The pivot of a simple pendulum (length I, mass m) is attached to a disc of radius R, which rotates in the plane of the pendulum with angular velocity w (see figure below). Write down the Lagrangian and derive the equations of motion for 0. The pivot of a simple penduhum (length l, mass m) is attached to a disc of radius R, which rotates in the plane of the pendulum with angular velocity w (see figure below). Write down the Lagrangian and derive the equations of motion for 0.

The pivot of a simple pendulum (length I, mass m) is attached to a disc of radius R, which rotates in the plane of the pendulum with angular velocity w (see figure below). Write down the Lagrangian and derive the equations of motion for 0. The pivot of a simple penduhum (length l, mass m) is attached to a disc of radius R, which rotates in the plane of the pendulum with angular velocity w (see figure below). Write down the Lagrangian and derive the equations of motion for 0.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two propellers of lengths and masses l, L and m, M rotate in the same direction, as shown in the figure. if the left propeller starts from rest, w1=0 and the right propeller starts with an angular velocity that the right propeller ends up with after both propellers have collided.
Two propellers of lengths and masses l, L and m, M rotate in the same direction, as shown in the figure. If the left propeller starts from rest, w1=0 and the right propeller starts with an angular velocity equal to w2, find the angular velocity with which the right propeller ends up after both propellers have collided.
A disk and a ring both homogeneous with masses M1=0.94 kg and M2=M1/6 and radii R1=0.36 m and R2=R1/2, respectively, are coupled by an ideal C strap, as shown in the figure below . At a given moment, a work of modulus W=35 J is performed on the system that, starting from rest, makes the disk and the ring rotate around their symmetry axes. In view of this, answer: what is the value of the linear velocity v at the edge of the disk? Consider that the strap does not slide over the edge of objects. Choose one: Escolha uma: a. 14,80 m/s b. 12,68 m/s c. 10,57 m/s d. None of the other alternatives e. 19,02 m/s f. 16,91 m/s g. 8,46 m/s h. 6,34 m/s
Sliding box: a) A box of mass m slides down an inclined plane and makes an angle with thehorizontal as shown in the figure. find a differential formula for the speed v(t) of the boxat time t in each of the following three cases:i) No sliding friction and no air resistance.ii) With sliding friction and no air resistance.iii) With sliding friction and air resistance.
Q6/ A car travelling at speed of 300 m/sec strikes a stone of mass 0.5 kg and 20 cm in size .Estimate Impulse of the force by the stone on the car? Q7/ A ball of mass 0.4 kg is thrown against a brick wall. When it strikes the wall it is moving horizontally to the left at 30 m/sec ,and it rebounds horizontally to the right at 20 m/sec. find the impulse of the force exerted on the wall ?
A turntable is a uniform disc of mass 2 kg and radius 1.3 x 10-1 m. The turntable is spinning at a constant rate of = 0.5 . The motor is turned off and the turntable slows to a stop in 8.0 s with constant angular deceleration. Find the (a) moment of inertia of the turntable; (b) initial rotational kinetic energy; (c) angular deceleration of the turntable while it is slowing down; (d) total angle in radians that the turntable spins while slowing down; and (e) magnitude of the frictional torque.
1. A massless spring (k=400) is pulled by 25cm from its natural length and then released,the spring is attached to a 0.40kg block and oscillates across a horizontal frictionlesssurface. Calculatea. Max velocityb. Max accelerationc. Velocity, restoring force and acceleration at 20 cm from its natural length.
- A double-pulley system, as in the right figure above, has masses m1 = 2.00 kg, m2 = 1.20 kg, and m3 = 0.800 kg. (a) What are the accelerations of all the masses? (b) What are the tensions in all the ropes
consider the slider-crank mechanism shown. Crank AB is 0.300 m long. Rod BD is 0.600 m long. The velocity at point B is 3.00 m/s, ⬅. speed of the piston at D?
3kg ball connected to horizontal AB with cable. AB rotates with constant angular velocity w about vertical axis. if angle of cable with vertical is theta= 30 degree, find angular velocity and tension of the cable.
A box of mass m = 0.7 kg is attached to a rope which is wrapped around a physical pulley with a radius of R = 10.2 cm and a rotational inertia of I = 0.075 kg·m2. When the box is released it starts to fall down with a constant acceleration and, at the same time, the pulley starts to spin up, see the picture below. Assuming that the pulley is frictionless, what is the magnitude of the box's acceleration and what is the tension in the rope? The acceleration of the box, a ? The tension in the rope, T? If the box starts from rest and traveled downwards a distance of h = 28 cm, what is the speed of the box and what is the angular velocity of the pulley? The speed of the box, v =? The angular velocity of the pulley, ω? -------------------------------------------------------------- A Merry Go Round carousel has a radius of R = 2.4 m and a rotational inertia of I = 695 kg·m2. A 75‑kg student is on the carousel at the midpoint between the carousel's center and the rim (at R/2 distance from…
Q7/ A ball of mass 0.4 kg is thrown against a brick wall. When it strikes the wall it is moving horizontally to the left at 30 m/sec ,and it rebounds horizontally to the right at 20 m/sec. find the impulse of the force exerted on the wall ?