The phase diagram for the system nitrobenzene/hexane at 1 atm is shown below. 294 292 290 27317 0 0.2 0.6 0.8 1 0.4 Mole fraction of nitrobenzene, X₁ Write the letter of the correct answer. 1. How many phases exists below the curve? a. 0 b. 1 c. 2 d. 3 2. How many phases exists above the curve? a. 0 b. 1 c. 2 d. 3 3. Which side of the phase diagram is rich in nitrobenzene? a. right b. left 4. Which side of the phase diagram is rich in hexane? a. right b. left Temperature, T/K

The phase diagram for the system nitrobenzene/hexane at 1 atm is shown below. 294 292 290 27317 0 0.2 0.6 0.8 1 0.4 Mole fraction of nitrobenzene, X₁ Write the letter of the correct answer. 1. How many phases exists below the curve? a. 0 b. 1 c. 2 d. 3 2. How many phases exists above the curve? a. 0 b. 1 c. 2 d. 3 3. Which side of the phase diagram is rich in nitrobenzene? a. right b. left 4. Which side of the phase diagram is rich in hexane? a. right b. left Temperature, T/K

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter6: Equilibria In Single-component Systems

Section: Chapter Questions

Problem 6.59E

See similar textbooks

Similar questions

give 5 examples of a 1 phase diagram and show its phase rule
The figure below is the solid-liquid phase diagram for the substances A and B. a) Label the number of phases and the substances in equilibrium in each region. b) Identify the region(s) where three phases coexist in equilibrium. c) Describe what will be observed when liquids of compositions a and b are cooled to a temperature just under T2. Please answer all parts
In the study of the vapour pressure of chloroform is determined. Chloroform is placed in a container and allowed to reach a temperature op 28C. A vacuum is then created at which point the chloroform start to boil. The pressure and temperature are recorded. Subsequently the vacuum is gradually reduced by allowing a small amount of air into the vessel, thereby increasing the pressure in the vessel. At each of these higher pressures, the solution is heated and till it boils again and the temperature point and pressure is recorded at which the solution boils. This is repeated until the vessel reaches room pressure. What is the dependent and independent variable?
The liquid-vapour equilibrium diagram of the acetone-chloroform mixture is shown below. A mixture containing 40% (molar percentage) of chloroform was heated to a temperature of 60°C, under a pressure of 1 atm. a) For a temperature of 60°C, what is the molar fraction of chloroform in the liquid phase and what is the molar fraction in the vapor phase, respectively?b) What is the molar fraction of chloroform and acetone at the azeotropic point?
The vapour pressure of a liquid is represented by the equationlog (P/Torr) =(−1625/?)+8.750 where T is the temperature in Kelvins. Use the equation to find the vapour pressure of the liquid at 23 ℃.
Based on the ternary phase diagram, a binary mixture of furfural and water will always split into two liquid phases: 1) 95 % furfural, 5 % H2O and 2) 92 % H2O, 8 % furfural. Neither true nor false True False The actual composition depends on other experimental parameters.
The solid–liquid equilibrium line in the phase diagram of water has a negative slope, equal to −0.0076 °C bar−1. Calculate the freezing point of water beneath a glacier that is 3 km high and has a density of 917 kg/m3.
Answer the following (This is all about Phase Diagram of Water and Carbon Dioxide). A. Using the Venn Diagram differentiate the phase diagram of water from carbon dioxide. B. Give practical applications of phase diagram in the industry. C. Explain why expressing a concentration as "x-percent can be ambiguous?
Topic : Phase Draw the phase Diagram of a one component system which contain more than one solid phase and Explain the following with help the Diagram. (i) Triple points (iii) Univariant system
The table below shows temperature/composition data collected for a mixture of methylbenzene (M) and octane (O) at 1 atm. Recall that x stands for the mole fraction in the liquid and y stands for the mole fraction in the vapor in equilibrium. The boiling points for methylbenzene (M) and octane (O) are 110.60C and 125.60C, respectively. Construct the phase diagram with Temperature vs. xM. What is the composition of the vapor in equilibrium with the liquid of composition (a) xM = 0.250 and (b) xO = 0.250. T (0C) 110.9 112.0 114.0 115.8 117.3 119.0 121.1 123.0 xM 0.908 0.795 0.615 0.527 0.408 0.300 0.203 0.097 yM 0.923 0.836 0.698 0.624 0.527 0.410 0.297 0.164
The normal boiling point of liquid pentane is 309 K. Assuming that its molar heat of vaporization is constant at 26.8 kJ/mol, the boiling point of C5H12 when the external pressure is 1.36 atm is K. Please provide only typed answer solution no handwritten solution needed allowed
Using Gibb's Phase rule calculate the degrees of freedom of the following: Show complete solutions: 1. Nitrogen (gas) + Nitrogen (liquid) 2. Sucrose + talc + kaolin