MCQ question 14-Vertical axismr= 0,5 mThe horizontal table in the figure is rotated with an angular velocity w = 4 rad/saround the vertical axis passing through point O. The object with a mass of10kg, located 0.5 m away from point O, stands without slipping. What is thesmallest value of the friction coefficient between the object and the table?(Assume that g= 10m/s*)m =a)0.16b)0.420.800.60e)0.24Boş bırak

Angular speed, w = 4 rad/s radius, r = 0.5 m mass, m = 10 kg g = 10 m/s2

The horizontal table in the figure is rotated with an angular velocity w = 4 rad/s around the vertical axis passing through point O. The object with a mass of m = 10kg, located 0.5 m away from point O, stands without slipping. What is the smallest value of the friction coefficient between the object and the table? (Assume that g = 10m/s) %3D %3D %3D

The horizontal table in the figure is rotated with an angular velocity w = 4 rad/s around the vertical axis passing through point O. The object with a mass of m = 10kg, located 0.5 m away from point O, stands without slipping. What is the smallest value of the friction coefficient between the object and the table? (Assume that g = 10m/s) %3D %3D %3D

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter6: Uniform Circular Motion And Gravitation

Section: Chapter Questions

Problem 9PE: Construct Your Own Problem Consider an amusement park ride in which participants are rotated about a...

See similar textbooks

Similar questions

An automobile engine can produce 200 N m of torque. Calculate the angular acceleration produced if 95.0% of this torque is applied to the drive shaft, axle, and rear wheels of a car, given the following information. The car is suspended so that the wheels can turn freely. Each wheel acts like a 15.0 kg disk that has a 0.180 m radius. The walls of each tire act like a 2.00-kg annular ring that has inside radius of 0.180 m and outside radius of 0.320 m. The tread of each tire acts like a 10.0-kg hoop of radius 0.330 m. The 14.0-kg axle acts like a rod that has a 2.00-cm radius. The 30.0-kg drive shaft acts like a rod that has a 3.20-cm radius.
A cat usually lands on its feet regardless of the position from which it is dropped. A slow-motion film of a cat falling shows that the upper half of its body twists in one direction while the lower half twists in the opposite direction. (See Fig. CQ11.10.) Why does this type of rotation occur?
Many of the elements in horizontal-bar exercises can be modeled by representing the gymnast by four segments consisting of arms, torso (including the head), thighs, and lower legs, as shown in Figure P8.15a. Inertial parameters for a particular gymnast are as follows: Note that in Figure P8.l5a rcg is the distance to the center of gravity measured from the joint closest to the bar and the masses for the arms, thighs, and legs include both appendages. I is the moment of inertia of each segment about its center of gravity. Determine the distance from the bar to the center of gravity of the gymnast for the two positions shown in Figures P8.15b and P8.15c. Figure P8.15
A carnival carousel accelerates nonuniformly from rest, moving through an angle of 8.60 rad in 6.00 s. If its turning at 3.30 rad/s at that time, find (a) its average angular speed, and (b) average angular acceleration during that time interval. (See Section 7.1.)
A grindstone increases in angular speed uniformly from 4.00 rad/s to 12.0 rad/s in 4.00 s. (a) Calculate the grindstones angular acceleration. (b) Through what angle does it turn during that time? (See Section 7.2.)
A student rides his bicycle at a constant speed of 3.00 m/s along a straight, level road. If the bikes tires each have a radius of 0.350 m, (a) what is the tires angular speed? (See Section 7.3.) (b) What is the net torque on each tire? (See Section 8.5.)
Construct Your Own Problem Consider an amusement park ride in which participants are rotated about a vertical axis in a cylinder with vertical walls. Once the angular velocity reaches its full value, the floor drops away and friction between the walls and the riders prevents them from sliding down. Construct a problem in which you calculate the necessary angular velocity that assures the riders will not slide down the wall. Include a free body diagram of a single rider. Among the variables to consider are the radius of the cylinder and the coefficients of friction between the riders' clothing and the wall.
A cat usually lands on its feet regardless of the position from which it is dropped. A slow-motion film of a cat falling shows that the upper half of its body twists in one direction while the lower half twists in the opposite direction. (See Fig. CQ8.14.) Why does this type of rotation occur? Figure CQ8.14
What is- the magnitude of the angular acceleration of a 25.0-kg disk of radius 0.800 m when a torque of magnitude 10.0 N m is applied to it? (See Section 8.5.)
Everyday application: Suppose a yo-yo has a center shaft that has a 0.250 cm radius and that its string is being pulled. (a) If the string is stationary and the yo-yo accelerates away from it at a rate of 1.50 m/s2, what is the angular acceleration of the yo-yo? (b) What is the angular velocity after 0.750 s if it starts from rest? (c) The outside radius of the yo-yo is 3.50 cm. What is the tangential acceleration of a point on its edge?
A worker applies a torque to a nut with a wrench 0.500 m long. Because of the cramped space, she must exert a force upward at an angle of 60.0 with respect to a line from the nut through the end of the wrench. If the force she exerts has magnitude 80.0 N, what magnitude torque does she apply to the nut?
A simple pendulum consists of a small object of mass 3.0 kg hanging at the end of a 2.0-m-long light string that is connected to a pivot point. (a) Calculate the magnitude of the torque (due to the force of gravity) about this pivot point when the string makes a 5.0 angle with the vertical. (b) Does the torque increase or decrease as the angle increases? Explain. Figure P8.6