The minimum drag condition is an important optimum condition for aircraft performance. The list below contains a variety of performance objectives, select ALL those that are achieved at the minimum drag condition. Only select answers you are sure are correct. Partial credit is available for each correct answer but a negative marking is applied within this question (but it is not possible to score a negative mark for the question overall). 1. Minimum descent rate of a propeller aircraft 2. Maximum endurance of a propeller aircraft 3. Maximum endurance of a jet aircraft 4. Maximum climb rate of a propeller aircraft 5. Maximum range of a propeller aircraft 6. Minimum descent angle of a propeller aircraft 7. Maximum climb angle of a jet aircraft 8. Minimum descent rate of a jet aircraft

The minimum drag condition is an important optimum condition for aircraft performance. The list below contains a variety of performance objectives, select ALL those that are achieved at the minimum drag condition. Only select answers you are sure are correct. Partial credit is available for each correct answer but a negative marking is applied within this question (but it is not possible to score a negative mark for the question overall). 1. Minimum descent rate of a propeller aircraft 2. Maximum endurance of a propeller aircraft 3. Maximum endurance of a jet aircraft 4. Maximum climb rate of a propeller aircraft 5. Maximum range of a propeller aircraft 6. Minimum descent angle of a propeller aircraft 7. Maximum climb angle of a jet aircraft 8. Minimum descent rate of a jet aircraft

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If a ball rolls up a ramp to a height of .3 m on the ramp (inclined at an angle of 20 degrees), what was its initial velocity? (question only involves potential energy. Ignore the fact that the ball is rolling.) Please provide a complete solution set with no skipped steps and double check your work! Thank you.
A liquid with a specific gravity of 4.7 and a viscosity of 1.3 cp flows through a smooth pipe of unknown diameter, resulting in a pressure drop of 0.183 lbf/in² for 1.73 mi. What is the pipe diameter in inches if the mass flowrate is 5,900 lb/hr?A. 3.64 inB. 0.44 inC. 5.74 inD. 0.005 in
#01: Explain the following terms in your own words. a) Aerodynamics. b) Mach Number. c) Sub-Sonic. d) Angle of Attack. e) Thrust. f) Chord Line. g) Drag Coefficient. h) Pitch Moment. i) Wind Tunnel. j) Skin Drag.
An airplane builder wants to build a scaled-down model of a real airplane in a 12:1 ratio in order to be able to perform tests in a wind tunnel. The real plane flies at 126 km/h, while the air speed in the tunnel where the model is located is given by V. The performances of the two will be equivalent for a value of V, in m/s, equal to Data: air viscosity η = 1.8 × 10-5 kg/(m.s) air density ρ = 1.3 kg/m3
Resistance R to the motion of a completely submerged body is given by R = ρV2 L2 φ , where ρ and ν are density and kinematic viscosity of the fluid while L is the length of the body and V is the velocity of flow. If resistance of a one-sixth scale airship model when tested in water at 10 m/s is 230 N, what will be the resistance in air of the airship at the corresponding speed? Kinematic viscosity of air is 13 times that of water and density of water is 810 times of air.
Hydrostatic pressure at any given depth of a liquid depends on the_____ of the container.a)Volumeb)ShapeC)Depthd)All of the above .As the temperature of oil increases, the viscosity of oil willa) increaseb) decreaseC)not change Which of the following units would NOT be used for volume flow rate?a) gal/minb) Ib/sc)m⅗d)ft^3/s 2.Dynamic viscosity is defined as,a) weight per unit volume of a fluidb) volume per unit weight of a fluidc) the velocity gradient divided by the shearing stress of a fluidd)the shearing stress divided by the velocity gradient of a fluid
A 1:20 scaled-down model of a hydrofoil is tested in a water channel, at a velocity of 0.179 m/s. At this velocity, a drag force of 2.2 N is measured. Determine the drag force of the original hydrofoil, at a velocity of 0.8 m/s.
3.) Automotive engineers work very hard to improve the value of the drag coefficient for cars. Suppose you have a car with a mass of 3000. kg and an effective surface area of 4.00 m^2. The engine can generate a maximum force of 28,000. N. Let the coefficient of kinetic friction be 0.200, and the coefficient of static friction be 0.400. Air has a density of 1.21 kg/m^3. (back on earth) (3a) Draw a free-body diagram for your car, including both drag and friction, when the car is moving at its maximum velocity. (3b) If the maximum value of your car's velocity is 150.0 m/s, then what is the drag coefficient for the car? (3c) Suppose your engineers change the drag coefficient to 0.300 - what would be your maximum velocity then with the same force from your engine.
Long flights at midlatitudes in the Northern Hemisphere encounter the jet stream, an eastward airflow that can affect a plane's speed relative to Earth's surface. If a pilot maintains a certain speed relative to the air (the plane's airspeed), the speed relative to the surface (the plane's ground speed) is more when the flight is in the direction of the jet stream and less when the flight is opposite the jet stream. Suppose a round-trip flight is scheduled between two cities separated by 3200 km, with the outgoing flight in the direction of the jet stream and the return flight opposite it. The airline computer advises an airspeed of 810 km/h, for which the difference in flight times for the outgoing and return flights is 72 min. What jet-stream speed is the computer using?
A fluid with a specific gravity of 2.6 and a viscosity of 2.0 cP travels through a smooth pipe with an unknown diameter, causing a pressure decrease of 0.183 lbf/in.2 over 1.73 miles. If the mass rate of flow is 7,000 lbs/h, what is the pipe diameter in inches?
The volume flow Q over a certain dam is a function of damwidth b , gravity g , and the upstream water depth H abovethe dam crest. It is known that Q is proportional to b . If b=120 ft and H =15 in., the flow rate is 600 ft 3 /s. What willbe the flow rate if H = 3 ft?
An important parameter in certain types of fluid flow problems when a free surface is present is the Froude number (Fr), which can be expressed in equation form as (Fr) = [pv^2/Lw]^1/2 where p is the density of the fluid, v is a velocity, L is a length, and w is the specific weight of the fluid. Show that the Froude number is dimensionless