The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB is 6.9 kN. Determine the required tension Tin cable AC such that the net effect of the two cables is a downward force at point A. Determine the magnitude R of this downward force.

The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB is 6.9 kN. Determine the required tension Tin cable AC such that the net effect of the two cables is a downward force at point A. Determine the magnitude R of this downward force.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 12.5CYU: Check Your Understanding For the situation in described in Example 12.5, determine the values of the...

See similar textbooks

Related questions

Q: Consider that a heart of defibrillator uses 404 j of energy in 11 ms What is the average power…

Q: Find the time taken 48 w bulb to consume 2400 J of energy?

A: Introduction : In this question we are provided with value of power and energy consumed . with…

Q: A motorcycle has a constant speed of 24.2 m/s as it passes over the top of a hill whose radius of…

Q: Question 3-a, Numerical: A crane is used to carry a heavy container of 1000 kg as shown in the…

A: Please see the answer below.

Q: Diagram of the problem, necessary formulas, clearance and numerical solution. An electric light…

Q: 2. The resultant of three parallel loads (one load is missing) is 50lb acting up at 12ft to the…

A: Given Resultant force = R = 50 lb Three forces are acting as shown in the figure 50 lb acting in…

Q: A baseball is thrown toward a player with an initial speed of 36.6 m/s at 50⁰ with the horizontal.…

A: In the given question, Initial velocity of projectile (u) = 36.6m/s Angle of projectile (θ) = 500…

Q: Also calculate the size of the image formed.

A: Given data; A concave lens has focal length,l=20cm distance,h=5 cmit forms an image at 15 cm from…

Q: Q5: Consider a particle of mass m in a 1) 2) 3) 4), two-dimensional box having side length L and L…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Find the Mass value Momentum 45 kg*m/s Velocity=2 m/s

A: Given data: Momentum (P) = 45 kg.m/s Velocity (v) = 2 m/s Required: Mass (m)

Q: Two skydivers are holding on to each other while falling straight down at a common terminal speed of…

A: In the given question, Initial terminal velocity of both skydivers is (u) = 51.1m/s Mass of first…

Q: 3. A football is kicked at 37.0° to the horizontal at 20.0 m/s from the player's hand at 1.00 m from…

Q: Find the mass of a car that drives at 8m/s and has 2300 J of energy.

A: Answer:- Given Speed (V) = 8 m/s Kinetic energy (K.E) = 2300 J Mass of a car(m) = ? We know you…

Q: 3. A stone is thrown off the edge of a cliff that is 16.0 m tall with an initial horizontal velocity…

Q: Someone launches a ball straight up releasing it when it reaches the top of their head. The ball…

Q: Find the Force Impulse 20 N*s Time=2 s

A: Write the given values with the suitable variables. J=20 N·st=2 s Here, J is the impulse and t is…

Q: A child is sitting on the outer edge of a merry-go-round that is 18 m in diameter. If makes 5.4…

A: Determine the angular velocity.

Q: A 40 cm long copper wire carries a current of 6 A and weighs 0.35 N. A certain magnetic field is…

A: Given data: Length (L) = 40 cm = 0.40 m Current (I) = 6 A Force (F) = 0.35 N Required: Magnetic…

Q: Q6: 100 g of radioactive element X are placed in a sealed box. The half-life of this isotope of X is…

A: Disclaimer: Since you have posted two questions and no specific question number is mentioned, we…

Q: . Explain with the help of a diagram,

A: Given; Why pencil partly immersed in water appears to be bent at the water surface. Explain with…

Q: 6. A car, travelling at 40m/s slows to 10m/s in 5 seconds. What was the acceleration? A). -6 m/s2…

Q: what is the dot product of C and E, if C = 3.45i - 3.5j + 3.48k and E = -3.6i - 7.11j + 3.13k?

Q: A ball of mass 6 kg is thrown up with a speed of 15 m/s. find the kinetic energy of the ball at the…

Q: A ship's sonar uses a frequency of 22.5 kHz. The speed of sound in seawater is 1533 m/s. a). Draw a…

A: (b) Here, fs=22.5KHz, v=1533m/s, vs=-4.15m/s, vd =0 Frequency received is fd=fs(v-vd)/(v-vs) =…

Q: 7. The point charge Q 18 nC has a velocity of 5×106 m/s in the direction a= 0.30a+ 0.40az. Calculate…

A: Write the expression for the force exerted by the electric field and magnetic field together. Here,…

Q: Find the difference in Second and first excited state energies 3-D (AE) of Partick in 01-0 2-D and…

A: We have a particle of mass say m which is in a infinite potential region of (1) length L, (2) 2-D…

Q: Find the distance covered by bus Speed=45 km/hr Time-2.3 hr

A: Given data: Speed (v) = 45 km/hr Time (t) = 2.3 hr Required: The distance (d)

Q: Find the time taken 48 w bulb to consume 2400 J of energy?

Q: 1. A truck has lost its brake and falls into 25.0 m deep ravine and lands at a distance of 30.0 m…

A: "Since you have asked multiple questions, as per instructions to us, we will solve the first…

Q: If you have an object moving along a rough surface (one in which kinetic friction is a significant…

Q: How much electric energy is delivered to a 60 W lightbulb if the bulb is left on for 2.5 hours? Show…

Q: If a car travelling at 64 m/s is subjected to a steady deceleration of 16 m/s², how long will it…

Q: 10. A flat sheet of paper of area 0.830 m² is oriented so that the normal to the sheet is at an…

A: Answer:- Given Area of a flat sheet of paper (A)=0.830 m2 Angle (theta) = 75o Electric field (E)…

Q: A crate of mass 105 kg is pushed along a floor with a force of 30 N for a distance of 18 m. Find the…

Q: The difference between the calculated mass of an atom and the actual atomic mass is referred to as…

A: When mass of nucleus is measured, it is found that the mass of nucleus is less than the sum of the…

Q: The speed at which a grandfather clock runs is controlled by a swinging pendulum. a) If you find…

A: The speed at which a grandfather clock runs is controlled by a swinging pendulum

Q: Determine the voltage at resistor R1 the LED forward voltage is 2.0 volts. * D1 D3 R1 1K 5V D2

Q: A 40 cm long copper wire carries a current of 6 A and weighs 0.35 N. A certain magnetic field is…

Q: when you use lights from battery does it have decrease the same voltage every hour or it depends

Q: 2. A baseball is thrown horizontally with an initial velocity of 25 m/s from a height of 1.5 m. How…

Q: A car travels northward at 75km/h along a straight road in a region where Earth’s magnetic field has…

Q: (b) what is the initial y-component of the velocity? (use energy methods)

A: b) Consider the y-component of initial velocity is viy. Apply the energy conservation equation…

Q: the mine transfers enough energy by heat to the mine's cooling systems to melt 363147 kg of ice at…

A: Given : Mass of ice (m) = 363147 kg Energy increased by 9.3 % Latent Heat of fusion of Ice (L) =…

Q: Two horses are pulling a barge with mass 2000 kg along a canal, as shown in the figure. The cable…

A: In the given question, Mass of the barge (m) = 2000kg Angle made by 1st horse with the canal (θ1) =…

Q: Add the following component vectors and determine the resultant. (You might want to draw them).…

Q: The inverse square law which you were initially introduced to applying to gravity, applies to Light…

A: Solution:-

Q: resonance refers to a reduction in the amplitude of a wave as a result of energy absorption or…

A: In the given question, there is a statement: Resonance refers to a reduction in the amplitude of a…

Q: Given data: Force 20.08 N Distance = 10.05 m Calculate work done ?

A: Introduction : In this question we are provided with value of distance and force . With these data…

Q: -2 A car accelerates with a constant acceleration of 2.1 m. s along a long straight road. How long…

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

100%

Kindly provide the full solution. Thank you!

The guy wires AB and AC are attached to the
top of the transmission tower. The tension in
cable AB is 6.9 kN. Determine the required
tension Tin cable AC such that the net effect of
the two cables is a downward force at point A.
Determine the magnitude R of this downward
force.
Assume a = 31 m, b = 41 m, c = 21 m, and d = 28
m.
B
Answers:
T =
KN
R =
KN
<X

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Derive an expression for the magnitude of the couple M required to maintain the equilibrium of the linkage shown.
Why must cables run above drop ceiling tiles be plenum rated?
The walkway ABC of the footbridge is stiffened by adding the cable ADC and the short post of length L. If the tension in the cable is not to exceed 420 lb, what is the smallest value of L for which the 160-lb person can be supported at B?
Determine the tension in cable AD, BD & CD.
How much compression acts on the hip during two-legged standing, given that the joint supports 250 N of body weight and the abduct muscles are producing 600 N of tension? What is the angle α of R?
While installing new spark plugs in your car, the manual specifies they be tightened to 43 Nm. If you can only apply a force to the wrench 22 cm from the plug, and only at an angle of 62 degrees, What magnitude force should you apply to the wrench?
How far from Q 2 must Q 3 be located so that the forces on Q 2 are at equilibrium ? ( Ans: 16.5 cm)
A uniform ladder of mass (m = 13.0 kg) and length (L) leans against a frictionless wall, see figure. If the angle θ = 50.0°, find the static friction force between the ladder and the floor when a 85.0-kg person stands quarter of the way up the ladder?
A 400-gram package lying on a horizontal surface is attached to a horizontalstring which passes over a smooth pulley.When a mass of 200 grams is attached to the other end of the string,the package is on the point of moving.Find , the coefficient of friction.
A train, traveling at 66 mi/h, rounds a horizontal curve of 390 ft radius. A passengerstanding in the lounge notes that she mustlean inward to keep from falling. Let an angle leaning inward be positive and outward benegative.At what angle from vertical must she lean?Since the radius of the curve is much greaterthan the height of the passenger, neglecttorques. 1 mile = 5,280 ft.Answer in units of ◦.
solve the 260 N force of fig as shown into two components with one acting along AB and the other passing through the point C
A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes, as indicated by the blue vectors. Find the tension in each rope when a 700 N person is d = 0.500 m from the left end