The pendulum is suspended from point O and consists of two bars, each weighing 10 lb. Determine the moment of inertia of the pendulum about the axis through the center of mass G.

Q: The block in the drawing has dimensions L0×2L0×3L0,where L0 =0.5 m. The block has a thermal…

A:

Q: Determine the rate of flow of water through a pipe of diameter 20 cm and length 50 m when one end of…

A: When one end of the pipe is linked to a tank and the other end is open to the atmosphere, we must…

Q: 5.4 In the continuous stirring heating tank, the flow rate of the influent is 200lb/min, the…

A: Write the expression of temperature variation. T=T0e-kt     80=90e-kt   ...... (1)

Q: These garden shears were manufactured using an inferior material. Using a loading of 50 lb applied…

A:

Q: re. Assume that the sy riant, in composition; n3B sition. for isothermal equilil

A: solution of above problem is below:

Q: HW. A 90-lb load is suspended from the hook as shown in the Figure. If the load is supported by two…

A: Find the forces in each cables and the stretch in spring for equilibrium.

Q: A resistor is wired to a battery in a circuit and dissipates a power P1 as heat. A second battery,…

A:

Q: Read the questions carefully before answering.  Box  or  indicate  your  final answers  when…

A:

Q: Water mass flow rate of 2kg/s is delivered through the 30 mm commercial steel pipe? -0.15 Calculate…

A: Given: mass flow rate of water→m˙=2 Kgs Diameter of the commercial steel pipe→D=30 mm=0.030 m So…

Q: For the cantilever beam (with a uniform load) shown below, determine the maximum shear and flexural…

A:

Q: What is the total entropy change to expand water at 30 psia and 70 percent quality to 10 psia in a…

A:

Q: explain the two phase component diagram of Cu-Ni and apply the phase rule

A: given; explain the two phase component diagram of Cu-Ni and apply the phase rule

Q: Зx, + 3х, + 5х, 1 Зх, + 5х, + 9х, 3D 2 + 9x3 5x, + 9х, + 17х, 3 4

A: 3x1+ 3x2+ 5x3= 13x1+ 5x2+ 9x3= 25x1+ 9x2+ 17x3= 4   Note: In the question, nothing is specified…

Q: A pipe passes through a room in which the surrounding air is at 22 ºC. The diameter of the pipe is…

A: Given data:

Q: a1) Classify each of the structures as statically determinate, statically indeterminate, or…

A: To find: Whether each structure is statically determinate, statically indeterminate, or unstable.

Q: Draw the shear and moment diagram of the given beam

A: Need to Draw the shear and moment diagram

Q: Draw the complete shearing force and bending moment diagram for the beam shown in the figure. Draw…

A:

Q: 1. A controlling torque , in gravity controlled instruments. is attached to the moving system in…

A: Correct answer: Small weight Note: We know that, small weight is attached to the moving system in…

Q: 3 kilograms of steam has an initial enthalpy of 7100.111 kJ at 0.14111 Mpa. Isentropically…

A:

Q: Draw the shear and moment diagram and determine the Vmax and Mmax of the simple beam shown below. Wo…

A:

Q: 150 mm Q.2: Determine the resultant couple moment of the three couples acting on the plate F = 200…

A:

Q: Find the straun y temile load fenoduece lonyahon J0.025m. and inihal denyth 100 mm.

A:

Q: Sketch the stream lines represented by y = xy. Also find out the velocity and its direction at point…

A:

Q: In a refrigerațion cycle, the flow of refrigerant is controlled by; * evaporator compressor…

A:

Q: A steel shaft of 75 mm diameter is pressed into a steel hub of 100 mm outside diameter and 200 mm…

A: We know that a steel shaft with a diameter of 75 mm is forced into a steel hub with an outer…

Q: operate with an initial pressure of 1.69356 Mpa and 370.356oC temperature and exhaust to a heating…

A:

Q: A rankine cycle with water superheats to 500.111oC at 3.1111 Mpa in the boiler and the condenser…

A: The Rankine Cycle is a mechanical cycle that converts the pressure energy of steam into mechanical…

Q: The bank of tubes at the back of domestic refrigerator is; * O evaporator tubes capillary tubes…

A: Refrigerator has 1. Compressor 2. Evaporator 3. Condenser 4. Expansion valves

Q: Determine the torque required to produce a 5° twist in the piece of wood. Use G = 1.0x10^6 psi for…

A:

Q: 3. A round shaft, 45 mm in diameter, carries a 3500 N load, as shown in the Figure. If the shaft is…

A:

Q: Draw the shear and moment diagram and determine the Vmax and Mmax of the cantilever beam shown…

A:

Q: 8-_A Stean paver Dlant aperates using the actual Rankine Cycle where' steam intially enters the…

A: Given dataSteam power plant operates using actual Rankine cycle.Conditions of steam at entry of…

Q: A heat exchanger has the objective of condensing 5 kg/s of water vapor and taking it from a pressure…

A:

Q: 1. for each of the following indicate the proper equation for work:  - isothermal compression -…

A:

Q: A major water main is an 18 in ductile iron pipe. Compute the Reynolds Number if the pipe carries…

A: given  data; diameter of pipe(d)=18in                            =0.4572mdischarge from…

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A: Write the given data. Q=9 m3/h=9 m3/h1 h3600 s=2.5×10-3 m3/sd=50 mmqL=2.5 J/kgP=0.1 kW=100 W

Q: long a straight line such that its acceleration is defined as a =-kv. If 1 = 0, determine the…

A:

Q: operat = 0, dx ду dz + = 0, dx ду dz The above steps are legal only if the flow is, Answers:…

A: In the field of fluid dynamics, incompressible flow is defined as a flow in which the density of…

Q: What is the resultant if the equilibrant is 10N , 30° N of E? What is the equilibrant if the…

A:

Q: y Fy

A:

Q: in Figure Q1(b). The two plates move in opposite directions with constant velocities V, and V2.…

A:

Q: 1. In general, what pattern do you notice between the force due to the gravity of the masses and the…

A: Given questions are : 1. In general, what pattern do you notice between the force due to the gravity…

Q: 3. An ideal Rankine Engine 1o Mfa and 350 C. It ex.Dands to a pressure of 100 kPa and then pressure.…

A:

Q: Problem 4: The space truss shown below is supported by ball-and-socket joints at C, D, and E.…

A: according to the given details

Q: Determine the work of the force when it displaces 2 m in each of the situation below: k = 10 N/m 2…

A:

Q: Define rotational and irrotational flow. The stream function and velocity potential for a flow are…

A:

Q: Consider the portion of an excavator shown. At the instant under consideration, the hydraulic…

A:

Q: Task 2 elect a reasonable pressure for the evaporator and condenser in the following scenarios: A) A…

A: Given  Condenser temperature, T1 = 25oC Evaporator temperature, T2 = - 10oC Find Condenser pressure,…

Q: A model of a river towboat is to be tested at 1:20 scale. The actual boat is designed to travel at a…

A: From the given question, Velocity of the actual boat = U = 2.5 m/s Kinematic viscosity of the water…

Q: Solve any question with heat using the chain rule with a mathematical application, not an…

A:

Moment of Inertia

Inertia can be termed as a resistance offered by a body to change its state. A rigid body initially at rest will apply resistance when acted by an external force that tends to change its state of rest or velocity, or a body initially at motion will provide resistance in changing its state of velocity or motion for coming to a state of rest. In other words, Newton's first law of motion describes the law of inertia of a rigid body.