The jaws and bolts of the wood clamp in Fig- are parallel. The bolts pass through swivel mounts so that no moments act on them. The clamp exerts forces of 300 N on each side of the board. Treat the forces on the boards as uniformly distributed over the contact areas and determine the forces in each of the bolts. Show on a sketch all forces acting on the upper jaw of the clamp. D 100 mm 150 mm B H00 mm75 mm-100 mm-

The jaws and bolts of the wood clamp in Fig- are parallel. The bolts pass through swivel mounts so that no moments act on them. The clamp exerts forces of 300 N on each side of the board. Treat the forces on the boards as uniformly distributed over the contact areas and determine the forces in each of the bolts. Show on a sketch all forces acting on the upper jaw of the clamp. D 100 mm 150 mm B H00 mm75 mm-100 mm-

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.97P: The figure shows a wire cutter. Determine the cutting force on the wire at A when the 75-N forces...

See similar textbooks

Similar questions

The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A caused by the applied force P.
Find the internal force system acting on section 3 for the pin-connected frame.
Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
The homogeneous 20-kg door is held in the horizontal plane by a thrust hinge at O, a hinge at A, and the vertical prop BC. Determine all forces acting on the door.
The linkage is made of two homogenous bars of weights shown in the figure. Determine the horizontal force P required to hold the linkage in the position shown.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
The 1800lbin. couple is applied to member DEF of the pin-connected frame. Find the internal force systems acting on sections 1 and 2.
If the input force to the compound lever is P = 30 lb, calculate the output force Q.
Find the tension T in the cable when the 180-N force is applied to the pedal at E. Neglect friction and the weights of the parts.
The 350-lb homogeneous plate has the shape of an isosceles triangle. The plate is supported by a thrust hinge at A, a slider hinge at B, and the cable CD. Find the force in the cable and the magnitudes of the hinge reactions.
The uniform ladder of weight W is raised slowly by applying a vertical force P to the rope at A. Show that P is independent of the angle .
Find the force P required to (a) push; and (b) pull the 80-lb homogeneous roller over the 3-in. curb.