The hemispherical dome in weighs 36.9 kN and is filled with water and attached to the floor by 6 equally spaced bolts. What is the force in KN in each bolt required to hold down the dome? Radius of the dome is 3 m, height of the pipe is 4 m and diameter of the pipe is 5 cm. Unit weight of water is 9.80 KN/m3. BOLTS

The hemispherical dome in weighs 36.9 kN and is filled with water and attached to the floor by 6 equally spaced bolts. What is the force in KN in each bolt required to hold down the dome? Radius of the dome is 3 m, height of the pipe is 4 m and diameter of the pipe is 5 cm. Unit weight of water is 9.80 KN/m3. BOLTS

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A circular door having a diam. of 3m closes a horizontal duct from a small diam. as shown. The center of the door is 4.5m below the dam’s water level. Assuming the unit weight of water is 9.79 kN/m3. Compute the hydrostatic force acting on the door.
A rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is accelerated horizontally at 2.5 m/s2 in the direction of its length. A. Determine the net force due to water acting on each end of tank. B. Determine the minumum pressure intensities at bottom C. Determine the slope of the free surface
Solve using the spefic weight of water which is 62.4 lb/ft^3
A closed rectangular tank measuring 4 m long, 8.89m wide, and 3m high is filled to a depth of 1.8m with oil (SG=0.8). The tank is attached to a truck that is traveling horizontally at 9.81m/s^2. Determine the allowable force (kN)at the rear wall of the tank.
A dam with specific weight of 24 kN/m3, has dimensions of 6m on top, 20m at the bottom and 27m high has water 22m deep acting on its vertical side. Compute the location of the vertical resultant force from the toe. CHOICES: a.) 8.01 b.) 18.10 c.) 1.80 d.) 10.81
An open horizontal tank 2 m high, 2 m wide and 4m. long is full of water. a) How much water is spilled out when the tank is accelerated horizontally at 2.45 misec in a direction parallel with its longest side? b.) What is the porce acting on the side with the greatest depth? c.) Compute the required accelerating force.
An open tank 1.82m square weighs 3.425 kN and contains 0.91m of water. It is acted by an unbalanced force of 9.4 kN parallel to a pair of sides. What is the force acting in the side with the smallest depth?
Determine the horizontal and vertical components of the resultant force the water exerts on plate AB and on plate BC. The width of each plate is 1.5 m.
Water flows at a rate of 3 m3/s through a 300 mm diameter pipe in which there is a 90 degreebend.(a) if the pressure at the entrance to the bend is 450 kN/m2 (absolute), determine the total force necessary to anchor the bend. FricLon losses can be neglected (b) if the bend was only 60 degree, by how much would the anchoring force change?
The concrete dam of trapezoidal cross section is shown with T = 1m, B = 4.3m, H = 9m and h = 6m. The unit weight of the concrete is 24??⁄?3. For the given conditions, evaluate the resisting moment of the dam to overturning in kN.m per meter length of dam. Unit of the Correct Answer: kN-m
A Triangular gate having a horizontal base of 1.30 m and an altitude of 2 m is inclined 45o from the vertical with vertex pointing upward. The base of the gate is 2.70 m below the surface of oil (s = 0.80). What normal force must be applied at the vertex of the gate to open it? Show figure
The crest gate on the dam (refer to figure) forms the arc of a circle of 3m radius subtending 45° at the hinge. The gate is 3m long. With water surface at as shown, compute the amount and location of horizontal and vertical components of hydrostatic pressure on the gate.