The LC-3 ISA has been augmented with the following push and pop instructions. Push Rn pushes the value in Register n onto the stack. Pop Rn removes a value from the stack and loads it into Rn. The following figure shows a snapshot of the eight registers of the LC-3 BEFORE and AFTER the following six stack operations are performed. Identify (a)-(d).

The LC-3 ISA has been augmented with the following push and pop instructions. Push Rn pushes the value in Register n onto the stack. Pop Rn removes a value from the stack and loads it into Rn. The following figure shows a snapshot of the eight registers of the LC-3 BEFORE and AFTER the following six stack operations are performed. Identify (a)-(d).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1.Show the status of PSW (Program status word) after addition of two 8bit numbers 26H and 3FH. Also draw status of flag register with help of diagram? 2. Mention the addressing mode, function and how many bytes instruction for the following instructions? ADI 42H b. LXI H, 2500H c. RLC 3. Write assembly language program to add to 8-bit numbers with carry. First numbers stored on memory location 2500h, second number on 2501H and store 8bit result on memory location 2502H and carry on 2503H.
Does your data table verify Ohm’s law ?
Suppose that initially the contents of the registers are A:A7 B:69 SP:004E Y:B804and that memory locations 0048 through 004F initially contain all zeros. The commands PSHY, PSHB, PULY, PSHA are then executed in sequence. List the contents of the registers A, B, SP,and X and the memory locations 0048 through 004F after each command is executed.
1 _ Compare between the status and control flags? Explain the status flags for the operation AEH+37H ? 2) 2 _What are the purposes of both segmentation and physical generation? Explain with draw and numerical example?
Suppose that initially the contents of the registers are A:07 B:A9 SP:004F X:34BF and that memory locations 0048 through 004F initially contain all zeros. The commands PSHA, PSHB, PULA, PULB, PSHX are then executed in sequence. List the contents of the registers A, B, SP, and X, and the memory locations 0048 through 004F after each command is executed.
What is a stack? What is the stack pointer used for?
What hex address will be decoded by the instruction OUT 6D, AL?
What is the content of register $t1 after executing the instruction: SLL $t1,$t1,8 if its initial content is 0x8009?
In a multibyte addition program, when must you use the ADD instruction? When must you use the ADC instruction?
Write a program to PUSH RO, R1, and R3 of Bank onto the stack and POP them back into RS, R6, and R7 of Bank 3. Also, mention the value of SP register after every PUSH and POP operation
The processor has performed the following addition operation: 0x01A0+ 0xC410------0xC5B0 What decimal numbers did the processor add up, and what is the result of the addition if the programmer chose these numbers to be signed 16-bit number, where the lower four bits represent the fractional part of the number?
design a two-way traffic light system with prototype using 4-bit down counter circuit. use 7-segment as an output to represent the timer.i need help.. pls make a circuit diagram for this. (like circuit wizard and tinkercad) i will do this on the breadboarduse simple ic only like dual jk flip flopsthank you.. sorry for asking again.