The inductor in (Figure 1) is a 9.0-cm-long, 2.0-cm-diameter solenoid wrapped with 300turnsPart AWhat is the current in the circuit 10 us after the switch is moved from a to b?Express your answer with the appropriate units.HA?I =ValueUnitsSubmitPrevious Answers Request AnswerX Incorrect; Try Again; 26 attempts remainingProvide FeedbackFigure< 1 of 1>30 2ab6.0 V

Given: l = 9cm = 0.09m D = 2cm , R = 1cm = 0.01m N = 300

Answered: The inductor in (Figure 1) is a…

Science

Physics

The inductor in (Figure 1) is a 9.0-cm-long, 2.0-cm-diameter solenoid wrapped with 300 turns.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 55P: How long after switch S1 is thrown does it take the current in the circuit shown to reach half its...

See similar textbooks

Related questions

Q: List whether the induced voltage from the inductor (L) is positive, negative, or zero from points A…

A: In the given question, We have to discuss about the induced voltage is positive, negative or zero,…

Q: B α (0 a F An alternating current generator has a square loop (with side length a) mounted on a…

Q: A coil with 150 turns, a radius of 4.2 cm , and a resistance of 19 Ω surrounds a solenoid with 150…

A: The magnetic field in the solenoid is,The flux through the solenoid and the surrounding coil is,The…

Q: A long solenoid of radius a carrying N turns per unit length is looped by a wire of resistance R (as…

A: Mutual Inductance when two coils are linked with each other in such a manner that the flux in one…

Q: If a solenoid is 10 cm long and has a radius of 1 cm, how many coils would be necessary to make an…

Q: What is the value of the inductor?

Q: Figure below shows the current as a function of time through a 20 (cm) long, 4.0 (cm) diameter…

Q: The large loop shown has a diameter of 73 cm and carries a constant 6 A current. The loop rotates…

Q: Shown in the figure below is a rectangle of wire immersed in a magnetic field. The rectangle has…

A: Given : l=2 m w=2 m R=7.02 ohm B(t)=5t3+2t4

Q: Calculate the inductance of a solenoid with 146 turns if the length of the solenoid is 18_cm and its…

Q: A solenoid passes through the center of a wire loop, as shown in (Figure 1). The solenoid has 1200…

Q: A 650-turn solenoid, 25 cm long, has a diameter of 2.2 cm. A 11-turn coil is wound tightly around…

Q: The above inductor consists of two solenoids (radius b, n turns/meter, and radius a, 2n turns/meter)…

Q: How does the self-inductance per unit length near the center of a solenoid (away from the ends)…

A: The expression for the self inductance , L=μN2Al

Q: The rectangular loop in the figure has 1.9×10−2 Ω resistance. What is the induced current in the…

A: According to Ampere's Law ∫B.dl=μ∘I Emf in loop is equal to rate of change in magnetic flux. ε=dϕdt…

Q: Using these data, discuss this situation in your group and determine the emf of the battery, the…

Q: Referring to the configuration shown on the right, a) determine the force between these conductors…

Q: A 110 V direct current motor generates a back-emf of 98 V when it runs at full speed. If the…

Q: Observe the following images: അ000000 അ a b) അ അ c) d Assuming the solenoids are equal, which…

Q: A coil with a self-inductance of 2.0 H carries a current that varies with time according to…

Q: Three rectangular loops move near a long straight wire carrying a constant current, as shown below.…

A: Answer Correct option is e) B and C

Q: 2. The loop of wire in the diagram below forms an equilateral triangle 20 cm on a side. (a)What is…

Q: Find the inductance and induced emf for a solenoid with a cross-sectional area of 1.3 × 10-3m2. The…

A: Given: Cross-sectional area of solenoid = 1.3×10-3 m2. Length of solenoid l = 9.0 cm. = 9×10-2 m.…

Q: At what speed (in meters per second) must the sliding rod in the figure below move to produce an emf…

Q: Please show how much current is on the battery and on each resistor and the inductor at T is equal…

Q: For the transformer shown in Figure Q3(a), determine the following: i. The turns ratio of the…

Q: The figure below is a top down view of a circular wire coil with rotating clockwise in a uniform…

A: This question can be solved by using the concept of Faraday's law , Lenz law and the force on a wire…

Q: In the circuit shown in figure, switch S is closed. At some time t afterward, the current il is 10A…

Q: vo coils connected as shown in the figure separately have inductances L1 = 34 m H. What is the…

A: Given:- Two coils connected as shown in the figure separately have inductance L1 = 34 mH and L2 =…

Q: At what speed must the sliding rod in the figure below move to produce an emf of 1.10 V in a 1.77 T…

Q: A metal disc of radius 25 cm is rotated at 2000 rpm on a horizontal axis. Two brushes make contact…

Q: Assume that the battery shown in Figure Q31.13a is replaced by an alternating current source and…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

The inductor in (Figure 1) is a 9.0-cm-long, 2.0-cm-diameter solenoid wrapped with 300
turns
Part A
What is the current in the circuit 10 us after the switch is moved from a to b?
Express your answer with the appropriate units.
HA
?
I =
Value
Units
Submit
Previous Answers Request Answer
X Incorrect; Try Again; 26 attempts remaining
Provide Feedback
Figure
< 1 of 1>
30 2
a
b
6.0 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
Does self-inductance depend on the value of the magnetic flux? Does depend on the current through the wire? Correlate your answers with the equation N=LI
For the circuit shown below, find the current through the inductor 2.0105 s after the switch is reopened.
Check Your Understanding A long solenoid of cross-section area 5.0 cm2is wound with 25 turns of wire pet centimeter. It is placed in the middle of a closely wrapped coil of 10 turns and radius 25 cm, as shown below. (a) What is the emfInduced In the coil when the current through the solenoid Is decreasing at a rate dl/dt= -0.20A/s? (b) What Is the electric field Induced In the coil?
Check Your Understanding. Current flows through the inductor in Figure 14.8 from B to A instead of from A to B as shown. Is the current increasing or decreasing in order to produce the emf given in diagram (a)? In diagram(b)?
The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In each case, determine which end of the inductor is at the higher potential.
How long after switch S1 is thrown does it take the current in the circuit shown to reach half its maximum value? Express your answer in terms of the time constant of the circuit.
(HELP ASAP I DONT NEED LONG EXPLANATIONS FASTER RESPONSE WITH CORRECT OPTION WILL BE MUCH BETTER) The stored energy in an inductor is 25 mJ. Given that a current with a magnitude of 60x10^-3 A flows through it, we need to calculate the value of the stored magnetic energy when it becomes four times its initial value.
An inductor has an inductance of 0.21 mH. Calculate the number of turns per unit length of this inductor if it has a total of 575 turns in it. The cross-sectional area of the solenoid is 2.00 cm2. Take ??μo (permeability of the free space) = 4*Pi*10-7 T.m/A Round off your answer to zero decimal place before submitting it . You are required to show your work in the file you submit.
What is the magnetic field due to an inductor of length 10 cm that has300 turns if 0.25 A of current passes through it? What is its inductance ifthe cross sectional area of the inductor is 1.5 cm2?
For the following scenarios derive the required mathematical model in the form of a differential equation: The instantaneous current ? at the time ? in a simple DC RL circuit. The displacement ? of a mass ? on a spring when the mass is pulled down from its equilibrium position and released when there is a damping force proportional to the velocity.
Experimentally, the magnetic flux ΦB in a solenoid was measured for various currents ?. The data was recorded in the table and plotted in the graph. The best fit line through the data was also drawn. Current (A) Magnetic flux (Wb) 0.750 2.00 1.75 4.00 2.50 6.50 What is the inductance of the solenoid? inductance=???