The most common clinical instrument used in measuring pressure is the.AThermometer.BSphyomanometer.CSphygmomanometerManometer

Thermometer is used to measure temperature. Manometer is used to measure pressure in a fluid.…

Answered: The most common clinical instrument…

Science

Physics

The most common clinical instrument used in measuring pressure is the

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 27CQ: Considering the magnitude of typical arterial blood pressures, why are mercury rather than water...

See similar textbooks

Related questions

Q: Consider a parallel plate capacitor with a plate area of 74.3 cm^2, a plate separation of 0.239…

Q: What is the current flowing into the 1-ohm resistor? 3.00 Ω 18.0 V 4.00 N -2.00 N 1.00 N

A: The total current drawn from the battery by the circuit is i=VReq, where Req is the equivalent…

Q: Find the value of final speed of car Initial velocity=2.05 m/s acceleration=2 m/s2 time=2 s

A: Given value--- initial velocity = 2.05 m/s . acceleration = 2 m/s2. time = 2 sec . We have to…

Q: Question 3: A 5.0 kg ball is rolling north at 2.50 m/s when it collides with a 6.0 kg ball which…

A: Given, mass of the ball, m1 = 5.0 kg moving towards with velocity, u1 = 2.50 m/s mass of second…

Q: 1. An object of charge +2.0 ×10°C is located at the Cartesian origin, (Om,0m). A second object, of…

Q: When a 30-N force, parallel to the incline and directed up the incline, is applied to a block on a…

Q: For the following motion equation s=2t^3 -15t^2+36t-22, t⩾0 a. When is the particle at rest?

Q: (a) Sketch a Carnot cycle of a gas on a T-S diagram. Show the direction of the state change along…

Q: If you push a box of supplies across 6 meters on a floor that exerts 110 newton of frictional force,…

Q: A paraglider started to descent in his wingsuit. Knowing that air resistance will be significant to…

Q: A lens has a power of -2.5D. If a book is held 20cm in front of the lens, A) where is the image? B)…

A: (A) Express the relation between focal length and power of lens. P=1f Here, P is the power and f is…

Q: Find the value of kinetic energy stored in car having mass of 2.48 kg moving with velocity 0.45 m/s

Q: The continuous-spectrum radiation that a blackbody emits is called A. Emitting light. B. Ultraviolet…

Q: A 15-ohm resistor has a constant current. If 3300 C of charge flow through it in 5 minutes what is…

A: We need to calculate the value of electric current in the circuit.

Q: A dentist’s drill starts from rest. After 3.20 s of constant angular acceleration, it turns at a…

Q: An interstate highway is made of concrete slabs 25 m long placed end to end. (a) What expansion gap…

A: Distance=25m

Q: d) What is the the velocity of the truck when it's at ¾ the length of the ramp?

Q: The graph below is the graph of magnetic flux versus time. The slope of this graph (ADIAt) indicates…

A: Given: The graph between manetic flux and time.

Q: Determine the momentum of a car having mass 200 kg moving with a velocity 34 m/s

A: Given data : Mass = m Velocity = v To find…

Q: What is the direction of the acceleration of your car when you start backing out of your parking…

Q: An independent and constant current source is supplying 0.6 ampere to a uniform copper conductor…

A: Solution:- 1) The drift velocity of electrons inside a conductor, is given by vd = i /( A*n*e)…

Q: (d) Draw the velocity vectors,  and the resultant velocity vector at this time.

Q: Complete the table for the Expt: Ohm's Law and series and parallel Current, Resistance, ohms…

Q: An engine develops 15 kw of power. How much time does it take to lift 250 kg to a height of 30m ?

Q: How much time does it take to lift 350 kg

A: Given; Determine the time does it take to lift 350 kgto a height,h=40 m Where it develops power of…

Q: Find the velocity and acceleration vectors in terms of u, and ug. de r= a sin 40 and 2t, where a is…

A: Formula

Q: For the given figure, the weight of the 12-ft bar is 5 lb. The moment of the tension in the cord…

Q: There are numbers of places in the body where the pressure is .A higher than atmospheric .B lower…

A: The pressure is defined as the force applied perpendicular to the object per unit area over which…

Q: A projectile is fired eastward from the earth's surface at A degree north latitude with a velocity…

A: Coriolis acceleration = -2ω→×v→ We keep only the x- components of Coriolis for and ignore the rest.…

Q: A block resting on a plane inclined at an angle, 0, of 42° from the horizontal is being held in…

A: From free body diagram, equate vertical forces and horizontal forces because system is at rest.

Q: would a 100% efficient engine violate the first law of thermodynamics? What about a workless…

A: would a 100% efficient engine violate the first law of thermodynamics? What about a workless…

Q: Find voltage

A: Given data : The current is denoted by i The resistance is denoted by R To find : Voltage

Q: What is the direction of the magnetic force on a positive force if V=into the page; B=upward?

Q: Part A Green light (A = 508 nm) strikes a single slit at normal incidence. What width slit will…

A: Given, Wavelength of the green light, λ = 508 nm width of central maxima, d = 3.00 cm distance of…

Q: A flat sheet is in the shape of a rectangle with sides of lengths 0.450 m and 0.675 m. The sheet is…

Q: pilot sets a bearing of 330° at 240 mph. A consistent wind blows at 52 mph due west. (round to two…

A: pilot sets a bearing of 330° at 240 mph. A consistent wind blows at 52 mph due west. (round to two…

Q: For the following motion equation s=2t^3 -15t^2+36t-22, t ⩾ 0 a. Find the average velocity and…

A: The equation is S = 2t3 - 15t2 + 36t - 22 , t>=0 At t1 = 2s S1 = 2(23) - 15(22) + 36(2) - 22 = 6m…

Q: In an elastic collision, the total energy is conserved but the momentum is not conserved. True False

A: To identify whether the given statement is true or falseGiven statement : In an elastic collision ,…

Q: What is the final temperature when 22 g of Aluminum at 30°C is placed in 200 g of water at 20°C?

Q: Q2) Calculate the density of copper, whose building unit is (FCC) type, the length of the edge of…

A: We need to calculate the density of copper, given that the building unit is FCC type, length of the…

Q: 12V 120 12

A: kirchoffs junction rule : the sum of currents moving towards junction is equal to sum of currents…

Q: a. If the plane was inclined at 37 degrees then the cart slides, what is the coefficient of static…

A: The coefficient of static friction is equal to the tangent of the angle at which the objects slide.

Q: A pendulum bob of mass 5.00 kg is attached to a rigid massless cord 1.50 m long. Calculate the…

A: In circular motion, Equate net force on the Bob to the centripetal force

Q: please sketch and label if possible thank you

Q: A charge if 20 C was passed through wire in 16 minutes. Calculate the average electric current…

A: Given value--- Charge = 20 C . time = 16 min . We have to find--- current through wire ?

Q: : An automobile starting from rest speeds up to 40 meters per second with a constant acceleration of…

Q: A charge +q is fixed at each of the points x = x0, x = 3xo, x = 5xo ..... infinite, on the x- axis,…

Q: 5. For the following motion equations = 2t – 15t + 36t – 22, t > or equal to 0 c. When is the…

Q: Consider the arrangement shown in Figure P31.26. Assume that R = 6.00 N, e = 1.20 m, and a uniform…

A: Given data: The resistance is R=6.00 Ω. The length of bar is l=1.20 m. The magnitude of magnetic…

Q: The energy that makes the maximum kinetic energy of the emitted electrons has stopped. A. Photon…

A: Explanation-: The energy that makes the maximum kinetic energy of the emitted electrons has stopped.…

Concept explainers

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.

Question

The most common clinical instrument used in measuring pressure is the
.A
Thermometer
.B
Sphyomanometer
.C
Sphygmomanometer
Manometer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Concept:

VIEW

Answer:

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The human circulation system has approximately 1109 capillary vessels. Each vessel has a diameter of about 8 m. Assuming cardiac output is 5 L/min, determine the average velocity of blood flow through each capillary vessel.
If the pressure in the esophagus is -2.00 mm Hg while that in the stomach is +20.0 mm Hg, to what height could stomach fluid rise in the esophagus, assuming a density of 1.10 g/mL? (This movement will not occur if the muscle closing the lower end of the esophagus is working properly.)
Figure 11.17 shows how a common measurement of arterial pressure is made. Is there any effect on the measured pressure if the manometer is Iowered? What is the effect of raising the arm above the shoulder? What is the effect of placing the cuff on the upper leg with me person standing? Explain your answers In terms of pressure created by the weight of a fluid. Figure 11.17 In routine blood pressure measurements, an inflatable cuff is placed on the upper arm at the same level as the heart. Blood now is detected just below the cuff, and corresponding pressures are transmitted to a mercury-filled manometer. (credit: LJ_S_ Army photo by Spc. Micah E.Clare\4TH BCT)
Considering the magnitude of typical arterial blood pressures, why are mercury rather than water manometers used for these measurements?
An airplane is cruising al altitude 10 km. The pressure outside the craft is 0.287 atm; within the passenger compartment, the pressure is 1.00 atm and the temperature is 20C. A small leak occurs in one of the window seals in the passenger compartment. Model the air as an ideal fluid to estimate the speed of the airstream flowing through the leak.
Pressure between the inside chest wall and the outside of the lungs normally remains negative. Explain how pressure inside the lungs can become positive (to cause exhalation) without muscle action.
How tall must be to measure blood pressure as high as 300 mm Hg?
An airplane is cruising at altitude 10 km. The pressure outside the craft is 0.287 atm; within the passenger compartment, the pressure is 1.00 atm and the temperature is 20C. A small leak occurs in one of the window seals in the passenger compartment. Model the air as an ideal fluid to estimate the speed of the airstream flowing through the leak.
An airplane has a mass M, and the two wings have a total area A. During level flight, the pressure on the lower wing surface is P1. Determine the pressure P2 on the upper wing surface.
The alveoli in emphysema victims are damaged and effectively form larger sacs. Construct a problem in which you calculate the loss of pressure due to surface tension in the alveoli because of their larger average diameters. (Part of the lung's ability to expel air results from pressure created by surface tension in the alveoli.) Among the things to consider are the normal surface tension of the fluid lining the alveoli, the average alveolar radius in normal individuals and its average in emphysema sufferers.
Pressure in the spinal fluid is measured as shown in Figure 11.43. If the pressure in the spinal fluid is 10.0 mm Hg: (a) What is the reading of the water manometer in cm water? (b) What is the reading if the person sits up, placing the top of the fluid 60 cm above the tap? The fluid density is 1.05 g/mL. Figure 11.43 A water manometer used to measure pressure in the spinal fluid. The height of the fluid in the manometer is measured relative to the spinal column, and the manometer is open to the atmosphere. The measured pressure will be considerably greater if the person sits up.
The human brain and spinal cord are immersed in the cerebrospinal fluid. The fluid is normally continuous between the cranial and spinal cavities and exerts a pressure of 100 to 200 mm of H2O above the prevailing atmospheric pressure. In medical work, pressures are often measured in units of mm of H2O because body fluids, including the cerebrospinal fluid, typically have nearly the same density as water. The pressure of the cerebrospinal fluid can be measured by means of a spinal tap. A hollow tube is inserted into the spinal column, and the height lo which the fluid rises is observed, as shown in Figure P9.83. If the fluid ruses to a height of 160. mm, we write its gauge pressure as 160. mm H2O. (a) Express this pressure in pascals, in atmospheres, and in millimeters of mercury. (b) Sometimes it is necessary to determine whether an accident victim has suffered a crushed vertebra that is blocking the flow of cerebrospinal fluid in the spinal column. In other cases, a physician may suspect that a tumor or other growth is blocking the spinal column and inhibiting the flow of cerebrospinal fluid. Such conditions ran be investigated by means of the Queckensted test. In this procedure, the veins in the patients neck are compressed lo make the blood pressure rise in the brain. The increase in pressure in the blood vessels is transmitted to the cerebrospinal fluid. What should be the normal effect on the height of the fluid in the spinal tap? (c) Suppose compressing the veins had no effect on the level of the fluid. What might account for this phenomenon?