine the location of the vertical force from pt. “a”.
The tank is filled with water. Suppose that h=4.0 m. Solve the problem using the integration method. Determine the resultant force acting on the trapezoidal plate C and determine the location of the center of pressure measured from the top of the tank.
Fluid Mechanic: The homogeneous timber AB as shown in the diagram is 0.15 m X 0.35 m in cross section. Determine the specific weight of the timber and thetension in the rope.
The corner plate of the ship's hull is bent at a radius of 1.5 meters, following the arc of a circle. What is the magnitude of the force applying on the curved corner plate for 1 meter length of the hull section if the bottom of the hull is 4.3 m below the seawater (S.G. = 1.03) surface?
an oil tank is in the shape of a right circular cylinder with a radius of r meters and its axis is horizontal. if the tank is half full of oil having mass density 750 kg per cubic meter, find r if the total force on one end of the tank due to liquid pressure is 8000 N