The potential energy of a system is described the the expression, U = axª – Bx² + y At what values of x is this system in equilibrium? Ox = 0, and X = ± 2a X = За and B 2a O x = 0, and 3B X = 4a O x=Va and x =VB

Q: A long, straight wire allows 3.50 A through it. What is the magnitude of the magnetic field 25.0 cm ...

A:

Q: Same situation as in the previous problem this time the magnet has mass 6.22 kg, the force pulling i...

A:

Q: In the figure the ideal batteries have emfs E1 = 4,89 V and E2 = 10.2 V, the resistances are each 2....

A:

Q: A car weighing 12 k N has speed of 20 ms- 1. Find its kinetic energy.

A: Given data:  Weight of car (W) = 12 kN = 12000 N Speed (v) = 20 m/s Required: Kinetic energy (KE) 

Q: How much energy is stored by the electric field between two square plates, 9.1 cm on a side, separat...

A:

Q: Same situation as in the previous two problems this time the magnet s mass is 7.20 kg and the magnet...

A:

Q: Nichrome wire is used in some radiative heaters. (a) Find the resistance (in Ω) needed if the avera...

A:

Q: 6.3. A car weighing 12 k N has speed of 20 ms -1. Find its kinetic energy.

A: Given data: Weight of the car  =  W  Speed of car=V   To find : Kinetic energy  

Q: Betelgeuse, a red-giant star in the constellation Orion, has a peak in its radiation at a frequency ...

A:

Q: Two blocks are positioned on surfaces, each inclined at the same angle of 46.2 degrees with respect ...

A: Given: θ=46.2°μ=0.540mass of black block M1=2.56 kgmass of white block M2=?both slides right, with c...

Q: 3. Resistance. A copperwire is 2.50 m long and has a diameter of 2.5 mm. How much current will it dr...

A: Given: The length of the copper wire is 2.5 m. The diameter of the wire is 2.5 mm. The potential dif...

Q: A concave mirror (R = 64.1 cm) is used to project a transparent slide onto a wall. The slide is loca...

A: Given: Radius of curvature R=64.1 cm, Focal length f=R2=64.1 cm2=32.05 cm, Object distance do=36.1 c...

Q: A short vertical transmitting antenna erected at the surface of a perfectly conducting earth transmi...

A:

Q: Two blocks are positioned on surfaces, each inclined at the same angle of 53.2 degrees with respect ...

A: In this question we have to find out the mass of the white block if both blocks are to slide to the ...

Q: What torque is required to uniformly rotate a disk with moment of inertia 0.7 kg m2 up to 2 rad/s in...

A: Given data:  Moment of inertia (I) = 0.7 kg.m2 Initial angular velocity (ωi) = 0 rad/s Final angular...

Q: Given data: Mass-4.4 kg Acceleration=3 m/s2 Determine force

A:

Q: A 2000 Hz sound wave passes through a wall with two narrow openings 30 cm apart. If sound travels on...

A:

Q: one is thrown vertically upward and return to the earth in 12 seconds. a.       Calculate the initi...

A: We know that the first equation of motion in the  terms of acceleration of gravity is given as  v= u...

Q: A d.c. supply of 120 V is connected to a large resistance X. A voltmeter of resistance 10 k2 placed ...

A:

Q: In the simple AC circuit shown on the right, the impedance is Z = 350 Ω and the current is I = Imaxs...

A:

Q: The orbit of a geostationary satellite is oncentric and coplanar with the equator of earth and rotat...

A:

Q: You are working with an electrical engineer who wants to send you messages with his microwave antenn...

A: In this question we have to find the location of the first dark fringe on the wall. Please give posi...

Q: A car's bumper is designed to withstand a 6.12-km/h (1.7-m/s) collision with an immovable object wit...

A: Given Initial velocity u = 1.7 m/s Mass m = 890 kg  Final velocity v = 0 Displacement S = 0.255 m 

Q: Problem 1: A centrifuge has a diameter of 18cm. It is able to spin at 10,000 rpm. A What is the cent...

A:

Q: A double-sit interference patterm is created by two narrow sits spaced 0.21 mm apart. The distance b...

A: Given Distance between the slits d = 0.21 mm = 0.21 × 10-3 m Distance between slit and  screen D = 6...

Q: In the figure circuit section AB absorbs energy at a rate of 47 W when current i = 0.88 A through it...

A:

Q: WT-2 A pipe closed at one end and open at the other has a length of 0.750m. Jiatai places a speaker ...

A:

Q: Two objects are placed on a surface, and each inclined at the same angle of 54.4 degrees with respec...

A:

Q: How many lines per centimetre does a grating have if the third-order bright fringe occurs at a 13.0°...

A:

Q: A farsighted librarian wears her 3.69-D refractive power eyeglasses 0.0200 m from her eyes and is ab...

A:

Q: A ball is thrown horizontally with an initial velocity of 25 m/s. The ball strikes the ground at the...

A:

Q: A magnet of mass 5.01 kg is suspended from the ceiling by a cord as shown. A large magnet is somewhe...

A: Given: The mass of the magnet is 5.01 kg. The magnetic force is 187.4 N.

Q: Object A has a charge of +2 µC, and object B has a charge of +6 µC. Which statement is true? 3 FAB ...

A:

Q: Same situation as in the previous two problems this time the magnet s mass is 5.28 kg and the magnet...

A:

Q: 50 W/m2 energy density of sunlight is normally incident on the surface of a solar panel. Some part o...

A:

Q: particle is oscillating, following the equation: x=4 cos 5t+ 6 sin 5t, where x is in meters and t is...

A: Given Equation of particle x = 4 Cos5t +6 sin5t 

Q: A temperature-stable resistor is made by connecting a resistor made of silicon in series with one ma...

A:

Q: A proton describes a circular orbit of radius 27 cm perpendicular to a magnetic field of modulus 1.0...

A:

Q: 0ft long has a variable load, zero at the leftmost end while 420lbf at the rightmost end. Calculate ...

A: We know that we have given the variable load on the horizontal beam and Zero at the leftmost end whi...

Q: A particle is launched from a point 100 m above the ground, with an initial speed of magnitude 48.2 ...

A:

Q: This time the magnet has mass 7.49 kg and the force pulling it to the right is 156.6 N. When the mag...

A: Given: Mass of magnet m : 7.49 kg Force applied F : 156.6 N Coefficient of kinetic friction μ=0.341 ...

Q: If the velocity is constant towards the right direction, the graph of displacement x vs time t is a ...

A:

Q: Part C For the vectors shown in the figure, determine (Eigure 1) the magnitude of 2A-3B + 20 Express...

A: We have to find the magnitude and direction of 2A-3B+2C

Q: H. DE-2 Ray is driving his car at a speed of 25 M/S when he sees a truck in front of him coming towa...

A:

Q: Given data: Initial velocity=8 m/s Final velocity=10 m/s Time=2 s Determine acceleration

A: Given data : Time=t Initial velocity=U Final velocity=V   To find : Acceleration

Q: A particle has an initial velocity of 3i + 4j and an acceleration of 0.4i + 0.3j . Its speed after 1...

A:

Q: A uniform 3.9T magnetic field points north. If an electron moves vertically downward (to- ward the g...

A: Given : Magnetic field , B= 3.9 T  Speed, v= 2.8 × 107 m/s  Charge on proton, q = 1.6 × 10-19 

Q: Suppose a car travels 108 km at a speed of 20.0 m/s, and uses 1.80 gallons of gasoline. Only 30% of ...

A: The work done by a force on moving a body by a distance is given by W = F.s, where F = the force act...

Q: 6.6. A motor boat moves at a steady speed of 4 ms acting on it is 4000 N. Calculate the power of its...

A: Given data :                   Speed of the boat  =  v                         Force  =  F       To ...

Q: An engine consists of a constant volume process at 0.8 m3 from 136 kPa to 381 kPa, an isothermal exp...

A:

Spring Potential Energy

The potential energy is the energy possessed by a body by virtue of its position or the energy held by the object due to its position relative to other objects, its force like stresses, charge, and other factors affecting the particles of the body. The potential energy is the measure of the net work done by or on the body. The spring potential energy is the potential energy stored due to the deformation of an elastic spring and this elasticity is due to the stretched spring. The elasticity is the ability of a solid-state matter to come back to its equilibrium position or original position after any kind of external force is acted on it. It is also known as Elastic potential energy. The potential energy here is caused due to the displacement of the spring from its equilibrium position to another position and this potential energy is equal to the net work done due to the stretching of the spring. It also resembles the same mechanics of the oscillation of a simple pendulum, where due to the external force, the object moves from its equilibrium position to its maximum ends and the periodic motion continues till it comes back to the equilibrium position to rest.