B α (0 a F An alternating current generator has a square loop (with side length a) mounted on a vertical shaft as shown in the figure. This square is rotating at angular velocity w. A uniform magnetic field 3 points to the right. The figure at the bottom shows the view from the above and s is the surface vector of the loop. Determine the induced emf, E(t) for this generator.

B α (0 a F An alternating current generator has a square loop (with side length a) mounted on a vertical shaft as shown in the figure. This square is rotating at angular velocity w. A uniform magnetic field 3 points to the right. The figure at the bottom shows the view from the above and s is the surface vector of the loop. Determine the induced emf, E(t) for this generator.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 10CQ: The normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially...

See similar textbooks

Similar questions

The north pole of a mag’iet is moved toward a copper loop, as shown below. If you are looking at the loop from above the magnet, will you say the induced convent is circulating c1ockise or counterclockwise?
The normal to tt plane of a single-turn conducting loop is directed at an angle to a spatially uniform magnetic field B. It has a fixed area and orientation relative to the magnetic fleck Show that the emf induced In the loop is given by i = (dB/dt)(Acos),where A is the area of the loop.
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
The circular conducting loops shown in the accompanying figure are parallel, perpendicular to the plane of the page, and coaxial. (a) When the switch S is dosed, what is the direction of the cun’ent induced in D? (b) When the switch is opened, what is the direction of the current induced in loop D?
Use Lenz’s law to determine tl direction of induced current in each case.
A square loop of side 2 cm is placed 1 cm from a long wire carrying a current that varies with time at a constant rate of 3 A/s as shown below. (a) Use Ampere’s law and find the magnetic field as a function of time from the current in the wire. (b) Determine the magnetic flux through the loop. (c) If the loop has a resistance of 3 how much induced current flows in the loop?
Suppose the magnetic field of the preceding problem oscillates with time according to B=B0sint . What then isthe emf Induced in the loop when its trailing side Is a distance d from the right edge of the magnetic field region?
A rectangular copper loop of mass 100 g and resistance 0.2 is in a region of uniform magnetic field that is perpendicular to the area enclosed by the ring and horizontal to Earth's surface (see below). The loop is let go from rest what it is at the edge of the nonzero magnetic field region. (a) Find an expression for the speed when the loop just exits the region of uniform magnetic field. (b) If it was let go at t = 0, what is the tune when it exits the region of magnetic field for the following values, a=25cm,b=50cm,B=3T,g=9.8m/s2 ?Assumethat the magnetic field of the induced current is negligible compared to 3 T.
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
If electric and magnetic field strengths vary sinusoidally in time at frequency 1.00 GHz, being zero at t=0, then E=E0sin2ft. (a) When are the field strengths next equal to zero? (b) 4Jhen do they reach their most negative value? (c) How much time is needed for them to complete one cycle?
A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
A uniform magnetic field B=5.44104iT passes through a closed surface with a slanted top as shown in Figure P31.59. a. Given the dimensions and orientation of the closed surface shown, what is the magnetic flux through the slanted top of the surface? b. What is the net magnetic flux through the entire closed surface?