The minimum working space width in front of service equipment installed in a house must be ______ inches wide or the width of the equipment, whichever is greater. The minimum amount of clear space in front of service equipment must be at least ______ feet. This space must be maintained to a height from the floor of ______ feet. Name the NEC® section that covers these requirements

The minimum working space width in front of service equipment installed in a house must be inches wide or the width of the equipment, whichever is greater. The minimum amount of clear space in front of service equipment must be at least feet. This space must be maintained to a height from the floor of __ feet. Name the NEC® section that covers these requirements

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter3: Determining The Required Number Of Branch Circuits, Lighting Outlets, And Receptacle Outlets

Section: Chapter Questions

Problem 41R

See similar textbooks

Similar questions

The NEC is the only code reference used for electrical installations of all types of occupancies including dwelling for physically challenged persons. True or False?
The minimum number of outdoor receptacles for a residence is __________, NEC __________. State the location. __________
The recessed fluorescent luminaires installed in the ceiling of the recreation room of this residence are connected with trade size flexible metal conduit. These flexible connections are commonly referred to as fixture whips. Does the flexible metal conduit provide adequate grounding for the luminaires, or must a separate equipment grounding conductor be installed? ________________
What color are the faceplates in the bathrooms? Refer to the specifications. ________________
Refer to the specifications in the back of this text following Chapter 33. a. What electrical codes must be conformed to? ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ b. What is the wiring method to be used in the workshop? ________________________________________________________________________ c. What size conductors are to be used for the lighting branch circuits? ______________________ AWG the small-appliance branch circuits? ______________________ AWG d. What section of the specifications tells us the size of the service entrance to be installed for this residence?
QUESTION 25 Type TC cable shall not be _____. a. installed where it will be exposed to physical damage b. all of these c. installed outside of a race-way or cable tray system, unless permitted in 336.10(4), 336.10(7), 336.10(9), and 336.10(10) d. used where exposed to direct rays of the sun, unless identified as sunlight resistant
QUESTION 9 When a ground wire is connected to an interior gas piping system and the underground portion of the gas pipe into the building is plastic, which of the following is (or are) true? a A.This would be approved by code as the gas pipe is only being bonded to the electrical system. b B.This installation would be approved by code, as the gas pipe is not a grounding electrode. c C.Both A and B d D.Neither A nor B
a. The Code requires a minimum of two small-appliance circuits in a kitchen. Is it permitted to connect a receptacle in a dining room to one of the kitchen small-appliance circuits? _______________ What Code section applies to this situation? _______________ b. Are outdoor weatherproof receptacles permitted to be connected to a 20-ampere small-appliance circuit? _______________ c. Receptacles located above the countertops in the kitchen must be supplied by at least _______________ 20-ampere small-appliance circuits.
Signals and Systems Please make sure that answer is correct