3 The nickel level in a soil sample was determined using AAS. A 3.0 g sample wasdissolved in acid and then diluted to a total volume of 100.0 mL. The absorbance of thissolution determined at a wavelength of 232 nm was found to be 0.3. Several standardwwmsolutions were tested under the same conditions and a calibration curve shown belowwas obtained. Calculate the mass of nickel in mg.0.9y = 0.0699x +0.015.0.80.70.60.50.40.30.20.1*****...8101214[Ni], ppmAbsorbance

It is application of lambert beer Law Here we are required to find the mass of nickel in mg

The nickel level in a soil sample was determined using AAS. A 3.0 g sample was dissolved in acid and then diluted to a total volume of 100.0 mL. The absorbance of this solution determined at a wavelength of 232 nm was found to be 0.3. Several standard solutions were tested under the same conditions and a calibration curve shown below was obtained. Calculate the mass of nickel in mg.

The nickel level in a soil sample was determined using AAS. A 3.0 g sample was dissolved in acid and then diluted to a total volume of 100.0 mL. The absorbance of this solution determined at a wavelength of 232 nm was found to be 0.3. Several standard solutions were tested under the same conditions and a calibration curve shown below was obtained. Calculate the mass of nickel in mg.

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter20: Molecular Spectroscopy And Photochemistry

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Calculate the density of the M1224g nucleus in g/L, assuming that it has that it has the typical nuclear diameter of 11013 cm and is spherical in shape.
Would the light from fireflies be considered an example of a fluorescence or a phosphorescence process?
In high-temperature sources, sodium atoms emit a doublet with an average wavelength of 1139 nm. The transition responsible is from the 4s to 3p state. Set up a spreadsheet to calculate the ratio of the numberof excited atoms in the 4s state to the number in the ground 3s state over the temperature range from anacetylene-oxygen flame (3000°C) to the hottest part of an inductively coupled plasma source (8750°C).
The Doppler effect is one of the sources of the line broadening in atomic absorption spectroscopy. Atoms moving toward the light source encounter higher-frequency radiation than atoms moving away from the source. The difference in wavelength experienced by an atom moving at speed v (compared to one atrest) is / = v/c , where c is the velocity of light. Estimate the line width (in nanometers) of the lithiumline at 670.776(6707.76 Å) when the absorbing atoms are at a temperature of (a) 2000 K and (b) 3120 K.The average speed of an atom is given by v=8kT/m , where k is Boltzmann’s constant, Tis the absolute temperature, and m is its mass.
Calculate the energy per mole of photons for the laser used in Blu-ray players ( = 405 nm)